1. Which of the following has dispersion forces as its only intermolecular force? а. СCl4 c. CH3CI b. HCI d. NaCl 2. A sketch of the phase diagram is given below. P A T On the phase diagram shown above, segment of temperature and pressure under which the solid and the gas of the substance are in equilibrium. а. АВ corresponds to the conditions b. AC С. CD d. BC

1. Which of the following has dispersion forces as its only intermolecular force? а. СCl4 c. CH3CI b. HCI d. NaCl 2. A sketch of the phase diagram is given below. P A T On the phase diagram shown above, segment of temperature and pressure under which the solid and the gas of the substance are in equilibrium. а. АВ corresponds to the conditions b. AC С. CD d. BC

Chemistry: An Atoms First Approach

2nd Edition

ISBN:9781305079243

Author:Steven S. Zumdahl, Susan A. Zumdahl

Publisher:Steven S. Zumdahl, Susan A. Zumdahl

Chapter9: Liquids And Solids

Section: Chapter Questions

Problem 16Q: Define critical temperature and critical pressure. In terms of the kinetic molecular theory, why is...

See similar textbooks

Similar questions

Define critical temperature and critical pressure. In terms of the kinetic molecular theory, why is it impossible for a substance to exist as a liquid above its critical temperature?
Define the normal boiling point of water. Why does a sample of boiling water remain at the same temperature until all the water has been boiled? Define the normal freezing point of water. Sketch a representation of a heating/cooling curve for water, marking clearly the normal freezing and boiling points.
The vapor pressure, ?,P, of a certain liquid was measured at two temperatures, ?.T. The data is shown in the table. T (K) P (kPa) 325 3.53 775 6.53 Keep the pressure units in kilopascals. If you were going to graphically determine the enthalpy of vaporizaton, Δ?vap,ΔHvap, for this liquid, what points would you plot? To avoid rounding errors, use three significant figures in the ?x‑values and four significant figures in the ?y‑values. point 1: ?=x= point 1: ?=y= point 2: ?=x= point 2: ?=y= Determine the rise, run, and slope of the line formed by these points. rise=rise= run=run= slope=slope= What is the enthalpy of vaporization of this liquid?
The normal boiling point of benzene is 80.1oC. What is the vapor pressure of benzene at 30.0oC? The ΔHvap of benzene is 30.7 kJ/mol
1. Describe the intermolecular forces that must be overcome to convert each of thefollowing from a liquid to a gas: a) Br2 b) CH3OH c) H2S 2. A mixture consists of 78,1 g benzene (C6H6) and 92,1 g toluene (C7H8). Both substancesare volatile, and their vapour pressures (in the pure form) are as follows at 20°C: Benzene: 0.0988 atmToluene: 0.0287 atm a) Which substance, benzene or toluene, would have the lowest boiling point in thepure form? Give a reason or your answer. b) Calculate the vapour pressure of the benzene-toluene mixture at 20°C.
The molar enthalpy of vaporization of carbon disulfide is 26.74 kJ/mol, and its norml boiling point is 46oC. What is the vapor pressure (in torr) of CS2 at 0oC?
The equilibrium vapor pressure of water at 70.0°C is 233.7 torr. If 0.190 g of H2O is collected in a closed 325.0-mL flask maintained at 70.0°C, which phase(s) of water will be present in the flask? Assume the density of liquid water is 1.00 g/mL.
If the enthalpy of vaporization for water is 44.0kJ/mol and the vapor pressure of water at 56oC is 123.8mmHg, what is the vapor pressureat 95oC?
The vapor pressure, P, of bromine at several temperatures, T, is given in the table. T(K) P(Torr) 280.0 92.26 285.0 117.01 290.0 147.76 295.0 184.52 300.0 228.77 Use this data to calculate the heat of vaporization, ΔHvap for bromine. ΔHvap = ____ kJ/mol Calculate the normal boiling point for bromine T=_____oC
The temperature dependence of the vapor pressure of solid sulfur dioxide can be approximated by log(p) = 10.5916 – 1871.2/T, with p in Torr and T in K. The temperature dependence of the vapor pressure for liquid sulfur dioxide is given by log(p) = 8.3186 – 1425.7/T. Determine the temperature and pressure at the triple point.
The vapor pressure, P, of a certain liquid was measured at two temperatures, T. The data is shown in the table. T (K) P (kPa) 275 3.37 625 8.22 Keep the pressure units in kilopascals. If you were going to graphically determine the enthalpy of vaporizaton, ΔHvap, for this liquid, what points would you plot? To avoid rounding errors, use three significant figures in the x‑values and four significant figures in the y‑values. point 1: x= point 1: y= point 2: x= point 2: y= Determine the rise, run, and slope of the line formed by these points. rise= run= slope= What is the enthalpy of vaporization of this liquid? ΔHvap= __________ J/mol
What is represented by A on the phase diagram?