You found two bottles in the laboratory labeled X and Y. The instructor said that these bottles contain strontium chloride and sodium chloride. You were tasked to identify bottles X and Y and what salt is contained in each bottle so that it can be properly labeled. Prepare a procedure on how you would be able to identify the salts in each bottle using a flame test and how the results will be interpreted.

You found two bottles in the laboratory labeled X and Y. The instructor said that these bottles contain strontium chloride and sodium chloride. You were tasked to identify bottles X and Y and what salt is contained in each bottle so that it can be properly labeled. Prepare a procedure on how you would be able to identify the salts in each bottle using a flame test and how the results will be interpreted.

Chemical Principles in the Laboratory

11th Edition

ISBN:9781305264434

Author:Emil Slowinski, Wayne C. Wolsey, Robert Rossi

Publisher:Emil Slowinski, Wayne C. Wolsey, Robert Rossi

Chapter36: Qualitative Analysis Of Group I Cations

Section: Chapter Questions

Problem 4ASA

See similar textbooks

Similar questions

What would be the result (description in appearance) of Potassium Bromide and Tenessine solution?
What are the expected results when these following metals and non-mentals would react to HCL & CUCL2?
What gas is evolved on the surface of the copper plate when this is reacting with acid?
What is my products melting point and what does that tell me about the purity of my aspiron product? Given information is in the attached photo.
To determine the percent purity of a sample containing iron(II) ammonium sulfate; Suggest , 2 different methods for iron(II) ion. Explain in detail what errors may occur in the methods. (volhard method, gravimetric analysis, kjeldahl, etc.) Percentage content: 1-100% ; the solution concentrations to be used are 0.01-0.1M; Take the volumes of solution to be used between 1-50 mL
Why must a boiling stone be added to a solution to be refluxed?
12.1 g of goztic acid was dissolved in water weighing 87.9 G. The mass fraction (%) of acid in the solution was calculated.
You are assigned an unknown solution that contains Group III cations. To -1 mL of this solution was added 6 M NH3 the solution was agitated to mix well, and a reddish-brown precipitate with a gelatinous solid clinging to the inner walls of the test tube was observed. The solution was centrifuged and the supernatant was tested for completeness of precipitation by adding an additional drop of 6 M NH3. No cloudiness was observed as the drop of reagent diffused through the solution. The supernatant was then carefully decanted into a clean test tube, labeled (1st solution), and saved for further testing later. The precipitate remaining in the test tube was washed with a small amount of water, centrifuged, and the wash decanted and discarded. To the precipitate was added about 10 drops of 6 M NAOH plus ~1 mL H20 and the test tube was vigorously agitated. The resulting suspension was centrifuged and the supernatant liquid was transferred to another clean test tube and clearly labeled (2nd…
This is not graded. Do # 12 and 13.
Draw the orbital diagram for iron. Step-by-Step explanation of solution Justification
There are two different types of reactions that NaI might undergo with concentratedsulfuric acid in Part E. Describe and write balanced equations for both possibilities. From Part E: Reactions with NaI and NaCl17. CAUTION: 18 M H2SO4 is extremely caustic. Handle it with care.18. This part will utilize the “Testing for an Acidic or Basic Gas” technique described in Appendix B.1419. Collect about 2 dropper’s worth of 18 M H2SO4 in a small tube and take it to your workstation for this part;don’t perform the following reactions in the main hood where this acid is kept.20. Place a small quantity (about the same amount of solid used for part D above) of NaI in a clean dryevaporating dish. Place the same amount of NaCl in a separate dish.23. Lift one of the watch glasses just enough to add one dropper’s worth* of 3 M H2SO4 to the salt inside andthen quickly replace it.25. Clean the dishes out and set them up as you did before with solid NaI and NaCl, and fresh pieces of litmuspaper. Add acid…
You and a partner are asked to complete a lab entitled“Oxides of Ruthenium” that is scheduled to extend over twolab periods. The first lab, which is to be completed by yourpartner, is devoted to carrying out compositional analysis.In the second lab, you are to determine melting points. Upongoing to lab you find two unlabeled vials, one containinga soft yellow substance and the other a black powder. Youalso find the following notes in your partner’s notebook—Compound 1: 76.0% Ru and 24.0% O (by mass), Compound2: 61.2% Ru and 38.8% O (by mass). (a) What is the empiricalformula for Compound 1? (b) What is the empiricalformula for Compound 2? Upon determining the meltingpoints of these two compounds, you find that the yellowcompound melts at 25 °C, while the black powder does notmelt up to the maximum temperature of your apparatus,1200 °C. (c) What is the identity of the yellow compound?(d) What is the identity of the black compound? (e) Whichcompound is molecular? (f) Which compound is…