A subway train made of two cars is shown. It travels at a speed of 50kph. When the brakes are applied, a braking force of 10,000N is applied to each car. Determine the force in the coupling between the cars. 80 kN 10,000 N 1000 N (tension) 1500 N (compression) 2000 N (compression) 20,000 N (tension) 2000 N (tension) 1500 N (tension) 2500 N (compression) 10,000 N (compression) 120 kN 10,000 N v = 50 km/h

A subway train made of two cars is shown. It travels at a speed of 50kph. When the brakes are applied, a braking force of 10,000N is applied to each car. Determine the force in the coupling between the cars. 80 kN 10,000 N 1000 N (tension) 1500 N (compression) 2000 N (compression) 20,000 N (tension) 2000 N (tension) 1500 N (tension) 2500 N (compression) 10,000 N (compression) 120 kN 10,000 N v = 50 km/h

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Note: DRAW COMPLETE FREE BODY DIAGRAM WITH COMPUTED VALUES. Under the influence of a 700 N-m couple, the flywheel A revolves clockwise. A band break will be employed to bring A's rotation to a halt. The belt and the flywheel have a coefficient of friction of 0.40. a.) What is the minimal force required to stop the flywheel at the end of rod B? b.) What is the minimum braking force P if the 700 N-m couple acts counterclockwise on A?
1-Moment of inertia of the pulley (kg.m2) ? 2-tension in rope of m1 (N) ? 3-tension in rope of m2 (N) ? 4-angular acceleration of the pulley (rad/s2) ? 5-acceleration of block m1(m/s2) ? 6-acceleration of block m2 (m/s2) ?
The systems shown is initially at rest. Neglecting axle friction and the masses of the pulleys, determine the acceleration of the left block in m/s2.
Please Quickk. In a high rise building, the elevator rises 366 m with an operating speed of 5 meters per second and reaches full speed in 10.68 m. The loaded elevator weighs 2000 kg. The acceleration of the elevator in m/s2 is 1.17. Determine the bending stress of wire rope with drum diameter of 7.8 inches and wire diameter of 0.0987 in. Answer 380 ksi
Two elevators operating in parallel shafts, approach each other from positions which are 120 m apart. The upper car has a downward acceleration of 0.50 m/s2, and the lower car is being accelerated upward 1.0 m/s2. When and where will they pass each other if the lower car starts 1 second after the other?
A block with mass m=(24+12)kg is pulled by a horizontal force P applied at point B in Fig.3. The coefficient of kinetic friction between the surfaces is we = (5A+5)/(25+94). When the acceleration of the block is a=(1+9)/4 m/s?, determine the cable forces Tax and Top- 0=(A+8) A=1
If blocks A and B has the total mass of 250 grams with a ratio (A:B) of 2:3, what will be the smallest force F needed to cause motion of block B if P=300 N? Let the static friction of the surfaces between A & B and B & C will be 0.25 and the surfaces between the ropes and pegs D & E be 0.35.
Blocks B has a mass of 20 kg and block C has a mass of 15 kg. The coefficient of static friction at the contacting surfaces is 0.2. Block A is suspended by a rope that passes over a fixed cylinder and is attached to block B. The coefficient of static friction between the rope and the cylinder is 0.25. What is the largest mass block A can have without causing block B to slip the left?
The ladder and the person weigh 30 lb and 180 lb, respectively. The center ofmass of the 12-ft ladder is at its midpoint. The coefficient of static frictionbetween the ladder and the floor is 0.5 and the coefficient of friction betweenthe ladder and the wall is 0.3. What is the largest value of the angle ALPHA for which the person could climb to the top of the ladder without it slipping?
The belt-driven pulley and attached disk are rotating with increasing angular velocity. At a certain 2instant the speed v of the belt is 1.5 m/s, and the total acceleration of point A is 75 m/s . For this instant determine (a) the angular acceleration of the pulley and disk, (b) the total acceleration of point B, and (c) the acceleration of point C on the belt.
Determine the angular acceleration of the 23-kg diving board the instant the man jumps off. Assume that the board is uniform and rigid, and that at the instant he jumps off the spring is compressed a maximum amount of 210 mm , ω=0, and the board is horizontal. Take k = 6.0 kN/m and Determine the vertical component of reaction at the pin AA the instant the man jumps off.
Q2/ You want to move a 400-N crate across a level floor by pulling upward on the rope at an angle of 30° above the horizontal. How hard must you pull to keep it moving with an acceleration of a = 0.5 m/s² ? Assume that µ = 0.30.