Which of the following conditions is NOT necessary for diffusion to occur? a.) a difference in concentrations in the fluid between solute and solvent b.) a difference in pressure between solute and solvent c.) a difference in the materials composing the solute and solvent

Which of the following conditions is NOT necessary for diffusion to occur? a.) a difference in concentrations in the fluid between solute and solvent b.) a difference in pressure between solute and solvent c.) a difference in the materials composing the solute and solvent

Physical Chemistry

2nd Edition

ISBN:9781133958437

Author:Ball, David W. (david Warren), BAER, Tomas

Publisher:Ball, David W. (david Warren), BAER, Tomas

Chapter19: The Kinetic Theory Of Gases

Section: Chapter Questions

Problem 19.64E

See similar textbooks

Related questions

Q: The concentration of a substance is essential to determine colligative properties. This question…

A: w/w(%)=(Mass of solute/mass of solution)×100 Density of solution=(mass of solution/volume of…

Q: a. Eutexia b. The Phase Rule c. Polymorphism d. Degrees of Freedom Useful device for relating the…

A: According to Q&A guidelines of Bartleby, we are supposed to answer only the first 3 rows of…

Q: Relation between the volume of gas (2) that dissolves in a fixed volume of solvent (1) and the…

A: SOLUTION: Step 1: According to Henry’s law: “At a constant temperature, the amount of a given gas…

Q: Compounds like sodium stearate, called “surfactants” ingeneral, can form structures known as…

A: (a) The colloidal size molecules cause scattering of light. Before critical micelle concentration…

Q: IL. Identify three ways in which you can reduce the amount of time reqaired to dissolve a given…

A: The maximum amount of solute that can be dissolved in the definite amount of solvent at a fixed…

Q: Volatile liquids A and B combine to produce a solution. Because the attractive forces between A and…

A: The ideal solution follows Raoult's law whereas the non - ideal solution does not follow Raoult's…

Q: To prepare 100ml of O.2M from the stock solution (10M) we need to dilute 4ml of the stock solution…

A: Molarity is the unit of concentration of a solution, and its unit is mol/L. It is defined by the…

Q: II. Freezing point of a pure solid. Data Table. 1. mass of pure naphthaleneo nili13119 9.574g. anoli…

A: Given: Mass of pure napthalene=9.579 g Freezing point of napthalene=78.6°C Mass of unknown=1.554 g…

Q: The standardized basic solution was then used in getting the total acidity of a food sample. Ten…

A: Given: 1 g of KHP is reacting. Volume of NaOH solution used in trial 1 = 52.0 mL = 0.052 L…

Q: A solution of 7.50 6.50 torr at 23.1°

Q: Why is it important to maintain the rock salt/ice mixture at a temperature of -10oC? A. Because it…

A: It is important to maintain the rock salt / ice mixture at a temperature of -10°C. This is because…

Q: Consider a solution composed of toluene (C7H8) and benzene (C6H6) with volumes 50 mL and 125 mL,…

Q: A certain amount of benzene C&H (D= 0.985 g/mL) was dissolved in 0.500 kg CCI4 to produce a solution…

A: Given: Mass of solvent i.e. CCl4 = 0.500 Kg = 500 g. Mole % of solvent i.e. CCl4 = 37.0 % Density of…

Q: Tendency of the solute to spread throughout the solution until the composition is homogeneous

A: We have to explain, tendency of the solute to spread throughout the solution until the composition…

Q: Which of the following statements is correct? a. Solvation releases energy. b. Difference in…

Q: (c) Are the strengths of the interactions between the particles in the solute and between the…

A: The strength of the interactions between the particles in the solute and between the particles in…

Q: Please indicate true (T) or false (F) as appropriate: Justify I) The vapor pressure of a…

A: We would use the definitions of Non-volatile substance , ideal solution , depression in freezing…

Q: Multiple choice 1. What type of relationship does boiling point and vapor pressure exhibit?…

A: Colligative Property of solution.,

Q: Company ABC uses KCN as a processing aid to extract gold from ore. It's the wastewater operator's…

Q: When mixing together the solvents A. Water/vegetable oil B. Water/rubbing alcohol C. Vegetable…

Q: The volume of the solution inside a container is constant as the time approaches infinity. True or…

Q: Calculate the formality and normality of a commercial solution of H2SO4 whose purity is 97% and its…

A: 97% by weight of solution means 97 gram of H2SO4 in 100 gram of solution. Density of Solution = 1.82…

Q: Example (6): Find the molar conductivity of aque ous solutions of LiCl and MgC at infinite dilution…

A: Molar conductivity of LiCl and MgCl2 at infinite dilution

Q: The concentration of the solution at anytime t is equal to: O the ratio of the amount of salt at…

A: The amount of solute present in the unit volume of the solution is known as the concentration of the…

Q: Discuss why the following affect the rate of diffusion: molecular size, temperature, solution…

A: We have been asked the why the following affect the rate of diffusion: molecular size, temperature,…

Q: The Total dissolved solids (TDS) can be reduced by the following method Select one: a. Distillation…

Q: 10. True/False: A greater surface area decreases the amount of material dissolved. 11. Dissolving is…

A: Solution [11.] – Dissolving is a surface phenomenon since it depends on solvent molecules colliding…

Q: 30. Vapor pressure is a property of the solvent O A.physical B.chemical O c.dynamic D.kinetic 27.…

A: ∆Tb = i × m × Kb ∆Tb = boiling point elevation i = vant Hoff factor For Sucrose, i = 1 ( as…

Q: temperature of the surrounding solution increase or dec

A: Thermodynamics is branch of chemistry in which we deal with amount of heat evolved or absorbed…

Q: a) An alcohol solution was prepared by adding enough water to 35. 0 mL of the alcohol to make a…

Q: h glass material is 0.1 N HCl solution prepared? A-) beaker B-)balloon jojo C-)erlenmeyer D-)measu

A: In chemical laboratories, all the chemicals, solutions, reactants are prepared and mixed in a…

Q: (Show setup for calculation on this and lines 9–11) 9. Moles of H,O2 10. Grams of H,O, 11. Mass…

A: 9.) To calculate moles of H2O2 , we would first write a balanced chemical for the production of O2…

Q: A Na2CO3 solution is made up by dissolving 32.5 g of Na2CO3ˑ10H2O in H2O and adding H2O until the…

A: Given, Mass of Na2CO3.10H2O = 32.5 g Total volume of solution = 300 cc Density of the total solution…

Q: a 50.0 mL sample of aqueous sodium chloride was analyzed according to the experimental procedure in…

A: To solve this problem first we have to calculate the mass of NaCl solution and mass of solid NaCl…

Q: 1. It is desired to prepare calcium sulfate solution by dissolving 250 grams of calcium sulfate in…

Q: State raoult's law for a non volatile solute in single volatile solvent?

A: The vapour pressure of a solution of a non-volatile solute is equal to the vapour pressure of the…

Q: Answers should be in 4th decimal places An automobile antifreeze mixture is made by mixing equal…

A: Given data: Density of mixture = 1.070 g/mL Density of ethylene glycol = 1.114 g/mL Molecular weight…

Q: 100 mL solution was prepared by dissolving 10.00 g of CaS04 (MW= 136. 14 g/mol) in water. The ensity…

Q: A solution is made using 162.1 g of dimethyl ether (MM = 46.07 g/mol) and 90.0 g of methanol (MM =…

A: Mole fraction of any component can be obtained by dividing the moles of that component with the…

Q: Determine if a homogeneous solution forms when each pair of substances is mixed. Check all that…

A: Homogeneous solution A non reacting ploar compound in polar solvent refered as homogeneous solution…

Q: 279.28 mL of 1.22 M organic salt was mixed with 168.14 mL of Ethanol (d= 0.789 g/mL, MW…

A: Given, Volume of organic salt in mL (solute) = 279.28 mL Molarity of organic salt = 1.22 M Volume…

Q: Q1. A suspension of colloidal particles in water (temperature 25°C and viscosity 8.9x10-4 Ns m2)…

A: Given, Temperature , T = 25°C=(25+273)K=298 K Viscosity μ=8.9×10-4 Nsm2 Particle concentration ,…

Q: The standardized basic solution (0.0939 M) was then used in getting the total acidity of a food…

Q: A solution is made by mixing 55. g of acetyl bromide (CH,COBr) and 141. g of thiophene (C,H,S).…

A: Given:: Mass of CH3COBr = 55 g, MM=122.95 g mol-1 Mass of C4H4S=141 g, MM=84.14 g mol-1

Q: True or False

A: Vapour pressure =P external that temperature is called BP. If external preesure is decreae then BP…

Q: Explain why the presence of a non volatile solute in solution reduces the tendency of the solvent…

A: Nonvolatile term says that the solute itself has little tendency to evaporate. Since, some of the…

Q: An aqueous solution is 0.8402 molal in Na2SO4. It has afreezing point of 24.218°C. Determine the…

A: Given data: The concentration of the solution is 0.8624 m. It has a freezing point is -3.064 °C The…

Question

Which of the following conditions is NOT necessary for diffusion to occur?

a.) a difference in concentrations in the fluid between solute and solvent
b.) a difference in pressure between solute and solvent
c.) a difference in the materials composing the solute and solvent

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

What is the kinetic property observed in suspension? What is the optical property observed in solutions?
True/False For liquid particles, due to no change of total particle mass along the coagulation, the increase of particle size is inverse square root of the number concentration
Theoretically, the inherent viscosity for solutions (not pure solvents) should always be a. greater than 0 b. less than 0 c. greater than 1 d. between 0 and 1
Explain why the presence of a non volatile solute in solution reduces the tendency of the solvent molecule from escaping.
True or False 1.Decreasing the external atmospheric pressure Increases the boiling point. 2. The net flow in diffusion is against the concentration gradient. 3. The solubility of gases increases as the partial pressure of the gas above. the a solution increases. 4. Weak electrolytes have poor water solubility. 5. Calcium carbonate is insoluble in water.
Greetings thank you for your help...I Appreciate you 2. Discuss why the following affect the rate of diffusion: molecular size, temperature, solution density, and the distance that must be travelled.
Give example and explanation of each words: Standard Solution Supernatant liquid Abscissa Atomic mass Concentration Density Equilibrium Constant Formula mass
The heterocyclic organic compound Furan, C4H4O, is widely used as an intermediate in the fabrication of medicines and is often mixed with ethanol, C2H5OH. The table below contains density data for the furan(1)/ethanol(2) solution at 303.15℃. : Plot the excess volume in m3 mol-1 assuming that the molecular masses for furan and ethanol are 68.075 g mol-1 and 46.07 g mol-1 respectively.
a. Colloidal particles typically have a negative surface charge that attracts oppositely charged positive ions in the surrounding bulk solution. These so-called _______-ions are held at the particle surface through electrostatic and van der Waals forces of attraction strongly enough to overcome thermal agitation. b. Turbine and propeller type mechanical mixers used for rapid mixing of reagent chemicals have either ------------- flow impellers with flat or curved blades located parallel to the axis of the drive shaft, or --------------------- flow impellers with blades making an angle of less than 90o with the drive shaf
1. What is the Brownian movement? 2. What is the effect of Brownian movement to diffusion?
The pressure arises when the rate of solvent from the pure solvent is equal to the rate of solvent in the solution in a U-Tube us known as? Select one: a. Atmospheric pressure b. Differential Pressure c. vacuum pressure d. osmotic pressure
True or false? The stronger the interaction between a component and the stationary phase, the faster the component is moved by the solvent front.