Which of the below is true for conventional milling: O Chips are removed behind the cutter which reduces the chance of re-cutting Chip width starts from zero and increases which causes more heat to diffuse into the workpiece and produces work hardening Creates cleaner shear plane which causes the tool to rub less and increases tool life

Which of the below is true for conventional milling: O Chips are removed behind the cutter which reduces the chance of re-cutting Chip width starts from zero and increases which causes more heat to diffuse into the workpiece and produces work hardening Creates cleaner shear plane which causes the tool to rub less and increases tool life

Precision Machining Technology (MindTap Course List)

2nd Edition

ISBN:9781285444543

Author:Peter J. Hoffman, Eric S. Hopewell, Brian Janes

Publisher:Peter J. Hoffman, Eric S. Hopewell, Brian Janes

Chapter1: Introduction To Machining

Section1.1: Introduction To Machining

Problem 9RQ: What machine tool is available with either horizontal or vertical spindle orientation and uses...

See similar textbooks

Similar questions

For face milling a 2 x 3 inch surface using 1.5 in face mill tool. What is the time required to finished a cut when the depth of cut is 0.02 inch and the feed rate 0.05 inch/rev, RPM is 60. The subject is Machine Shop Theory. Please make clear the solution and answer and understandable. Thanks
Q#2 “Milling is an intermitted cutting operation”. Explain it.
5.) Calculate the machining time required to reduce from 60mm diameter shaft to 50mm diameter, for a length of 1500mm with depth of cut 2mm for rough cut and 1mm for finish cut. Cutting speed and feed may be assumed as 30m/min and 0.5mm/rev respectively.
Calculate the machining time intervals for face milling a cutter 10 inches long, 2 inches wide, with a depth of cut of 0.1 inch for the following workpiece materials: (a) low-carbon steel ; (b) titanium alloys; (c) aluminum alloys, and (d) thermoplastics.
a. Give 3 reasons why conventional machining is essential. b. What is the difference between the primary shear zone and secondary shear zone? c. Name a device or procedure used to measure cutting temperature Please type the answers!!
Show schematically the cutting motion and feed motion in turning and milling. Compare the advantages and disadvantages of counter (opposite) milling and co-milling
Sketch and explain up milling operation
If a fairing operation is executed at a rotational speed of 40.0 rev / min, the feed is 0.015 in / rev and the depth of cut is 0.180 in, it determines: a) cutting time to complete the fairing operation; and b) the cutting speed; and c) The speed of metal removal at the beginning and end of the cut d) The power dissipated.
Briefly contrast the speed and feed differences between drilling and reaming operations.
What machine tool is available with either horizontal or vertical spindle orientation and uses rotating cutting tools to primarily produce flat surfaces?
Calculate spindle RPM and machining time for cutting a 1.5" diameter 4" long at 225 SFPM using a feed rate of 0.004".
Many of the cutters used in machining are made of either __________________ or ____________________.