Answered: Why is the sum of the maximum voltages…

Why is the sum of the maximum voltages across each element in a series RLC circuit usually greater than the maximum applied voltage? Doesn’t that inequality violate Kirchhoff’s loop rule?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 56P: Examine the circuit shown below in part (a). Determine dl/dt at the instant after the switch is...

See similar textbooks

Related questions

Q: Use the worked example above to help you solve this problem. A coil with 21 turns of wire is wrapped…

Q: A 500-turn coil of area 0.00200 m^2 is rotated in a 2.00 T magnetic field. At what frequency, f,…

A: We know that angular frequency ω= 2πf= 2×3.14×f

Q: 2. The figure below shows three situations (all are RLC circuits). Is the driving angular frequency…

Q: Determine the current I(t) in the RL circuit below. Show all your calculations in detail. I(t) R =…

Q: Problem 1 ) All parts of this problem refer to the circular loop of wire in the coordinate system…

A: All the parts of the problem can be solved by using the concept of Faraday and lenz law effectively…

Q: Fill in the blank with correct answers: Vo The voltage-current phase diagram shown in the picture is…

A: Since in the given graph, the two curves of voltages is only for EMF and inductor. Hence the AC…

Q: Solve the following problems: 1. The AM radio band extends from 5.4 x 10° Hzto 1.7 x 10°Hz. What are…

Q: Two widely separated inductors Li and L2 are connected either in series or in parallel. What is the…

Q: 1. What is Resonance? 2. At resonance, is XC a maximum or minimum? Explain. 3. Why is it that Z =…

Q: In the circuit below, the switch was turned to the 2 position at t=0 after being in the 1 position…

A: Dear student The Capacitor is a device which when given potential difference, doesn't get charged…

Q: The current shown in part (a) below is increasing, whereas that shown in part (b) is decreasing. In…

A: a) The current is increasing, that means the current is flowing from lower potential to higher…

Q: The magnet is pushed away from the solenoid. What will be the magnetic field direction inside the…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: A single turn coil of radius 5.00 cm is held in a vertical plane and a magnet is rapidly moved…

A: A single turn coil , n=1 Radius of coil = r= 5 cm = 0.05 m B1= 0.040 T B2= 0.025 T t= 0.2 sec…

Q: Find the total Laplace impedance of the circuit below. Express your answers in integers. 3 s 2 Fill…

A: According to question we need to find total Laplace impedance of circuit.

Q: Why does a capacitor act as a short circuit at high frequencies? Plus, why does a capacitor act as…

A: Behavior of capacitor at high and low frequency:

Q: The 3 resistors A, B and C are connected in series to a 120-volt supply. If resistor A is 60 ohms,…

Q: The coil in the picture below is rotating with a constant angular speed of 263 rad/s in a uniform…

Q: A square flat coil that has N turns, encloses an area A, and carries a current i has its central…

Q: A single turn coil of radius 7.00 cm is held in a vertical plane and a magnet is rapidly moved…

Q: What does a radio wave do to the charges in the receiving antenna to provide a signal for your car…

A: Radio waves generated from the radio towers consist of two types of electromagnetic fields: magnetic…

Q: Ik 2k W- 3MA O O SMA 5k 幸

Q: Use the worked example above to help you solve this problem. A coil with 21 turns of wire is wrapped…

Q: . A magnetic field directed out of the page changes with time according to ? = (0.02? 2 + 0.6?)?…

A: Given that, B= (0.02t² + 0.6t) T Radius of loop(r)= 2.5 cm = 0.025 m Resistance (R)= 5 ohm We know…

Q: How can you convert the wavelength to wave number and absorbance to transmittance?

Q: 1. Recall circuit IX from the tutorial, which is reproduced at right. In the tutorial, batteries A…

Q: 3) Why is the radio receiver circuit, commonly called a resonant circuit?

A: .

Q: One member of your group suggests that the RL circuit in figure 1 be modified so that a third switch…

A: In this question we are given with two circuits and we have to answer some questions related to it.

Q: Will a transformer operate if a battery is used for the input voltage across the primary? Explain

A: Working of transformer in DC circuit:

Q: he conductors carry currents i1 and i2 as indicated. If i1 is decreasing and i2 is constant, then…

A: Suppose a rectangular loop of wire is placed midway between two long straight parallel conductors as…

Q: Now refer to part ii of this question and think about the current direction produced in the coil,…

A: Electromagnetic induction: The production of an electromotive force across a conductor in a changing…

Q: Can you help with 5a and subquestion 5b 5a. An American traveler in Australia carries a transformer…

A: Input voltage, Vi=230V Output voltage, V0=115V

Q: After the switch is closed in the LC circuit shown in Figure , the charge on the capacitor is…

A: The current is maximum in the circuit when the capacitor is fully discharged.

Q: Suppose L = 10 henrys, R = 10 ohms, C = 1/500 farads, E = 100 volts, q(0) = 10 coulombs, and q′(0) =…

A: The general ode for an RLC circuit is: Substitute the known values and solve.

Q: In a hydroelectric dam, how is energy produced that is then transferred out by electrical…

Question

I need a proper solution for the following ( understandable writing and well explained )

Why is the sum of the maximum voltages across each element in a series RLC circuit usually greater than the maximum applied voltage? Doesn’t that inequality violate Kirchhoff’s loop rule?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

I need proper answer for the following (understandable writing and well explained) Does the phase angle in an RLC series circuit depend on frequency? PLus, what is the phase angle for the circuit when the inductive reactance equals the capacitive reactance
Examine the circuit shown below in part (a). Determine dl/dt at the instant after the switch is thrown in the circuit of (a), thereby producing the circuit of (b). Show that if I were to continue to increase at this initial rate, It would reach its maximum /R in one time constant.
I need a proper solution for this question ( well explained and understandable writing) After the switch is closed in the LC circuit shown in Figure , the charge on the capacitor is sometimes zero, but at such instants the current in the circuit is not zero. How is this behavior possible?
Imagine a conductor on rails that completes the circuit below. There is also a magnetic field with strength 3 T pointing into the screen. If the resistance of the resistor is 1000 Ohms, and the bar is 2 meters long and sliding to the right with a constant speed of 5 meters/second, what is the power dissipated by the resistor?
The current shown in part (a) below is increasing, whereas that shown in part (b) is decreasing. In each case, determine which end of the inductor is at the higher potential.
I don't understand how to get from the individual loop equations to the highlighted part. Where did the i2s go?
Suppose you require a peak output voltage of 15.0 V and have available an AC source whose pealvoltage is 110 V. You have access to an iron core transformer on which there are 200 turns ofconducting wire on the side that you have decided to use as the secondary side of the transformer.How many turns of wire would you need to wind on the primary side to create a transformer thawould satisfy your requirement? Show your work.
Consider the circuit shown in the figure.(a) When the switch is in position a, for what value of ? will the circuit have a timeconstant of 15.0 ms?(b) After a very long time, the switch is thrown to position b. What is the current inthe inductor at the instant the switch is thrown to position b?
Use the picture below to answer. The metal bar has a length of 2 meters, the magnetic field has a strength of 3.5 T, the bar is moving 4 m/s, and the resistance is 10 Ω. a) Calculate the voltage generated when the bar is moving at 4 m/s. b) Using the right hand rule and Faraday’s/Lenz’s Law determine the direction of the current in the circuit. c) Using the voltage from part a), calculate the value of the current flowing through the circuit. d) Calculate the force that the metal bar feels due to the current flowing through it in part c) and the magnetic field. Also right down the direc- tion of this force.
Thank you. To clear up the rest of my confusion, can you please show me how to calculate capicitors in a series and in parallel and also how to calculate resistors in a series and in parallel. I just need to be able to see all of the calculations and compare
how do the minimum resistance, maximum current and parallel connection relates to each other, including their formula? and why does the parallel connection have a lower resistance?
Please fill out the template with the work for this homework problem. Note that you need to have a picture, a list of knowns and unknowns, the general equation/s you will use, and the math steps to solve for the unknown, only plug in the numbers after you have solved for the unknown, and the answer with units included. Suppose a 32 mH inductor has a reactance of 95 Ω. What would the frequency be in Hz?