you stand at rest on a bench, the bench exerts a normal force on you, equal and opposite to your weight. Which force is related to this normal force by Newton's third law? PLEASE EXPLAIN CHOICE THOROUGHLY USING DIAGRAM IF NECCESSARY i) The gravitational force from the Earth on you ii) The gravitational force from you on the Earth iii) The normal force from you on the bench iv) None of the above

you stand at rest on a bench, the bench exerts a normal force on you, equal and opposite to your weight. Which force is related to this normal force by Newton's third law? PLEASE EXPLAIN CHOICE THOROUGHLY USING DIAGRAM IF NECCESSARY i) The gravitational force from the Earth on you ii) The gravitational force from you on the Earth iii) The normal force from you on the bench iv) None of the above

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter2: Matter And Energy

Section: Chapter Questions

Problem 10RQ: Why does an object weigh less on the moon than on earth?

See similar textbooks

Similar questions

Engineering Dynamics 1. A car moving at 70 km/hr has a mass of 1700 kg. What force is necessary to decelerate it at a rate of 50 cm/s^2? 2. Determine the angle of the superelevation for a 200 m hi-way curve so that there will be no slide thrust at a speed of 90 kph.
A submarine is traveling at a depth of ‘95’ kilometers in the ocean, where the gagepressure is 840 Kg(f)/cm2 . The density and bulk modulus of elasticity of water at the top surface of the ocean are 1025 kg/m3 and 24000 kg(f)/cm2 respectively. Find the following:(i) What will be the density of water at the depth of 2.0 kilometers?(ii) What will be specific volume and change of volume at that depth?(iii) What is the pressure at the top surface of the submarine? How much will bechanged in pressure if submarine change direction from North to East?
6.4. A force of 300 N is sufficient to keep a 100-kg wooden crate moving at constant velocity across a wooden floor. What is the coefficient of kinetic friction?
Engineering Mechanics IIThe 7.3 Kg block rests on the smooth incline. If the spring is originally stretched 80cm determine the total work done by all the forces acting on the block when a horizontal force P=320N pushes the block up the plane s=3.2m the angle made along the component in the direction of the force is 40 degrees. use spring stiffness equals to 25N/mthis is the book we are using in our class you can download it through this link:https://drive.google.com/file/d/1Ws-HdkaO4OAfTMa1crhsf63rbClZUCl5/view?usp=sharing
Penny is adjusting the position of a stand up piano of mass mp = 155 kg in her living room. The piano is lp = 1.35 m in length. The piano is currently at an angle of θp = 36 degrees to the wall. Penny wants to rotate the piano across the carpeted floor so that it is flat up against the wall. To move the piano, Penny pushes on it at the point furthest from the wall. This piano does not have wheels, so you can assume that the friction between the piano and the rug acts at the center of mass of the piano. Randomized Variables mp = 155 kglp = 1.35 mθp = 36 degrees a. Write an expression for the minimum magnitude of the force Fs in N Penny needs to exert on the piano to get it moving. Assume the corner of the piano on the wall doesn't slide and the static friction between the rug and the piano is μs. b. The coefficient of kinetic friction between the carpet and the piano is μk = 0.27. Once the piano starts moving, calculate the torque τp in N⋅m that Penny needs to apply to keep moving the…
When one boy is sitting 1.20m from the center of a seesaw, another boy must sit on the other side 1.59m from the center to maintain an even balance. However, when the first boy carries an additional weight of 14kg and sit 1.80m from the center, the second boy must move to 3m from the center to balance. Neglecting the weight of the seesaw, find the weight of the heavier boy. need answer asap
The meterstick shown is 100 cm long. It is free to pivot around its center of gravity (CG), which is at the 50 cm mark. There is a 25.0 N block hanging from the 80 cm mark. Decide where each of the other blocks should be placed, one at a time, to balance out the 25.0 N block. At what mark on the meter stick would you place a 18.0 N block to balance the 25.0 N block?
A dam has been built to hold back a lake. The dam gate is at the same depth as the lake bottom. The center of the rectangular gate is at some depth d below the water surface. The gate is 1 m tall and 3 m wide. If the average force applied to the gate by the water is 744 kPa m^2, what is d? Show your work. (a) 15 m (b) 150 m (c) 3000 m (d) 30 m (e) None of the above.
Chemistry The contact angle for water in a clean glass is zero. Calculate the surface tension of waterin a 0.3 mm diameter vertical tube if the water rises to a height 4.96 cm above the liquidoutside the tube, knowing that specific gravity of water equals 998.2 kg/m 3 and theacceleration due to gravity equals 9.806 m/sec2
Nitrogen gas is confined in a cylinder and the pressure of the gas is maintained by a weight placed on the piston. The mass of the piston and the weight together is 100 kg. The acceleration due to gravity is 9.81 m/s2 and the atmospheric pressure is 1.01325 bar. Assume frictionless piston. Determine: (a) The force exerted by the atmosphere, the piston, and the weight on the gas if the piston is 200 mm in diameter. (b) The pressure of the gas. (c) If the gas is allowed to expand pushing up the piston and the weight by 500 mm, what is the work done by the gas in kJ? (d) What is the change in the potential energy of the piston and the weight after the expansion in part (c)?
Engineering Mechanics IIThe 7.3 Kg block rests on the smooth incline. If the spring is originally stretched 80cm determine the total work done by all the forces acting on the block when a horizontal force P=320N pushes the block up the plane s=3.2m the angle made along the component in the direction of the force is 40 degrees. use spring stiffness equals to 25N/mthis is the refference we are using maybe it can help you in answering the problem :https://drive.google.com/file/d/1Ws-HdkaO4OAfTMa1crhsf63rbClZUCl5/view?usp=sharing
Your physics book is resting in front of you on a horizontal table in the campus library. You push the book over to your friend, who is seated at the other side of the table, 0.400 m north and 0.300 m east of you. If you push the book in a straight line to your friend, friction does -4.8 J of work on the book. If instead you push the book 0.400 m due north and then 0.300 m due east, how much work is done by friction?