Which of the following could DECREASE the amount of the recovered crystals in the purification by recrystallization experiment? Collecting the recrystallized benzoic acid by filtration using a pre-weighed filter paper. Using a long-stemmed funnel in the hot filtration step. Cooling the filtered solution rapidly. Washing the recovered crystals using hot solvent. a.

Which of the following could DECREASE the amount of the recovered crystals in the purification by recrystallization experiment? Collecting the recrystallized benzoic acid by filtration using a pre-weighed filter paper. Using a long-stemmed funnel in the hot filtration step. Cooling the filtered solution rapidly. Washing the recovered crystals using hot solvent. a.

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter80: Crystallization: Purification Of Solids

Section: Chapter Questions

Problem 4P

See similar textbooks

Similar questions

Which of the following could result in a loss in yield in a mixed solvent recrystallization? i. Use of fluted filter paper in hot filtration ii. No heated solvent in the receiving flask iii.Rapid cooling iv. Both ii and iii
1. In recrystallization, the goal is to obtain a purified material with maximum recovery? What are the effects of the operations below on purity and recovery? Explain briefly. a. In the solution step, an unnecessarily large volume of solvent is used. i. Effect on purity: ii. Effect on recovery: b. The crystals obtained are washed with cold solvent. I. Effect on purity: II. Effect on recovery: C. The crystals referred to in (b) are washed with hot solvent. I. Effect on purity: II. Effect on recovery:
Write a flow diagram Prepare a written copy of the complete separation scheme for a solution that contains Ag+, Fe3+, Cr3+, Ni2+, Zn2+, and Ba2+. Make sure that your separation scheme includes: separation of each ion into its own individual sample AND precipitation BEFORE a confirmation test is done all phases and visible colors, if applicable reagents and conditions necessary to carry out each step balanced equations, including phases, for each step
Accurately weigh out about 6g copper(ii) sulfate crystals into a weighing boat. Use the copper(ii) sulfate crystals to make up 250cm3 of standardized copper (ii) sulfate solution Pipette 25cm3 of this solution into a conical flask Add 1.5g potassium iodide and swirl thoroughly Titrate this solution with standard 0.1 moldm-3 Na2S2O3 in a burette. When the iodine color fades, add 1 cm3 starch indicator. Use your titration data below to calculate the percentage by mass of copper in the copper(ii) sulfate crystals.
1. Why is the washing of crystals on the filter paper not as effective a process of purification as crystallization?2. How do you account for the formation of crystals of different sizes in slow and rapid crystallization process?3. What properties should ideally be possessed by a recrystallization solvent?
Let's assume that 5.6 g of crude product was isolated, and 4.19 g of pure product was collected after recrystilization 8. Let's assume that the melting point of the recrystallized product was 104-108°C. What conclusions can you draw? Provide a brief discussion of these results.
for effective purification by recrystalization while avoiding performing a hot gravity filtration, what is the desired solubility of an impurity at different temperatures? Hot solvent solvent after cooling
0.56 g 1,4‐dimethoxybenzene, 0.9 mL 2‐chloro‐2‐methylpropane, 5 mL nitrobenzene and 0.52 g graphite were combined, and the mixture was refluxed for 1.5 hours. It was then cooled to room temperature and filtered. The filtered graphite was washed with 15 mL hexane. The filtrate was distilled under vacuum to remove any remaining 1,4‐dimethoxybenzene, 2‐chloro‐2‐ methylpropane and nitrobenzene (6.3 g), yielding 0.44 g 1,4‐di‐tert‐butyl‐2,5‐dimethoxybenzene (43.4% yield). What is the Atom economy, E factor, and effective mass yield?
Make a results and discussion in Laboratory Report Format of the following: 1. Separation of mixture using different techniques 1.1 Simple distillation: Water + acetone 1.2 Fractional Distillation: Methanol + ethanol 1.3 Chromatography: Separation of mixture of Red ink and blue ink 2. purification of impure samples by crystallization 2.1 Copper sulfate 2.2 Potash alum 2.3 Benzoic acid
Objective: To determine the percent NaCl (w/v) of a water sample 5.00 mL sample diluted to 50 mL solution 0.1000 M AgNO3 Volume of AgNO3 trial 1=15.30 mL trial 2=14.90 mL trial 3=15.10 ml
Which statement about liquid-liquid extraction is not correct? * A- A solvent must be available that is miscible with the solution containing the substance to be extracted. B- The solvent used for extraction must have a good ability to dissolve the desired substance. C- The denser solution forms the bottom layer in the extraction funnel. D- The extraction funnel must be vented during the extraction procedure to prevent excessive build-up of pressure inside the extraction funnel. E- All these statements are correct.
is mobile phase the eluting solvent?