Write an 8085 assembly language program for the interfacing of 8255., where Port A and Port B are holding values, take those numbers from Port A and Port B, add them, and send the result at Port C. Note: Port A address is 00, Port B address is 01, Port C address is 02 and Control Register address is 03.

Write an 8085 assembly language program for the interfacing of 8255., where Port A and Port B are holding values, take those numbers from Port A and Port B, add them, and send the result at Port C. Note: Port A address is 00, Port B address is 01, Port C address is 02 and Control Register address is 03.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

ChapterS: Safety, Basic Electricity And Ohm's Law

Section: Chapter Questions

Problem 8RQ: What is an MSDS?

See similar textbooks

Similar questions

How many 8 bits data blocks can be transmitted per second over 4800 bits/second serial Communication link using a parity synchronous mode of transmission with 1 start bit, 2 stop bits, 1 parity bit?
Using a ROM, implement a 1-digit binary to 7-segment display decoder. In vhdl programming language.
Q3) A bit word 1010 is transmitted. Construct the even parity 7-bit hamming code for this data? If at receiver end data is received as 1000010, then check and correct the code using even parity scheme. Assume the direction of generation and checking the code from right to left?
Briefly explain why Integrating type ADC’s are called as Indirect ADC’s? Name two Indirect ADC’s?
Observe the encoded binary signal? What line encoding format was used?
Consider two microprocessors having 8-bit and 16-bit wide external data buses, respectfully. The two processors are identical otherwise and their bus cycles are the same speed. Suppose all instructions and operands are two Bytes. By what factor do the maximum data transfer rates vary? Suppose all instructions and operands are one Byte. By what factor do the maximum data transfer rates vary? Discuss your answers.
Draw a bus organization consisting of 3 bits and 5 registers.
Binary to Octal Decoder using 7-Segment Display
Explain Difference between Circuit Switching, and Packet Switching. And also what are the advantages of Circuit Switching and Packet Switching?
In PLD, any of this process is called Programming?? O a. Blowing fuse O b. Read and write data o. None of the choices are correct, Dr. Read data
Convert each SOP expression to standard SOP form.?