10. The 1/v axis of a reciprocal plot is labeled 10° The 1/[S] axis is labeled [S]*': (M)'× 10.) The plot intersects the two axes at “2" and "-4," respectively. What are Vmax and Km ? v: (nmoles x literx min)×
Q: The average normal body temperature is generally accepted as 98.6 F. What is the temperature in C…
A: Hours, minute and seconds are some common units of time, whereas kelvin, F, degree Celsius are units…
Q: Why is it better to use 10.0mL or greater of a liquid in measuring its density?
A: We use 10.0ml or greater of a liquid as graduations on the measuring cylinder make it easier to…
Q: Jse only dimensional analysis to solve this problem. Include a number, unit, and substance in the…
A: Given that: Mass of methanol = 60.0 g Density of methanol = 0.791 g/mL Percent of solution =…
Q: Semipermeable membrane Pure H20 NaCl(aq) H20-- Time H20 H20 -H2O IHI
A: There are two solutions in a container where one is pure water and the other is sodium chloride…
Q: Q2: Classify the quality of crude oil based on the properties listed in the table below and explain…
A: Classify Quality of crude oil based on the properties listed in table
Q: What is normality of a solution containing 90g of HCI in 2600ml of solution? (Use the given…
A: Normality is defined as number of gram equivalents of the solute dissolved per litre of solution.
Q: You find that there is 500 mL D5W left in an IV infusion. The order is to infuse at 50 mL/hr. How…
A: Given: Volume of DSW left in IV infusion = 500 mL Order of infusion = 50 mL/hr
Q: If 416 mL of olive oil are used to prepare a liter of olive oil emulsion, how many grams of the oil…
A: Specific gravity :- The ratio of density of substance to density of water is defined as specific…
Q: Data from M. J. Samide, J. Chem. Ed. 2004, 81, 1641. (a) Do the volumes delivered by student 1 from…
A: a. First calculate the volumes delivered by student 1 from burette. Mean volume (V¯) = 10.01 ml No.…
Q: Which substance should go at the bottom of the fraction ration and which should go on the top ?…
A: Given The number of moles of H2 is 0.37 mol.
Q: A chemist working as a safety inspector finds an unmarked bottle in a lab cabinet. A note on the…
A: Answer :- a) 0.705 g.mL-1 b) Yes c) diethylamine…
Q: Calculate the equivalent weight (EW) and normality (N) for a solution of H3PO4 given the following…
A: The question is based on the concept of solutions. number of equivalent of a solute present in one…
Q: For the calculation of sd, shouldn't it be (0.97-1.09) and so on... because 0.97 = x and 1.09 =…
A: The general equation to find the standard deviation is: ∑i=2n(Xi-μ)2NwhereXi = Experimental valuesμ…
Q: A chemist working as a safety inspector finds an unmarked bottle in a lab cabinet. A note on the…
A: Given: Volume of unknown liquid = 1.124 L Mass of unknown liquid = 704 g
Q: Simplify the following quantities using a unit with an appropriate prefix: (a) 2.5 104 Hz. (b) 8.43…
A: A question based on general chemistry that is to be accomplished.
Q: A 700 cu ft tank contains 17lb of C2H6 and 9lb of CH4 at 50F. What is the specific gravity of the…
A:
Q: The reading on a graduated glass tube filled with melted gallium is 120.50 cm at 29.8 °C. The local…
A:
Q: 4. Below left is a cylinder containing water. An object with a mass of 21g and a volume of 15 cm³ is…
A: “Since you have asked multiple question, we will solve the first question [Q4] for you. If you want…
Q: 1.1 Unit conversion. (a) Convert 10 lbm • ft/s² to units of lbf and dynes. (b) Convert 20 kPa to…
A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…
Q: The data below is for a sample of gas at 25ºC. Volume Difference in Hg Pressure Px V (mL) Levels…
A: The P x V table is as follows
Q: 2.7 x 10-3
A: Actually of La3+ means concentration at La3+ (effective) now as La(IO3)3 and La(NO3)3 both contain…
Q: Calculatian OF Fez Do. lucing02: . g-02 x. Conversion Factor 1 -X. Conversfon Factor 7 Corversion…
A: Mole relation gives the relationship among moles, molar mass, atomic mass, particles.…
Q: A 400 mL sample of water is filtered through a pre-weighed filter. After drying to constant weight…
A:
Q: Normal body temperature is 98.6 F. What is normal temperature in K?
A:
Q: How do I solve number 11?
A: The density of the substance can be described as the mass of the substance per unit volume. The…
Q: A glass weighs 50.915 g in air and 23.950 g when immersed in water. What is the specific gravity?
A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…
Q: Q1/Prepare 0.1N of CH,COOH in 500 mL, Specific gravity 1.05 gm/cm and percentage 99.5% ?
A:
Q: Average of the following data: 30.2 mM, 30.45 mM, 30.38 mM, 3.05 × 10²M
A: Calculate average of the given data ---
Q: fat sample with combination of acids contain standard hydrochloric acid for blank and sample with…
A: Saponification : The process in which fats, oils, or lipids are converted into saop and alcohol by…
Q: 1-4 ture @ 26.1°C, 24.6g of camphor (LiothG0), a nunvolatile solid, is dissohved in The of benzene…
A:
Q: High pressure liquid chromatography (HPLC) is a method used in chemistry and biochemistry to purity…
A:
Q: Calculate the specific volume, α (cm3/gm), using the following equation and the values of constants…
A:
Q: According to this graph, which diffusion is faster at the temperature indicated by the vertical…
A: We are given Diffusion(m2/s) versus Temperature(K)*1000 graph. For a particular temperature value,…
Q: The pressure in a constant volume thermometer is 0.800 x 102 Pa at 400 K and 0.600 x 105 Pa at 300…
A: Gay-Lussac’s Law: According to Gay-Lussac’s law, if we increase the temperature of the ideal gas the…
Q: 11 1 10 9 8 00 4 T 7 6 5 ppm 4 C,H,O,N M.Wt = 139 13 3 2 1 0
A: The given spectrum is of 2-nitrophenol where in principle there are 4 chemically non-equivalent…
Q: Ethyl alcohol (C2H5OH) may be prepared by the fermentation of glucose (C6H12O6) as indicated by the…
A:
Q: Some experts says that km can be calculated by saying Vmax from date divided by 2 and then they find…
A: We can calculate the approximate value of Km both from the graph and by solving the MM equation.
Q: ormality of 100 mL of 1.17% (w/v) Čačl2 is 0.812 N 0.212 N 0.106 N
A: Normality is number of gm equivalent present in 1000ml of solution. nfactor for salt is charge on…
Q: A student sets up the following equation to convert a measurement. (The ? stands for a number the…
A: Please find your solution below : 1 Pa = 10-3 Pa I cm3 = 10-6 m3 Therefore, 87 Pa cm3 = 87×10-3×10-6…
Q: ass is produced by casting. Pressure of the D00 Pa) by placing in a vacuum oven and te he same time.…
A: Now, K=-1vdvdpTB=-1vdvdTp dvv =-Kdp+BdT
Q: = 0.80, K- ? t units and sig. figs.:
A:
Q: What is the mean (average) value for the following data: 25.12, 25.29, 24.95, and 25.55?
A: Given numbers are 25.12, 25.29, 24.95 and 25.55 To calculate mean, we can use the formula given…
Q: Fill in the blanks: 1. This is the SI unit of one (1) Pascal (Pa) 2. 1 lb/in2 =_ Pa 3. 105 N/m2 =…
A: Pascal (Pa), mm Hg, bar, atm, psi all units are used for measurement of pressure.
Q: . What are the Km and Vmax values b
A: Enzymes are biological catalyst with take part in various biological processes in living beings.…
Q: 1: What is the density (g/ml) of a 3.6M Sulfuric acid solution that is 29% H2S04 mass (Mwt. = 98)?…
A:
Q: Coming homo after the end of the winter semostor, you find that your family's swimming pool has not…
A: Solution - According to the question - Given - take whole swimming pool as a control volume. given…
Q: A student performed the experiment described in this module, using 7.00 mL of a 1.8% H2O2 solution…
A: First calculating the H2O2: 1.8% H2O2 solution means 1.8 g H2O2 in 100 ml of watermass in 7 ml = 1.8…
Q: 10. JY is a 58-year-old male hospitalized for a total knee replacement. He was given unfractionated…
A: The desired dose is 2 mcg/kg/min.
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 1 images
- For a given liquid a plot of the lnP versus 1/T gives a straight line with a slope of -4606 K.What is the ΔHvap of this liquid?10.11/ A 1.5-kg specimen of a 90 wt% Pb-10 wt% Sn alloy is heated to 250°C (480°F), at which temperature it is entirely an a-phase solid solution . The alloy is to be melted to the extent that 50% of the speci- men is liquid, the remainder being the a phase. This may be accomplished either by heating the alloy or changing its composi- tion while holding the temperature con- stant. (a) To what temperature must the speci- men be heated? (b) How much tin must be added to the 1.5-kg specimen at 250°C to achieve this state? 10.15) A magnesium-lead alloy of mass 5.5 ka consists of a solid a phase that has a compo- sition that is just slightly below the solubility limit at 200°C (390°F). (a) What mass of lead is in the alloy? (b) If the alloy is heated to 350°C (660°F). how much more lead may be dissolved in the a phase without exceeding the solubility limit of this phase? 10.27 A hypothetical A-B alloy of composition 55 wt% B-45 wt% A at some temperature is found to consist of mass…For a given liquid a plot of the lnP versus 1/T gives a straight line with a slope of -2829 K.What is the ΔHvap of this liquid? Your answer should be in kJ/mol and have 3 sig figs
- At what pressure does the mean free path of krypton (Kr)atoms (d = 3.16 × 10-10 m) become comparable with thediameter of the 1-L spherical vessel that contains them at300 K? Calculate the diffusion constant at this pressure.Convert the pressure of a substance into its “concentration” in mol L . Show how d[A]/dt is equal to dPA/dt multiplied by a constant. (Assume ideal behavior and that T is constant)1. What is the apparent hard-sphere diameter of CO2 at 0°C? The viscosity of CO2(g) at 1 atm and 0°C is 139 μP (micropoise). 2. When equal amounts of hydrogen, H2, and iodine, I2, are mixed together at a total pressure of 1 bar, the partial pressure of hydrogen iodide, HI, vapour produced from by the reaction H2(g) + I2(g) ⇌ 2 HI(g) is 22.8 kPa. Calculate the equilibrium constant for the reaction. 3. The equilibrium constant for the reaction 2HCl(g) + O2(g) ⇌ H2O(g) + Cl2(g) is 13300 at 400 K and 429 at 500 K. Use the van't Hoff equation to determine the standard enthalpy of reaction.
- Polyethylene glycol 400 (PEG400) is a nonvolatile liquid polymer, which when mixed with water canbe used as a base for parenteral formulations. The designation “400” means that the molecular weightof PEG molecules is approximately 400 g/mol. Preparation with water (ΔHv = 40.7 kJ/mol) requires that the two be mixed at 56 oC, at which the equilibrium vapor pressure of pure water is 16.5 kPa. a. If 105 g of PEG400 are added to 500 g of water at 56 oC, what will the boiling temperature of the solution be?What is the diffusion coefficient of a membrane-bound protein of molar mass 79,300 daltons at 37°C if the viscosity of the membrane is 1 poise (0.10 N-s-m-2)? Assume that this protein is an unhydrated, rigid sphere that has a density of 1.4 g-cm-3. 4.0 8.05e-12 x m².s-1 What is the average distance traveled by this protein in 2.3 s? 4.0 6.085e-6 x Å1. "Band structure" of "Hatom chain" and "H mole chain" are drawn as "graphs" and "intermediate process". Describe it in detail.