Which of the following would be the correct equation for determining the number of moles of H2SO4 that are added to the flask based on [H2SO4] and volume of H2SO4 titrant (mL H2SO4)? A Moles of H2SO, = mL H2SO4 x [H2SO,] Moles of H,SO, = [H2SO4 ]x [mL H2SsO4 ] %D 1,000 mL [1000 mL]x [mL H2so4] [H2SO4 ] C Moles of H,SO, =

Which of the following would be the correct equation for determining the number of moles of H2SO4 that are added to the flask based on [H2SO4] and volume of H2SO4 titrant (mL H2SO4)? A Moles of H2SO, = mL H2SO4 x [H2SO,] Moles of H,SO, = [H2SO4 ]x [mL H2SsO4 ] %D 1,000 mL [1000 mL]x [mL H2so4] [H2SO4 ] C Moles of H,SO, =

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

A solution is prepared by mixing 20.0 mL of 0.100M Fe(NO3)3 with 20.0 mL of 0.00300M KSCN and 10.0 mL of DI water. Calculate the initial concentration of Fe^3+ in this solution? Give answer with correct amount of sig figs.
What mass of Ba(OH)2 is present in a sample if it is titrated to its equivalence point with 44.20 mL of 0.1000 N H2SO4? Note: Present complete solutions for the following problem. Express your final answers up to two (2) decimal places.
A soda ash sample was contaminated with NaOH. It was made up of 0.00069 moles of NaOH and 0.00115 moles of Na2CO3. What would be the expected volumes of Vphth and Vmo if the said sample was titrated with 0.1M HCl?
Lead(II) carbonate, PbCO3, is one of the components of thepassivating layer that forms inside lead pipes. (a) If the Kspfor PbCO3 is 7.4 x 10 - 14 what is the molarity of Pb2+ ina saturated solution of lead(II) carbonate? (b) What is theconcentration in ppb of Pb2+ ions in a saturated solution?(c) Will the solubility of PbCO3 increase or decrease as thepH is lowered? (d) The EPA threshold for acceptable levelsof lead ions in water is 15 ppb. Does a saturated solution oflead(II) carbonate produce a solution that exceeds the EPAlimit?
A 3.00 mL aliquot of 0.001 M NaSCN is diluted to 25.0 mL with 0.1 M HNO3. How many moles of SCN- are present?
PART 2: A solution is prepared by mixing 150.0 mL of 0.0010 M magnesium nitrate and 250.0 mL of 0.100 M sodium fluoride (Ksp = 7.4x10-11). Is Ksp greater than , equal to, or lower than Qsp? Will a precipitate form, Y/N? What is the fluoride ion concentration (in solution) after mixing is complete? Give your answer in exponential form and to three sig. figs. (e. g. 1.23E-3). What is the magnesium ion concentration (in solution) after mixing is complete? Give your answer in exponential form and to three sig. figs. (e. g. 1.23E-3).
4) A 25.00-mL sample of vinegar is diluted with deionized to 100.0 mL. Then a 10.00-mL aliquot (portion) of the dilute vinegar solutionis titrated with 0.1055 M NaOH solution using phenolphthalein as theindicator. (a) If 19.60 mL of the base solution is required to reach the end-point, calculate the molar concentration of acetic in dilute vinegar solution. (b) What is the molar concentration of acetic acid in the original (undiluted) vinegar? The acid-base reaction occurs as follows: HC2H3O2(aq) + NaOH(aq) --> H2O(l) + NaC2H3O2(aq)
Calculate the moles of KHP titrated in each trial = M x L = 0.5 M x 0.025 L=_____ Calculate the moles of NaOH using stoichiometry of the reaction KC8H5O4 + NaOH ® NaKC8H4O4 + H2O Mole of NaOH = mole of KHP x = ______________________ Calculate the molarity of NaOH for each trial: molarity of NaOH = . Enter your answers in the following Table 2 Table 2: molarity of NaOH solution. 1st trial 2nd trial 3rd trial 4th trial Molarity of NaOH Average Molarity
2] Vinegar can be assayed to determine its acetic acid content. Determine the %(w/v) of acetic acid in a 15.00 mL sample of vinegar that requires 22.70 mL of a 0.5500 M solution of NaOH to reach the equivalence. Solution: Final answer:____________ 3] The calcium in a 5.00-mL serum sample is precipitated as CaC2O4 with ammonium oxalate. The filtered precipitate is dissolved in acid, the solution is heated, and the oxalate is titrated with 0.00100 M KMnO4, requiring 4.94 mL. Calculate the concentration of calcium in the serum in meq/L (equivalents based on charge). Solution: Final answer:____________
What volume (V) of 0.100M (moles) KMnO4 would be required to Titrate 0.23g of K2{Cu(Cu2O4)2} * H20?
Na2CO3 served as the primary standard in a titration experiment. Find the molarity of the titrant given the following data in 3 decimal places. Show solutions Primary Standard Used: Na2CO3Formula Mass of 1º standard: 105.99 g/mol% purity of 1º standard: 95% Trial 1 2 3 1º Standard weight, g 0.1005 0.1001 0.0997 Net volume of HCl, mL 9.30 9.00 8.90 Molarity of HCl X1 X2 X3
35.0 mL of 6.7 x 10-4 M Ca(NO3)2 is mixed at 25˚C with 65.0 mL of 8.4 x 10–5 M Na2CO3.Compute the initial concentrations of [Ca2+]init and [CO32-]init after mixing.Assume volumes are additive. 3. Should a precipitate form when the solutions in prelab questions #2 above are mixed?Support your answer with a calculation