You have 100 mL of solvent available to do an extraction. Which will give a better separation? O A. 1 extraction with 100 mL B. 2 extractions with 50 mL C. 5 extractions with 20 mL O D.3 extractions with 25 mL

You have 100 mL of solvent available to do an extraction. Which will give a better separation? O A. 1 extraction with 100 mL B. 2 extractions with 50 mL C. 5 extractions with 20 mL O D.3 extractions with 25 mL

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter33: Automated Methods Of Analysis

Section: Chapter Questions

Problem 33.5QAP: Give the advantages and disadvantages of sequential injection analyzers compared to traditional flow...

See similar textbooks

Related questions

Q: The purpose of adding sodium sulfate in the extraction is to decrease the solubility of caffeine in ...

A: Solvent extraction or liquid-liquid extraction: The separation of compounds which are miscible in re...

Q: 3/ What is the product of adding water to (5,6,6 - tri bromo - 7- ethyl - 7 - mathyl oct - 3 - ene) ...

Q: 1. 2. 3.

Q: The following reaction is performed using 8.75 g of Fe2O3 and 4.75 g of Al. Fe2O3 (s) + 2 Al (s)...

A: Given, Fe2O3 (s) + 2 Al (s) ➝ Al2O3 (s) 2 Fe (s) Mass of Fe2O3 reacts = 8.75 g Mass of Al react...

Q: II в D The correct arrangement of figure I is: O light source – monochromator – sample – photomultip...

Q: A solution of potassium permanganate of unknown concentration was analyzed against a standard of var...

A: Given

Q: Question 12 All of the following are TRUE about molecular fluorescence spectroscopy, except: O A. th...

Q: 1.CH,Mgfe, THE 2.H F D.

A: Grignard reagent is the source of nucleophilic which undergoes nucleophilic addition reaction.

Q: where did the 14 come from?

Q: Question 2 What is the molar extinction coefficient if the pathlength of the sample cell is 5.6mm an...

Q: * 00 Radon (Rn) is the heaviest and the only radioactive member of Group 8A(18), the noble gases. It...

A: Given data No of atoms of radon=10^15 atoms Average atoms=1.373×10^4 Given mass=3.96g Molar mass=...

Q: Which of the following is/are TRUE regarding instrumental methods of analysis? these methods can mea...

A: Ans. Instrumental method of analysis: (a) In instrumental analysis much less sample can be used, lo...

Q: Which part in the figure can be a photovoltaic cell, phototube or photomultiplier tube? A ...

A: photovoltaic cell, phototube or photomultiplier tube are used as detector in spectrophotometer.

Q: Name the given compounds. For uniformity's sake, name all the branched substituent as if naming an a...

A: Given, the structures of the compounds,

Q: • Part A The specific rate constant for the first-order decomposition of N2O5 (g) to NO2(9) and Oz(9...

Q: I :x-ä=Ä, %3D TIL TY :A =Q= A, Which of the above would be expected to have sp² hybridization on ato...

Q: Which of the following is the most correct name for this compound? но a. 2-hydroxy-2-methylnonane di...

Q: Which of the following is the most correct name for this compound? a. 2,5-dioxooctanal b. 4,7-dioxoo...

Q: What is the IUPAC name of the following compound? CI Br 2-bromo-3-chlorocyclohexene 1-bromo-6-chloro...

A: for IUPAC nomenclature numbering will start from alkene position, hence the carbon which is contain ...

Q: Draw the product of the following reaction, indicating the correct stereochemistry. Ili CH,OH H,SO, ...

Q: SU 4 can be prepared from the reaction of 15.0 g of KMNO 4 with 22.6 g of H 25O 3? 2KMNO 4 + 5H 2SO ...

A: Sulphurous acid react potassium permagnate produced MnSO4

Q: The compounds in a multi-component solution can be separated by extraction. By using the most approp...

A: Extraction is the technique used to separate the desired products from the raw materials. Extraction...

Q: 1) In three drinking glasses, pour the same amount of water. 2) In one glass, add a spoon of sand. I...

A: Sand is not soluble in water. Fine salt or table salt is completely dissolved in water and makes a c...

Q: Which of the following is the most correct name for this compound? HO a. 2-hydroxy-2-methylnonane di...

Q: EXPLAIN IN 3-5 SENTENCES: 1. What are the tissue sources of Alkaline phosphatase?

A: Since you posted multiple questions, as per guidelines we will solve only first one for you. Alkalin...

Q: 1. Determine the normality of a solution which contains 2.83g of calcium sulfate in 500ml solution?

A: Normality: the number of gram equivalent moles of a solute present in one litre of the solution is c...

Q: a) CH3MGBR + CdBr2 b) CSH5NA + BeBr2 c) PHCH2OCH3 + Li

A: ANSWER : The reaction are known as Metal Exchange Reaction in which one metal get exchanged with oth...

Q: HO H,C H,C CH3 H,C 1. Но CH, H,CO CH 2. IZ

A: Given,

Q: 1. What is the [H3O-] and [OH-] ion concentration respectively in a solution that contains 0.155 M H...

A: HNO3 ---------> H+ + NO3- [H+] = [H3O+] [H+][OH-] = 10-14

Q: PART 3: Complete and balance the reaction below in basic solution: H2O2(aq) + Cl02(aq) cloz(aq) + Oz...

Q: How many grams of hydrogen are there in 50.1 g of CH3(CH2)4OH? please explain each step

Q: Draw the major product of this reaction. Ignore inorganic byproducts. Br2 (1 equiv)

A: We have to find the major product.

Q: Which of the following statements best describe a minimum azeotrope? 1. Minimum azeotrope boils at h...

A: Azeotrope can be defined as mixture of liquids that has a constant boiling point The boiling point o...

Q: what intermoleculor forces does CS2 have

A: Interpretation - To tell what intermoleculor forces does CS2 have - Introduction- Intermolecu...

Q: II в D Which part in the figure can be a grating or prism? O A

A: Prism or grating is used in an experiment for dispersion and controlling the direction of light with...

Q: CH3OH + H2O = ? Si(OH)4 + H2O = ? HS- + H2O =? What is the conjugate base and acid of the ff?

Q: Question 24 Using the given data above, determine the following information: What is the concentrati...

A: As per Beer-Lambert's law:

Q: 375 370 365 360 355 350 345 340 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1 A A Mole fraction B В Temperat...

Q: CH,CH3 CH3 CH;CH,CHCHCH,CHCH3 CH(CH3)2

Q: 7. Determine the amount of heat (in kJ) given off when 5.43 x 105 g of NO2 are produced. 2NO + O2) →...

A: Formation reaction of nitrogen dioxide is given

Q: Rank order the following molecules (I, II, and II) in order of relative boiling point temperature. н...

A: Boiling temperature can be defined as the temperature at which a liquid substance start converting i...

Q: Aqueo us sulfurous acid (H2S03) was made by dissolving 0.200 L of sulfur dioxide gas at 19°C and 745...

Q: 1. A polymer consists of lkg of polyester with number-average molecular weight 10000g mol-1 is mixed...

Q: CI Br

Q: HaSou Is03 230°C /24hrs.

A: Pyridine undergoes electrophilic substitution preferably at 3-position(or β-position) as it result...

Q: Consider the following reaction: X_Y + Z >2X + D, The proposed mechanism of this reaction is below: ...

Q: What is the name of the major product formed during the reaction between benzoyl chloride and phenol...

Q: Three resonance structures of the given anion are possible. One is given, but it is incomplete. Comp...

A: Resonance structure: There are many organic molecule which exhibit different structures because thei...

Q: What is normality of a solution that contains 1.5 g of Ca(OH)2 dissolved in 850 mL? (Molar mass = 74...

Q: View Policies Current Attempt in Progress Consider the reaction, CH3CI(g) + 3Cl2lg) →CCI4(3) + 3HCI(...

Question

You have 100 mL of solvent available to do an extraction. Which will give a better separation?
O A. 1 extraction with 100 mL
B. 2 extractions with 50 mL
C. 5 extractions with 20 mL
O D.3 extractions with 25 mL

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Give the advantages and disadvantages of sequential injection analyzers compared to traditional flow Injection analyzers.
You have 100 mL of solvent available to do an extraction. Which will give a better separation?a. 1 extraction with 100 mLb. 2 extractions with 50 mLc. 5 extractions with 20 mLd. 3 extractions with 25 mL
Which statement is valid when the multiple extraction and single extraction is compared. The effciency of multiple extraction and single extraction is incomparable. Single extraction and multiple extraction have the same effciency Multiple extraction is more efficent than single extraction Single extraction is more efficient than multiple extraction
30. Can you explain explain liquid chromatographic separation.... And how to solve problems akin to this?
What should you do if there are insoluble impurities after heating up your sample in the recrystallization solvent? a. Add more solvent to dissolves the impurities. b. Gravity filter the hot solution. c. Pick out the insoluble particles with a spatula. d. none of the above.
What types of flow meters are used in gas chromatography?
calculate the following for each sample gas chromatograph. a) retention time for each peak (label peaks) b) area of each peak c) %composition Sample GC of starting material for distillation of solution that is 40% ethyl acetate and 60% propyl acetate.
Where should the analyte be spotted on a TLC plate? Below the 1 cm spot line On the 1 cm spot line. On the solvent front line Above the 1 cm spot line
two chromatograms after LC separation. Which chromatogram is better to proceed for MS analysis? What mobile phase condition/composition (LC separation) was used?
Which of the following could be a consequence of an open and uncovered chromatographic chamber? The travel rate of a component would be faster. The chromatographic chamber will not be saturated. The mobile phase will take a longer time to reach the end line. Select one: Explain why it is included I, II, and III I only I and III II and III
A mixture of species of A, B, and C is injected into a liquid chromatographic column with length of 20.0 cm. The obtained separation results are listed as follows: Please calculate the selectivity factor for species A and B? Please keep your answer to two decimal places. I would need help with these question and the answer is 1.39 (I don't know how to get it)
How to identify spots on Thin layer Chromatography? Please shortly answer at your own words. Answer should be to the point (specific 4-5 lines).