Words: Accelerating, Float, Gear, Noise, Tooth, Vehicle Crown wheel and pinion noise originates from poor ________________ contact and may be noticed on drive, overdrive or ________________. It can be more pronounced on one of these than on the others. Drive noise is most pronounced when ________________, as the gear teeth are under load. The bearings are also under load so that any lack of preload will allow the ________________ teeth to change their area of contact. Noise on overdrive occurs as the ________________ decelerates from medium speeds, while float ________________ occurs under light cruising conditions.

Words: Accelerating, Float, Gear, Noise, Tooth, Vehicle Crown wheel and pinion noise originates from poor contact and may be noticed on drive, overdrive or . It can be more pronounced on one of these than on the others. Drive noise is most pronounced when , as the gear teeth are under load. The bearings are also under load so that any lack of preload will allow the teeth to change their area of contact. Noise on overdrive occurs as the decelerates from medium speeds, while float occurs under light cruising conditions.

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter38: Manual Transmissions And Transaxles

Section: Chapter Questions

Problem 10ASRQ: While discussing shift mechanisms: Technician A says that the interlock notches hold the...

See similar textbooks

Similar questions

What is the importance of studying how to perform assemble/disassemble manual transmission?
The typical RWD drive shaft rotates how many times faster than wheels
Why are the wires leading to some wheel-speed sen sors twisted?
32. Technician A says hypoid gearset are only used in RWD vehicle drivetrains. Technician B says hypoid gearset multiply torque. Which technician is correct? A- Technician A B- Technician B C- Both A and B D- Neither A nor B.
The four common configurations used as the finaldrives on FWD vehicles are the __ gear, __ gear,__ gear, and __
Explain the role of shift rails and shift forks in theoperation of a transmission or transaxle.
When discussing shift problems,Technician A says that worn or broken engine and transaxle mounts can cause a transaxle to have shifting problems.Technician B says that poor shift boot alignment can cause a transaxle to jump out of gear?
when discussing shift problems, technician A says that worn or broken engine and transaxle mounts can cause a transaxle to have shifting problems. technician b says that poor shift boot alignment can cause a transaxle to jump out of gear
A clicking noise during transmission/transaxle operationmay be an indication of __ .a. worn mainshaft (input shaft) bearingsb. faulty synchronizer operationc. failed oil sealsd. worn, broken, or chipped gear teeth
what pushes the baulk ring onto the come on the gear when the sleeve starts to move on the hub? how does the baulk ring block the sleeve from engaing with the dog teeth on the gear before synchronization occurs? when would a noisy input shaft bearing be more noticeable? what is the difference between a fulltime and part-time four wheel (4WD) system?
The four common configurations used as the final drives on FWD vehicles are the_____ gear,_____ gear,_______gear, and_____.
During a test drive, a noise that appears to be transmission related disappears when the driver brings the vehicle to a stop and disengages the clutch with the engine at idle. Technician A says that the noise may be caused by an internal transmission problem. Technician B says that the problem may be something interfering with the flywheel or pressure plate. Who is correct? a. Technician A only b. Technician B only c. Both A and B d. Neither A nor B