Answered: y T T F = 100N An object is subjected…

y T T F = 100N An object is subjected to three forces as shown in the figure. Assume 0 = 25.2 °, what is Tif the object is in static equilibrium? Enter your answer with three significant figures.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 75CP: A horizontal force F is applied to a uniform sphere in direction exact toward the center of the...

See similar textbooks

Related questions

Q: Three forces F, = 20 N, F2 = 10 N and F, = 5.0 N act on the structure shown in figure below. A…

Q: determines the consequence of the linear load acting on the beam

Q: In the figure below, the horizontal boom is uniform and has the same weight as the hanging weight at…

Q: A cable exerts a force F on the bracket of the structural member to which is attached as shown. If…

A: Inclined angle, θ=15° Magnitude of x component=900 N

Q: The cantilevered beam is supported at the fixed support A as shown in Figure Q3.1. 6 kN 130 1 30°…

Q: A 8-m uniform beam of weight 120 N is supported by two ropes at the ends. If a 500-N person sits at…

Q: A cantilever beam is subjected to an inclined force (P) as shown in Figure 1, the equilibrium normal…

Q: One end of a uniform 3.80-m-long rod of weight Fg is supported by a cable at an angle of ? = 37°…

Q: . The figure represents the concurrent force system acting at a joint of a bridge truss. Determine…

A: For equilibrium of system net force acting on the system must be zero and horizontal as well as…

Q: There are four forces acting on a pole, A = 10i N, B = 20j N, C = -30j N, D = -40i N. What should be…

Q: The uniform beam below weighs 572N. If the rope can support 915N, what is the maximum value of w?…

Q: F FB A CG B A mg = Assume FA is down and the 20 kg board is 5 meters long. The board is in static…

A: Dear student When objects are in static equilibrium, the net force as well as net torque on it is…

Q: A horizontal 4.0 m long 5.0 N uniform bar at one end is attached to a wall by a frictionless hinge;…

Q: (a) What is the mechanical advantage of a nail puller--similar to the one shown in Figure…

A: Given data: The input force of the lever arm Li= 45.0 cm=0.45 m The output force of the lever arm…

Q: The beam as shown, has negligible weight. If the system hangs in equilibrium when Fw = 500.0N, what…

A: Given information: The Force (FW1) = 500.0 N let us re draw the diagram as shown below:

Q: 9. A uniform 400 N boom is supported as shown in the figure below. Fixl the tension in the tie rope…

A: Given : Boom weight W=400 N

Q: A uniform beam of length L = 7.25 m and weight 4.65 x 102 N is carried by two workers, Sam and Joe,…

A: The uniform length of the beam, The weight of the beam,

Q: The system in the figure is at equilibrium and m = 13kg. What is the tension in cord 1(T¡) assum ing…

A: mass (m) = 13 kg θ = 53o

Q: 3. A uniform plank ABC of weight 30 N and 2 m long is supported at one end A and at a point B 1.4 m…

A: Given that the weight of the plank is F = 30 N 30(1.4-1) = W(0.6)(30)(0.4) = 0.6WW = 120.6W = 20 N

Q: What would be the maximum weight W of the block, shown in the following figure, so that the tension…

Q: Write the two equations of equilibrium, Fx = 0and Fy 0. 600N 60 (a) 200 N 105 60 F (b)

Q: A large advertisement board (W) is held in position by cable F1, with a breaking strength of 1500 N…

A: Given : breaking strength of the F1 is, 1500 N breaking strength of the F2 is, 750 N Determine :…

Q: What condition or conditions are necessary for static equilibrium? 1=0 O Fnet=0 and Tnet=0 Fnet=0…

A: There are two condition if any object in static equilibrium position. The net force along any…

Q: 7. Three masses are hanging vertically as shown in the drawing on the right. Assume the pulleys are…

Q: A 12m long post is bolted to the wall on its left end. It's right end is held horizontal by a wire…

A: Draw the schematic diagram of the arrangement.

Q: A person is standing on a section of uniform scaffolding as shown has a ms = 22.0 kg mass and is…

A: A person is standing on a section of uniform scaffolding as shown in the figure. The section of…

Q: A window washer is standing on a scaffold supported by a vertical rope at each end. The scaffold…

Q: What is the value of the force F (N) required balance the system in the figure? M=13 kg and F makes…

Q: A uniform plank of length L=2.7m and weight W =735N is supported by three ropes as indicated in the…

Q: A sandwich board advertising sign is constructed as shown in figure 5.39. It's mass is 6.90 KG. (a)…

Q: What are tbe conditions for an object to be in static equilibrium?

Q: CAN THE SYSTEM AS SHOWN IN THE FIGURE BE IN STATIC EQUILIBRIUM IN THE POSITION SHOWN? THE UNIFORM…

A: A system in static equilibrium is defined as the one, in which there is no acceleration in any…

Q: An object is subjected to three forces as shown in the figure. Assume F1 = 70.0 N and F2 = 95.0…

A: When the number of forces are in the equilibrium, then the net force is zero or the vector sum of…

Q: Which of the pictured rigid bodies cannot be in static equilibrium? A В C D

A: In rigid body A, there is a couple acting on it, which gives rise to a rotational motion to the…

Q: Figure for Question # 18. X Y 18. A uniform plank is supported by two equal 120-N forces at X and Y,…

Q: against the wall, where it is held by friction as shown in the figure below. The coefficient of…

Q: |Three forces F, = 20 N, F, = 10 N and F, = 5.0 N act on the structure shown in figure below. A…

A: Option c) is correct.

Q: Cable AB passes over the small ideal pulley C without a change in its tension. What length of cable…

Q: y T F, F, An object is subjected to three forces as shown in the figure. Assume F1 = 80.0 N and F2 =…

A: Given The force F1 is F1=80 N. The force F2 is F2=95 N. From the given diagram, The tension in…

Q: The diagram shows a sign that wighs 50 N hanging from a uniform horizontal pole. The pole weighs 30…

A: The net torque about the axis is,

Q: A uniform steel bar of length 10 m is supported at point A and B using two cables as shown in the…

Q: On the block in the figure of mass m = 2kg acts a force F = 40N perpendicular to the wall. What…

A: Mass of block (m) = 2 kg Applied force (F) = 40 N acceleration due to gravity = 10 m/s2

Q: under curve 10. Which one of the following objects is in static equilibrium? A. В. С. D. а) А b) В C…

A: Required : Which object is in equilibrium.

Q: A carpenter carries a 6kg uniform board as shown below? (a) What downward force does he apply with…

A: Given Mass of board ,M = 6 kg Acceleration due to gravity ,g = 9.8 m/s2

Question

y
T
T
х
F = 100N
An object is subjected to three forces as shown in the figure. Assume 0 = 25.2 °,
what is T if the object is in static equilibrium? Enter your answer with three
significant figures.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

If an odd number of forces act on an object, the object cannot be in equilibrium.
What force must be applied at point P to keep the structure shown in equilibrium? The weight of the structure is negligible.
In order to get his car out of the mud, a man ties one end of a rope to the front bumper and the other end to a tee 15 m away as shown below. He then pulls on the center of the rope with a force of 400 N, which causes its center to be displaced 0.30 m, as shown. What is the force of the rope on the car?
A uniform horizontal strut weighs 400.0 N. One end of the strut is attached to a hinged support the wall and the other end of the strut is attached to a sign that weighs 200.0 N The strut is also supported by a cable attached between the end of the strut and the wall. Assuming that the entire weight of the sign is attached at the very end of the s find the tension in the cable and the force at the hinge of the strut.
Explain the need for tall towers on a suspension bridge to ensure stable equilibrium.
A horizontal force F is applied to a uniform sphere in direction exact toward the center of the sphere, as shown below. Find the magnitude of this forcee so that the sphere remains in static equilibrium. What is the frictional force of the incline on the sphere?
The forearm shown below is positioned at an angle with respect to the upper arm , and a 5.0- kg mass is held in the hand. The total mass of the forearm and hand is 3.0 kg, and their center of mass is 15.0 cm from the elbow. (a) What is the magnitude of the force that the biceps muscle exerts on the forearm for =60 ? (b) What is the magnitude of the force on the elbow joint for the same angle? (c) How do these forces depend on the angle ?
Check Your Understanding A 400.0-N sign hangs from the end of a uniform strut. The strut is 4.0 m long and weighs 600.0 N. The strut is supported by a hinge at the wall and by a cable whose other end is tied to the wall at a point 3.0 m above the left end of the strut. Find the tension in the supporting cable and the force of the hinge on the strut.
Check Your Understanding For the situation in described in Example 12.5, determine the values of the coefficient s of static friction for which the ladder starts slipping, given that is the angle that the ladder makes with the floor.
In order to lift a shovelful of dirt, a gardener pushes downward on the end of the shovel and pulls upward at distance l2 from the end, as shown below. The weight of the shovel is mg and acts at the point os application of F2 . Calculate the magnitudes of the forces F1 and F2 as functions of l1 , l2 , mg, and the weight W of the load. Why do your answers not depend on the angle that shovel makes with the horizontal?
Suppose a 900-kg car is on the bridge in Figure 9.34 with its center of mass halfway between the hinges and the cable attachments. (The bridge is supported by the cables and hinges only.) (a) Find the force in the cables. (b) Find the direction and magnitude of the force exerted by the hinges on the bridge.
The uniform seesaw shown below is balanced on a fulcrum located 3.0 m from the left end. The smaller boy on the right has a mass of mass of 40 kg and the bigger boy on the left has a mass 80 kg. What is the mass of the board?