•1 www 50 0-01 H

Q: c)    Compute the no load line voltage of a star connected 4-pole alternator for the following data:…

A: Given data, The flux per pole =0.12Wb, Slot per pole per phase  = 4 Conductor/slot = 4, Two-layer…

Q: In the circuit given below, R= 9 ΚΩ. Using mesh analysis, find the value of vo 30 V R 20 V (+ 5 ΚΩ 4…

A: Given circuit,

Q: What is the power-delay product for the symmetrical reference inverter shown below, if VDD is…

A: It is given that: VDD=3V

Q: The D latch of Fig. 5.6 is constructed with four NAND gates and an inverter. Consider the following…

A: Solution- Function table- En                       D                                        Next…

Q: 19 A balanced three-phase voltage source, Van = 200/0° V rms, positive phase sequence, is connected…

A:

Q: OV 50 Ω Μ 20 Ω Μ 80 Ω 15 Ω 30 Ω Μ ig 20 Ω Μ is ) 20 V Μ 12 V '60 Ω

A: Kirchhoff's Current Law- This law states that the sum of all incoming current is equal to all the…

Q: Given the electric flux density, D = 0.3ra.nC/min free space: (a) find E at point P(r= 2, 0 = 25., p…

A: Given: D→=0.3r2 ar^nCm2 in free space Required:  (1) find E→at point Pr=2,θ=25°,φ=90°  (2) Find the…

Q: Ex. 3) a 3-phase, 50Hz generator running at 1500 rpm, the stator inside diameter is (0.5m) and its…

A:

Q: b. An AM transmitter is modulated by five different tones at 1.5 kHz, 3 kHz, 4.5 kHz, 6 kHz and 7.5…

A: Given data, An AM transmitter is modulated by five different ones at f1=1.5 kHzf2=3 kHzf3=4.5…

Q: Trademark is a legal term used to describe the rights that creators have over their literary and…

A: Copyright is a legal term that describes right that creators have over their literary and artists…

Q: Draw a logic diagram constructing a 3 × 8 decoder with active-low enable, using a pair of 2 × 4…

A: A circuit device that changes a code into a set of signals, know as decoder. It is a just reverse of…

Q: A 10 Q2 resistor is connected in series to a parallel combination of a 60 resistor and a 20 resistor…

A: Given data, R1=10ohm R2=60ohm R3=20ohm V=220V

Q: cement mode MOSFET biased as show Note that the gate and drain voltage ed as shown. Sketch the…

A: The diagram for n-channel mode can be drawn as,

Q: Determine the frequency and duty cycle

A:

Q: A controller is designed so that the nominal closed-loop transfer function has bandwidth 0.5 rad/s…

A: Given   A controller is designed so that the nominal closed-loop transfer function has bandwidth 0.5…

Q: How many resistors are there in the hybrid pi model? 0 1 02 04 none of the other choices 05

A: Hybrid pi model: A circuit model for examining transistor small-signal performance is the hybrid-pi…

Q: Design the sequential circuit specified by the state diagram of Fig. 5.19 , using T flip-flops.

A: The given state diagram is shown below:

Q: 3.15P) The excess electron concentration and Electic field is plotted in a bar of an n-type…

A: The given plot is shown below:

Q: -3s+1 s+a = Given a plant P (s) and a model for measureable output disturbance d with transfer…

A: Given,Ps=-3s+1s+aandQs=1s+bWhere,a=4.8b=9

Q: Consider the circuit below with i(t) = 2-2 e^(-6t) A [e is the exponential] for t> 0 and i(t) = 0…

A:

Q: A 470 ohm resistor has 18.8 volts across it. What is the power consumed by that resistor? Enter your…

A: Given, Resistance, R = 470 ohm Voltage across it, V = 18.8 volts

Q: A 1000W AM carrier signal has a modulation index of 0.5. a. How much power is in the total signal?…

A: Given: In an AM modulated signal, Carrier power, Pc=1000 W Modulation Index, m=0.5

Q: The ideal maximum voltage gain of a CD amplifier is: 1. gmRs. 2. -gmRd. 3. 1.

A: In this question we will write ideal maximum voltage gain of common drain amplifier....

Q: The main disadvantage of the CB amplifier compared to the CE and CC amplifier 1. has low input…

A: For the above given question we need to identify disadvantages of the common base amplifier compared…

Q: A choke coil is connected in series with a fixed resistor. A 240 – volts, 50 – Hz supply is applied…

A:

Q: Q4 - 3-phase, 6 pole, 400V 50Hz, I.M, has the stand still impedance of (0.04 + j 0.44) ohm/phase and…

A: Induction Motor: Relative slip is defined as the difference between synchronous speed to motor rotor…

Q: Select one: a. None of the answers O b. 2 diodes are reversely biased O c. the 10K resistor can not…

A:

Q: 1. A three-phase, three-wire CBA system with an effective line voltage of 106.1 V, has a balanced…

A: Current: It is the time rate of the change of the charges. It is also known as the flow of the…

Q: a) The reason of high input resistance of the MOSFET is: 1. The insulator layer. 2. The reverse…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Q4/:- For VCO-LO circuit block, if the message signal is the sine wave as shown in the figure below…

A: Voltage controlled oscillator in which the oscillating frequency is controlled by the voltage. The…

Q: b) A periodic composite signal with a bandwidth of 2500 Hz is composed of two sine waves. The first…

A: It is given that: B.W.=2500 Hzf1=100 HzVmax1=20 VVmax2=5 V

Q: An AM transmitter uses high-level modulation of the final RF power amplifier, which has a dc supply…

A: Given data, Supply voltage Vcc=36 V Current I = 2.8 A Efficiency η=77%

Q: tance Questions 2 For the following circuit assume Vi-9 V, Vz1-5V, VD1-0.6V. Vo is: R = 1 k Dowww…

A:

Q: unive niversal series motor has a resistanc of of 30 and an inductance of X Henry. when connected to…

A: Solution- E1= V-IR=250-30×0.8=226 VNdc = 2000 rpmE2 = V-IR-IX                          IR =…

Q: Answer it clearly Show the complete solution An R-L-C series circuit has a current which lags the…

A:

Q: ect all that are true    A) A PID controller can always be written as an observer-based controller…

A: PID controller refers to Proportional Integral Controllers. Device used in  in industrial…

Q: Q3: The response of a pressure sensor is determined experimentally and given in the table below. A…

A: Given data, Pressure(kPa) 10 20 30 40 50 60 Voltage(V) 0.3 0.3 0.4 0.6 0.8 1

Q: skin temperature is 310 K uman surface is approxima the power radiated from th uman body is

A: Given A=1.8m2 T=310 k

Q: A rectangular waveguide is terminated with an unknown load. By using a slotted line, load VSWR is…

A: VSWR : VSWR stands for voltage standing wave ratio is directly proportional to reflection…

Q: semiconductor is n or p type, device is operating in accumulation, deplet 1 charges do each of the…

A: The semiconductor is p-type and the operation of devices in inversion mode.

Q: A 2-wire d.c. ring distributor is 300 m long and is fed at 240 V at point A. At point B, 150 m from…

A: It is given that: L=300mVA=240 VLAB=150mLBC=50mLCA=100mIAB=IAIBC=IA-120ICA=IA-200IB=120 AIC=80…

Q: 2. Design a circuit that implements function p below using AND, OR, and NOT gates. DO NOT change the…

A: Logic gates: Logic gates are the fundamental component of the digital electronic. The logic gates…

Q: Simplify the following Boolean functions by first finding the essential prime implicants: F (A, B,…

A: Given data :  Boolean functions : F (A, B, C, D)=Σ(0, 2, 3, 5, 7, 8, 10, 11, 14, 15)

Q: Q7: Evaluate both sides of Stoke theorem for the field H=6xy ax-3y² ay A/m and the rectangular path…

A:

Q: The Fourier transform of a signal x(t) is X(w). Find the Fourier transform of x(-(1-2t)).

A: For the above given question we need to calculate fourier transform of shifted and scaled version of…

Q: Consider the circuit below with i(t) = 80 sin(20t) mA for t> 0 and i(t) = 0 for t<0. C1-400 uF. C…

A:

Q: The blood pressure is 80 mmHg diastolic and 120 mmHg systolic which equal to: O 10.640 kPa and…

A:

Q: A 25 kVA, 13,800/240 V distribution transformer has full load efficiency of 97% at unity power…

A:

Q: For the following circuit assume Vi-9 V, Vz1-5V, VD1-0.6V. Voi R = 1 k ww Select one: O a VzI None…

A:

Q: Write and verify: A behavioral HDL model of the BCD ripple counter described in Problem 6.13.

A: BCD ripple counter:- It is digital serial counter which counts ten digits. It is reset for the every…

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).