1. A full-wave center -tapped C-filtered power supply has a transformer with 5:1 turns ratio, with a supply of 110Vac, 60HZ. What capacitance would be required to maintain a 10V minimum voltage across a 1000 load? (Answer should be whole number)

1. A full-wave center -tapped C-filtered power supply has a transformer with 5:1 turns ratio, with a supply of 110Vac, 60HZ. What capacitance would be required to maintain a 10V minimum voltage across a 1000 load? (Answer should be whole number)

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter8: Basic Electric Motors

Section: Chapter Questions

Problem 37RQ: Which of the following capacitors could be used to replace a 35-microfarad, 370-volt running...

See similar textbooks

Related questions

Q: 9 A 100-ohm resistor is connected to the secondary winding of an ideal transformer with a turns…

Q: Tutorial 27/5/2021 EX1: A 20KVA, 2500/250V, SoH,1- 1 - transformer has the following test results.…

Q: A (220/22) kV, 440 MVA transformer has a reactance of 0.1 PU. Then, the equivalent reactance in Q on…

Q: A 450KVA single-phase transformer has a turns ratio of 15/60. The primary winding is connected to…

A: (1) The first question is completely correct in regards to calculation and numerical values. (2) In…

Q: The star-connected secondary of a transformer supplies a delta-connected motor taking a power of…

A: Here, Secondary of transformer is star connected, so line current and phase current are same but…

Q: A choking coil having a resistance of 20 Ω and an inductance of 0.07 henry is connected with a…

Q: 2.15 A power-supply transformer has a tums ratio of 5:1. What is the secondary voltage if the…

A: Given, Power supply transformer with Turns ratio N1N2=51 Primary voltage V1=120 V

Q: A transformer having 2400 turns on the primary and 48 turns on the secondary is used as an…

Q: 100KVA, 200 V/ 200 kV testing transformer has 6% leakage reactance and 1% resistance. An insulator…

A: Turns Ratio Testing. Turns ratio transformer testing is regularly used to guarantee that the…

Q: A transformer has 440 primary windings and 22 secondary windings. The potential difference across…

Q: The maximum efficiency at Full-load and Unity power factor of a 1-phase, 25 kVA, 2000/1000V, 50Hz…

A: At maximum efficiency, iron loss = copper loss Output power at full load = kva rating * power factor…

Q: The resistor of 6-ohms and unknown impedance coil in series draws 12A from a 120 volts, 60hz line.…

Q: 45 The 110V output of a transformer is applied to a 220 resistive circuit, causing, 0.22Amps to flow…

A: Given: Secondary voltage, V2=110 V Resistive load at secondary, R2=22 Ω Primary current, I1=0.22 A

Q: Q2) Design a quarter-wave transformer to match a 100 load with a transmission line with a…

Q: For the following question, you must draw a transformer circuit. A 480/2400-V rms step-up ideal…

A: The transformer is a static device that steps up or steps down the voltage depending upon the turn…

Q: A coil is connected to a 230 volt source. If the voltage across the inductor is 125v, and the power…

A: The solution is given below

Q: The mutual inductnce between two unity coupled coils of 9 H and 4 H will be ?

A: Given: Coil 1 inductance, L1 = 9 H Coil 2 inductance, L2 = 4 H As coil is unity coupled, so…

Q: Calculate the reactance of a coil of inductance 0.2H when it is connected to a 50Hz supply. A.…

A: The solution is given below

Q: 5 Determine the regulation of an 8kVA, 100 V/ 200 V, single phase transformer when its secondary…

A: Given values are - E1E2=100200S=8kVAV2=194Volt

Q: Q13.i. Consider a single phase Transformer with secondary current, 3.5A and secondary Voltage, 11kV.…

A: Solution:- The power rating of a transformer is given by current in the transformer multiplied with…

Q: A 100 kVA, 400 V/250 kV testing transformer has 8% leakage reactance and 2% resistance on 100 kVA…

Q: A 25 KVA transformer supplies a load of 12 KW at a power factor of 0.6 lagging. If additional unity…

Q: A 100-KVA, 20/5 KV transformer has an equivalent impedance of 10%. Calculate the impedance (in…

A: It is given that: S=100 kVA=0.1 MVAV1V2=200kV5kVZpu=10%=0.1

Q: A 25 KVA transformer supplies a load of 12 KW at a power factor of 0.6 lagging. If additional unity…

Q: 4.a. A demountable stud bushing on high-voltage leads eliminates the need for a. an oil stop. b. a…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: 03 /A coil of inductance 636.6 mH and negligible resistance is connected in series with a 100 0…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: Calculate the equivalent impedance of a circuit where a coil of (5H, angle 53.2 degrees) ohms is…

A: To find equivalent impedance

Q: 7. Two single-phase transformers, connected in open delta will supply power to a 200 hp, three-phase…

Q: The primary and secondary winding of a 26 kVA transformer has 400 turns and 40 turns, respectively.…

Q: A 5KVA, 120/540V single phase transformer has a secondary terminal voltage of 500 V when loaded.…

A: Given: Q=5 kVAVLV=120 VVHV=540 VVL=500 V

Q: A 15 kVA, 600/120 V, 0.95 efficient conventional transformer is from a 720 V source to a 600 V load…

A: Since you have posted a question with multiple sub-parts, we will first three subparts for you. To…

Q: A single-phase transformer used for street lighting(high-pressure sodium discharge lamps) converts 6…

A: (a) The given single-phase transformer is step down transformer as the output voltage at the…

Q: (A) The capacitances of a 3-phase belted cable are 12-6 µF between the three cores bunched together…

A: Consider the given below diagram of the cable,

Q: primary and secondary coils of a transformer have 50 and 1500 turns respectively. IF the magnetic…

Q: A factory is fed from a transformer rated 450KVA, the peak demand power is 350KW and the power…

Q: single coil 600 turns instrument transformer, operating in the step-down mode with a 40 percent tap,…

A: Dear student as per our guidelines we are supposed to solve only one question in which it should…

Q: 2. A resistor of 6 0 and an unknown impedance coil in series draw 12 amps from a 120 volts, 60 Hz…

Q: Calculate the efficiency of the transformer load at (a) full Cb) half-l.ad unity P.f Also Calculate…

A: A transformer is an electrical machine which is used in AC circuit to either step up or step down…

Q: Q2/ Fill in the blanks: 1- The two windings of a transformer is ........ linked. 2- If a transformer…

A: In this question we will write transformer related questions.....

Q: A 200-kVA, 230-V/230-kV testing transformer having a resistance and leakage reactance of 2% and 7%…

Q: QUESTION 2 Calculate the magnitude of the reflected impedance for an ideal transformer that is…

A: The solution is given below

Q: An isolation transformer is connected to a 158V RMS source and a 3.1kQ456.4° load. Calculate the…

Q: A 16 Q resistance is connected across the secondary winding of a single-phase power transformer…

Q: A single-phase 22KVA, 2200 V/220 V, 50 Hz, distribution transformer is to be connected as an auto…

A: Here, we have a single phase transformer. For which the input voltage is 2200 V and the output…

Q: 2- When the frequency of the voltage across of a (50HZ) power transformer increased by 10% of the…

A: Transformer A transformer is a device used in the power transmission of electric energy. The…

Q: Three identical coils, each of resistance 10 Q and inductance 42 mH are connected in star and in…

A: First calculate impedance of the phase and than using ohms law calculate phase current. Power…

Q: A single phase practical transformer rated 100 kVA, 12470 volts primary, 600V secondary has a…

A: The power consumed by resistance is given as: P=I2R=0.101×0.101×220×103=2.244 kW The kVAR rating is…

Q: A 22 Q resistance is connected across the secondary winding of a single-phase power transformer…

A: Option a is correct. The detailed solution is provided below.

Q: A 5KVA ideal transformer supplied with 120V RMS and connected to a 1kQ load draws 2A RMS of current…

Concept explainers

Three-Phase Transformers

Three-segment transformers are a type of transformer used to transform voltages of electrical systems into three ranges. Two type transformers are shell-type transformer and core type transformer. In brief, it could be described because of the exquisite kinds of configurations.

Transformer

Ever since electricity has been created, people have started using it in its entirety. We see many types of Transformers in the neighborhoods. Some are smaller in size and some are very large. They are used according to their requirements. Many of us have seen the electrical transformer but they do not know what work they are engaged in.

Question

Please answer this

1. A full-wave center -tapped C-filtered power supply has a transformer with 5:1 turns ratio, with a
supply of 110Vac, 60HZ. What capacitance would be required to maintain a 10V minimum voltage
across a 1002 load? (Answer should be whole number)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

If a capacitor produces 15 ampere on a 240-volt supply, which of the following is its microfarad rating? 166 microfarad 15 microfarad 200 microfarad 3450 microfarad
Which of the following capacitors could be used to replace a 35-microfarad, 370-volt running capacitor? a. 35 microfarad, 330 volt b. 35 microfarad, 390 volt c. 30 microfarad, 440 volt d. 40 microfarad, 370 volt
The circuit is connected to a 60-Hz line. The apparent power in the circuit is 29.985 VA, and the power factor is 62.5%. The resistor has a voltage drop of 14.993 V, the inductor has an inductive reactance of 60 , and the capacitor has a capacitive reactance of 45 . ETITZVA29.985PF62.5%ER14.993VIRRPELILXL60VARsLLECICXC45VARsCC
Inductive Circuits Fill in all the missing values. Refer to the following formulas: XL=2fLL=XL2ff=XL2L Inductance (H) Frequency (Hz) Inductive Reactance ( ) 1.2 60 0.085 213.628 1000 4712.389 0.65 600 3.6 678.584 25 411.459 0.5 60 0.85 6408.849 20 201.062 0.45 400 4.8 2412.743 1000 40.841
7. The no-load current of a transformer is 4A at 0.25 pf when supplied at 25V, 60Hz. Find the magnetizing component of the no-load current
A choking coil having a resistance of 20 Ω and an inductance of 0.07 henry is connected with a capacitor of 60 μF capacitance which is in series with a resistor of 50 Ω. Calculate the total current and the phase angle when this arrangement is connected to 200-V, 50 Hz mains.
2. A series circuit consisting of a 0.0795-henry inductor and a 177-microFarad capacitor is connected to a 120-volt 60-cycle source. Calculate (a) the equivalent reactance of the circuit. (b) the circuit current. indicaling Whether the latter lags or leads
A series circuit composed of a resistance of 24 ohms, an inductance of 0.09 henry and a capacitance of 8 microfarad, is connected to a 120-volt 50-Hz supply. Calculate the (a) power factor of the circuit, (b) total reactive power, (c) voltage drop accross the inductor.
A 440-V, 60-Hz,36.7 HP induction motor has power factor of 0.75 (lagging). Three Δ-connected capacitors are installed to improve the power factor to 0.95 (lagging). Calculate the kVA ________________ of the capacitor bank, and the capacitance of each capacitor (in microfarads) __________________. (please answer with 3 decimal, and clear solution!)
Calculate the maximum horsepower of an induction motor at 0.8 power factor and 85.5 percent efficiency. Given a 75 KVA, three phase transformer supplies the following initial loads: Capacitor bank drawing 25 kVAR and an inductive load drawing 36 kw, 0.715 power factor.Please show the detailed solution.
4.a. A demountable stud bushing on high-voltage leads eliminates the need fora. an oil stop.b. a gasket.c. a terminal lug. 4.a. A power transformer with standard insulation class of 69 kv will withstand an rms test voltage ofA. 140 kv.B. 440 kv.c. 69kv.
The mutual inductnce between two unity coupled coils of 9 H and 4 H will be ?