Please show complete solution and answers must be expressed in engineering notation with 2 decimal places. You need a 45 Q resistor, but the stockroom has only 20 Q and 50 Q resistors. How can thedesired resistance be achieved under these circumstances? What can you do if you need a 35 0resistor?

We have to connect two 50 ohms in parallel combination and then have to connect a 20ohm in series…

Answered: You need a 45 Q resistor, but the…

You need a 45 Q resistor, but the stockroom has only 20 N and 50 Q resistors. How can the desired resistance be achieved under these circumstances? What can you do if you need a 35 n resistor?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 46P: An electronic device designed to operate at any temperature in the range from 10.0C to 55.0C...

See similar textbooks

Related questions

Q: Water Diamond A rectangular diamond block lies submerged at the bottom of a tank of water. A light…

Q: A 10.30-g bullet is fired into a stationary block of wood having mass m = 5.050 kg. The bullet…

A: Note:- You have posted two different questions. As per guideline about different questions, I will…

Q: Harmonic Oscillator: 1.5kg object is connected to a spring with k=100N/m. (assume that there is no…

Q: 2) For a converging lens with focal length f = 10 cm, the object distance p = 25 cm. Calculate the…

A: Given that The focal length of the convergent lens is f = 10cm (positive for…

Q: 28. A student attempts to lift a uniform 3.4-kg beam off the floor and raise it to a vertical…

Q: from Convex Lens 1: 6.0 cm Distance of Convex Lens 1 from Convex Lens 2: 15.0 cm

Q: What are the physics principle behind an ophthalmic slit lamp?

A: Ophthalmic slit lamp is an instrument used by ophthalmologists to check the eyes of the patients

Q: Lilo and Stitch, two observers, are observing each other's clocks. Stitch is on the ground, while…

A: GIVEN:- Lilo and Stitch are two observers observing each other's clocks. stitch is on the ground and…

Q: A baseball hits a car, breaking its window and triggering its alarm which sounds at a frequency of…

A: Write the equation of the Doppler effect. Here, fo is the frequency of sound, v is the speed of…

Q: Use the rules for working with measurements to give your answer to the appropriate accuracy and/or…

Q: Which of the following is FALSE regarding hyperopic persons? Their corrective lens is a convex…

A: Here the option (d) is correct. i.e The statement The focal lengths of their lenses are shorter…

Q: The left ventricle of a resting adult's heart pumps blood at a flow rate of 83.0 cm /s, increasing…

A: According to our guideline we have to do the first question only.please upload another question…

Q: In the figure ε1 = 2.46 V, ε2 = 0.819 V, R1 = 6.20 Ω, R2 = 1.80 Ω, R3 = 4.00 Ω, and both batteries…

A: GIVEN ε1 = 2.46 V, ε2 = 0.819 V, R1 = 6.20 Ω, R2 = 1.80 Ω, R3 = 4.00 Ω, To find out Power of battery…

Q: A stone was thrown vertically with initial velocity of 49 m/s from

Q: 4) An anti-reflective coating has index of refraction 1.5. For wavelength 2 = %3D 500 nm, calculate…

A: n=1.5 λ=500

Q: 1.70kg blóck of gold is put into 400.g of water initially mperature of the block and water is 26.4…

A: We are authorized to answer one Question at a time, since you have not mentioned which question…

Q: 2. Mars Escape Velocity Physics lab students are sent to Mars to do experiments during an Earth…

A: a) escape velocity is that minimum velocity that a moving body must have to escape from the…

Q: An object with a height of 2 cm is placed 3.2 cm to the left of a converging lens with a focal…

Q: An eight turn coil encloses an elliptical area having a major axis of 40.0 cm and a minor axis of…

A: Given, Major axis=40cm Minor axis=30cm Current=6.05A Magnetic field=1.97 ×10 ‑4 T

Q: Part B What is the resistance of a carbon rod at 25.8° C if its resistance is 0.0140 N at 0.0° C?…

Q: Q18. Given the net torque of the system, find the angular acceleration for the 70N system of three…

A: Given data: The radius of rotation is r=12 m. The angular velocity is required at t=5 s. The number…

Q: Two cars left Albany and Tenterden at the same time, passing through mount barker and both…

A: Given Two cars left Albany and Tenterden at the same time, passing through mount barker and both…

Q: The unit of Young’s modulus of elasticity is:

Q: Suppose you want a telescope that would allow you to see distinguishing features as small as 6.5 km…

A: distance between objects on moon (x)= 6.5 km distance of moon (d) = 384000 km wavelength of light =…

Q: best solves the given problem? I. To loosen a stubborn screw from a piece of wood with a screw…

A: A) Option (i) is correct longer The torque required to unscrew the screw is given by the product of…

Q: A diver performs a dive from the 10 m platform. At the instant of take-off his centre of mass is…

Q: If a blender is plugged into a 110 V outlet that supplies 2.7 A of current, what amount of power is…

A: Given data: Voltage (V) = 110 V Current (I) = 2.7 A Required: Power (P)

Q: Forensic Scientists use a "ballistic pendulum" to determine the speed of bullets as they leave the…

Q: An object with a height of 2 cm is placed 3.2 cm to the left of a converging lens with a focal…

Q: 1. Spring and SHM Consider a mass on a spring system that moves in simple harmonic motion. If the…

A: Given Amplitude is doubled i.e. A' = 2A i ) maximum speed Solution v = Aw v' = A' w v' = 2Aw v' =…

Q: Shown below are two carts connected by a cord that passed over a small frictionless pulley. Each…

Q: A syringe has a fine needle with an inside diameter of 97.9 µm. The barrel has a diameter of 2.76 cm…

A: Barrel diameter=2.76cm Force=4.08N

Q: A ball on a string is swung in a horizontal circle at a constant speed of 4.3 m/s. The centripetal…

Q: Block A in the figure (Eigure 1) has mass 1.00 kg, and block B has mass 3.00 kg. The blocks are…

A: The final speed of block A is 4.2 m/s And the potential energy stored is 10.78 j

Q: Find the value of force applied Displacement is 12 m Work done is 360 J

Q: 1.5kg object is connected to a spring with k=100N/m. (assume that there is no friction) If the…

A: Given:- Mass of the object is m=1.5 kg Spring constant k=100 N/m Amplitude of motion is A=3cm=3cm×1…

Q: A mass of 420 g is attached to a vertical spring, causing the spring to stretch a distance d. When…

Q: Box A has a mass of 11.0 kg, box B has a mass of 8.0 kg. There is an applied force of 29.0 N What is…

A: Given: The mass of box A is 11 kg. The mass of box B is 8 kg. The applied force is 29 N.

Q: TH Ta 4.00cm 3.00cm 2.20m A rectangular bar of gold has the dimensions as shown. (This is a very…

A: length of gold bar, l= 2.2 m cross-section area , A= (3 cm)x(4 cm)=12 cm2 = 12 x(10-2 m )2 = 12 x…

Q: i need the answer quickly

Q: Lilo and Stitch, two observers, are observing each other's clocks. Stitch is on the ground, while…

A: We know from einstein's special theory of relativity, When an object is moving with some velocity…

Q: a GPS receiver told you that your home was 15.0 km at a direction of 40 degrees north of west, but…

A: a GPS receiver told you that your home was 15.0 km at a direction of 40 degrees north of west, but…

Q: 2. An inductor is in series with an 80.0 2 resistor and an AC source. The voltage amplitude of the…

A: Given Resistance of the resistor is R=80.0 Ω Amplitude of the voltage source is V=150 V Frequency of…

Q: Q20. A hoop with a radius of 0.75 meters is rotated about an axis 0.5 meters from the center of…

A: Given data :- radius R = 0.75 m distance of axis of rotation from the center of mass of the hoop r =…

Q: After an unfortunate accident occurred at a local warehouse, you were contracted to determine the…

Q: P²IF The Par tical move in apotental Prove That

Q: In (Figure 1), how much force does the fluid exert on the end of the cylinder at A? How much force…

Q: briefly describe and illustrated by the diagram the scalar influence that the electrical charge is…

A: Electric charge is a condensation of a line of force where is interrupted by a point of reflection.

Q: A spherical conducting sphere of radius R = 10 cm has total excess charge Q. What is the electric…

A: Radius of spherical conducting sphere = 10 cm Total excess charge on sphere = Q

Q: D. - If you have a resistor of colors (red, brown, orange, silver) and it was measured by ohmmeter…

A: Given four Band Resistor Color bands red brown orange and silver Value of resistor 20000 Ohms To…

Concept explainers

Ohm's law

Ohm’s law is a prominent concept in physics and electronics. It gives the relation between the current and the voltage. It is used to analyze and construct electrical circuits. Ohm's law states that the voltage across a conductor is directly proportional to the current flowing through it.

Path of Least Resistance

In a series of alternate pathways, the direction of least resistance is the actual or metaphorical route that offers the least resistance to forwarding motion by a given individual or body.

Question

Please show complete solution and answers must be expressed in engineering notation with 2 decimal places.

You need a 45 Q resistor, but the stockroom has only 20 Q and 50 Q resistors. How can the
desired resistance be achieved under these circumstances? What can you do if you need a 35 0
resistor?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Consider a power plant is located 60 km away from a residential area uses Q-gauge (A=42.40mm2) wire ofcopper to transmit power at a current of I = 100.00 A.How much more power is dissipated in the copper wires than it would be in superconducting wires?
Resistors are commonly rated at 18W,14W,12W ,1 W and 2 W for use in electrical circuits. If a current of1 = 2.00 A is accidentally passed through a R=1.00 resistor rated at 1 W, what would be the most probable outcome? Is there anything that can be done to prevent such an accident?
Check Your Understanding Copper wires use routinely used for extension cords and house wiring for several reasons. Copper has the highest electrical conductivity rating, and therefore the lowest resistivity rating, of all nonprecious metals. Also important is the tensile strength, where the tensile strength is a measure of the force required to pull an object to the point where it breaks. The tensile strength of a material is the maximumamount of tensile stress it can take before breaking. Copper has a high tensile strength, 2108Nm2 A thirdimportant characteristic is ductility. Ductility is a measure of a material’s ability to be drawn into wires and a measure of the flexibility of the material, and copper has a high ductility. Summarizing, for a conductor to be a suitable candidate for making wire, there are at least three important characteristics: low resistivity, high tensile strength, and high ductility. What other materials are used for wiring and what are the advantages and disadvantages?
How does the resistance for copper and for silicon change with temperature? Why are the behaviors of these two materials different?
A 0.50-W, 220- resistor carries the maximumcurrent possible without damaging the resistor. If the current were reduced to half the value, what would be the power consumed?
An electronic device designed to operate at any temperature in the range from 10.0C to 55.0C contains pure carbon resistors. By what factor does their resistance increase over this range?
How can we analyze complex resistors?
Two 3.8microF capacitors, two 2.2kohms resistors and a 16.0V source are connected in series. Starting from the uncharged state, how long does it take for the current to drop from its initial value to 1.50 mA
Two 6.0 µF capacitors, two 2.2 kΩ resistors, and a 12.5 V source are connected in series. Starting from the uncharged state, how long does it take for the current to drop from its initial value to 1.30 mA?
Find the equivalent resistance of the network in the circuit and the current in eachresistor. The source of emf has negligible internal resistance. R1= 4 Ω, R2= 6 Ω, and R3= 3 Ω. Round off in nearest hundredths.1. RT = ________2. IT = ________ 3. I1 = ________ 4. I2 = ________ 5. I3 = ________ 6. V1 = ________7. V2 = ________ 8. V3 = ________
How many different resistance valuescan be created by combining three unequal resistors? (Don’t count possibilities in which not allthe resistors are used, i.e., ones in which there iszero current in one or more of them.)
What resistance values can be createdby combining a 1 kΩ resistor and a 10 kΩ resistor?