wR-27/Wb. The power (P) supplied to an electric circuit is given by P = 2 dt. If%3Di = 63 * I sin(wt), I is the current, w is the angular frequency and R is theresistance, evaluate P.

P=ωR2π∫02πωi2dtGiven that,i=63×Isinωt

Answered: WR b. The power (P) supplied to an…

WR b. The power (P) supplied to an electric circuit is given by P i? dt. If i = 63 * I sin(wt), I is the current, w is the angular frequency and R is the resistance, evaluate P.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 65P: In an oscillating LC circuit the maximum charge on the capacitor is 2.0 × 10-6 C and the maximum...

See similar textbooks

Related questions

Q: istance is R, the inductance is L, and the impressed voltage is E(t). (Use i for

Q: A sinusoidal voltage Av = 37.5 sin(100t), where Av is in volts and t is in seconds, is applied to a…

A: According to guidelines we need to solve only first three sub-part kindly repost other parts in the…

Q: For a classroom demonstration, a professor built an RL circuit similar to the one shown in the…

A: Given: V=6.00 vL=4.80 mH =4.80*10-3 HR=2.60 ohm

Q: The switch in a series RL circuit with a re- sistance of 6.1 N , inductance of 3.1 H, and voltage of…

A: Given value--- resistance = 6.1 ohm. Inductance = 3.1 H. Voltage = 35.3 V. We have to find---…

Q: A series RL circuit with R = 52 Q, and L= 8 H has a constant voltage E = 132 V applied at t = 0 by…

Q: A 25-µF capacitor is connected to an emf given byv(t) = (160 V) sin (120πt) . (a) What is the…

A: (a) The frequency is given by, f=60 Hz The reactance of the capacitor is, XC=12πfCXC=12π60 Hz25×10-6…

Q: L ll R R L + V L ell

A: Please see the answer below

Q: Find the steady-state current q (t) on the capacitor and the current i (t) in the given LRC-series…

A: The equation for the given LRC circuit is,…

Q: The current in the circuit shown in the fiqure below equals 71.0% of the peak current at t = 6.50…

Q: Consider the circuit in the figure below, taking E = 6.00 V, L = 6.20 mH, and R 7.40 N. S + R (a)…

Q: a) What is the impedance (in Ω) of the circuit? (b) What is the maximum current (in A)? (c)Determine…

A: a) The circuit’s impedance can be determined as, Here, R, L, C, and ω represent the resistor’s…

Q: 10 Ω d 1Ω a o 6Ω Rab 3Ω 4Ω 5Ω 12Ω bo b ww ww ww

Q: The I vs t graph shown below is for an LR circuit without a battery. I (A) 12 16 14 10.5 7. 3.5 8 20…

Q: A circuit conducting loop lies in the :xy-plane as shown in Figure .The loop has a radius of 0.2m…

A: The flux through the loop is, ε=-dφdt=-ddtBA=-πr2ddtB=-πr2ddt40sin104t=-40×104πr2cos104t

Q: What is the energy density at the center of a circular loop of wire carrying a 26.0 A current if the…

Q: А. 45.2 Q The current in the circuit is given by i(t) = I cos[(9580 rad/s){], where I is the В. 126…

A: Given C = 0.625 × 10-6 F L = 75.8mH = 75.8 ×10-3 H R = 335 Ohm

Q: An inductor has a current I(t) = (0.480 A) cos[(260 s1)t] flowing through it. If the maximum emf %3D…

A: NOTE: As per guidelines, I can solve first question only. If you need help with other questions,…

Q: The current in an RL circuit increases to 95% of its final value2.24 s after the switch is closed.…

A: Given data The inductance is L=0.275 H The time is t=2.24 s The final current is If=0.95Io Here Io…

Q: the phase between the current and EMF converge to as f>> fo, where fo is the resonant frequency?

Q: A series RLC circuit has resistance R = 50.0 Ω and inductanceL = 0.500 H. (a) Find the circuit’s…

A: Part A:

Q: 3) E, = E +E Solve for Ex then find the voltage across the reactance when ET = 115V and ER = 92.5V.

A: Given data- Equation ET=ER2+EX2 We solve it for Ex value, when ET=115V and ER=92.5V

Q: How much time does it take for the current in an RL circuit withR = 130 Ω and L = 68 mH to reach…

A: Given Data: The resistance of a resistor is, R=130 Ω The inductance of an inductor is, L=68 mH The…

Q: A fully-charged capacitor with C = 1137F is connected in series with a resistor (w/ R = 867N) and an…

Q: The current i in electric circuit containing resistance R, and inductance L in series with a…

A: f(t) is given by the negative of the product of the inverse of the time constant and the time…

Q: What is the inductance of a series RL circuit in which R = 1.0 KΩ if the current increases to…

A: Given : R = 1 kΩ = 1000 Ω I = Io/3 t = 30 μs = 30 x 10-6 s

Q: The charge q on the capacitor in a simple RLC circuit is govorned by the oquation Lq" (t) + Rq'(1) +…

Q: An ac generator with emf em sin vdt, where m e=25.0 V and vd 377 rad/s, is connected to a 4.15 mF…

Q: A series RL circuit with R = 23Q has a constant voltage E =185 V applied at t 0 by the closing of a…

A: Express the relation for the current in a series RL circuit at any time t if the switch is closed at…

Q: A sinusoidal voltage Δv = 35.0 sin(100t), where Δv is in volts and t is in seconds, is applied to a…

Q: At time t = 0 a current of 2 amperes flows in an RLC circuit with resistance R = 40 ohms, inductance…

Q: (d) Determine the numerical value for o (in rad) in the equation i = Imax sin(@t – p). rad (e) What…

Q: time intérval, and zero potential difference is measured across the capacitor. After the switch is…

Q: series RL circuit with R = 10 Q and L= 3 H has a constant voltage E applied at t = 0 by the closing…

A: In LR Circuit current can be given as I = V/R ( 1- e-Rt/L )

Q: A sinusoidal voltage Δv = (80.0 V) sin (150t) is applied to aseries RLC circuit with L = 80.0 mH, C…

A: Part A:

Q: 4) XL = 2nfL Solve for L then find the inductance (L - Unit of measure is h(henry's)) when the…

Q: How many time constants T does it take for the potential difference across the resistor in an LR…

A: As given in figure when switch is moved to the upper position removing VO from the circuit then when…

Q: An electrical engineer designed an RL circuit similar to the one shown in the figure, with E = 6.00…

Q: Let I, r, c and v represent inductance, resistance, capacitance and voltage, 1. respectively. The…

Q: The current of a coil of inductance L = 0.1 H varies with time according to I = 4 t2 - 6 t, where I…

Q: The charge q on a capacitor in a simple a-c circuit varies with time according to the equation q = 3…

Q: A resistor and capacitor are connected in series across an ac generator. The voltage given by V(t) =…

A: Given:- V = V0cosωt V0 = 120 V ω = 120 π rad/sec R = 600 ΩC = 4.5 μF Find:- a) The magnitude of…

Q: A sinusoidal voltage Δv = 35.0 sin(100t), where Δv is in volts and t is in seconds, is applied to a…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: b) Find the total inductance (LAB) for the given circuit. 60 H 15 H ell ell ll 60 H 30 H 25 H 20 H В

A: Total inductance will be 24.16H.

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

wR
-27/W
b. The power (P) supplied to an electric circuit is given by P = 2 dt. If
%3D
i = 63 * I sin(wt), I is the current, w is the angular frequency and R is the
resistance, evaluate P.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

In an oscillating LC circuit the maximum charge on the capacitor is 2.0 × 10-6 C and the maximum current through the inductor is 8.0 mA. (a) What is the period of the oscillations? (b) How much time elapses between an instant when the capacitor is uncharged and the next instant when it is fully charged?
A parallel-plate capacitor has a plate area of A = 0.250 m2 and a separation of 0.0100 m. What must be must be the angular frequency ω for a voltageV(t) = V0 sin ωt with V0 = 100 V to produce a maximum displacement induced current of 1.00 A between the plates?
At what velocity must a conductor 75 mm long cut a magnetic field of flux density 0.6T if an emf of 9V is to be induced in it? Assume the conductor, the field and direction of motion are mutually perpendicular.
A square loop with 5 cm sides is perpendicular to a uniform field 150 mT in intensity. If a third of this flux remains every 0.010 s, what is the average emf induced?
The sum of the electrical and magnetic energies in an L-C circuit is 0.800 J. At a certain instant the energy is exactly half electrical and half magnetic, the capacitor charge is 5.30 mC, and the current is 8.00 A. Find (a) the capacitance, (b) the inductance, and (c) the angular frequency of oscillation.
A smooth plane wave at a frequency of 3 GHz and y-polarized, dielectric constant 2.5 and lossin a magnetic medium with a tangent of 0.05, it spreads in the + x direction,a) Determine the distance at which the amplitude of the propagating wave will be halved.b) Find the impedance, wavelength and phase velocity of the wave in the medium.c) E = ay50Sin at x = 0 (6pi10 ^ 9t + pi / 3) (V / m) assuming H is instantaneous for each t and xWrite your statement.
If the propagation losses (PEL) for a link that operates at a frequency of 4 GHz are 120dB, when using a frequency of 8 GHz the value of the new propagation losses will be: Select one: A. 126dB b. 140dB c. 130dB
A sinusoidal voltage Δv = 45.0 sin(100t), where Δv is in volts and t is in seconds, is applied to a series RLC circuit with L = 170 mH, C = 99.0 µF, and R = 60.0 Ω. e) What If? For what value of the inductance (in H) in the circuit would the current lag the voltage by the same angle ? as that found in part (d)?
The indutor in a radio receiver carries a current of amplitude 200mA when a voltage of amplitude 2.40V is across it at a frequency of 1400kHz. Calculate the value of the inductance.
If electric and magnetic field strengths vary sinusoidally in time, being zero at t=0, then E=E0 sin 2πft and B=B0 Sin 2πft . Let f = 1.00 GHz here How much time is needed for them to complete one cycle?
If a circular loop of wire of radius 17.0 cm is located in a region where the spatially uniform magnetic field perpendicular to the plane of the loop is changing at a rate of +1.7 ✕ 10−3 T/s, find the value of the induced EMF in this loop due to this changing magnetic field.
Magnetic flux density is given by the units of T (Tesla). 1T = 1 Nm-1A-1. How to obtain it in gs-2A-1?