1000 mg of granular salt is briefly stirred into a glass container of 1/4 liter volume filled with water. After briefly mixing, some salt is still seen at the bottom of the glass. The undissolved salt is filtered from the water, weighed and determined to have a mass of 200 mg. What is the dissolved phase concentration of salt remaining in the water? Provide your answer to the nearest whole number in units of mg/l.

1000 mg of granular salt is briefly stirred into a glass container of 1/4 liter volume filled with water. After briefly mixing, some salt is still seen at the bottom of the glass. The undissolved salt is filtered from the water, weighed and determined to have a mass of 200 mg. What is the dissolved phase concentration of salt remaining in the water? Provide your answer to the nearest whole number in units of mg/l.

Introductory Chemistry: An Active Learning Approach

6th Edition

ISBN:9781305079250

Author:Mark S. Cracolice, Ed Peters

Publisher:Mark S. Cracolice, Ed Peters

Chapter2: Matter And Energy

Section: Chapter Questions

Problem 61E: The photograph below shows a beaker of water and a sugar cube, the combined mass of which is...

See similar textbooks

Similar questions

A student dissolves 12.4g of ammonium nitrate (NH4NO3) in 200.g of water in a well-insulated open cup. She then observes the temperature of the water fall from 21.0°C to 16.9°C over the course of 7 minutes. NH4NO3(s) → NH+4(aq) + NO−3(aq) You can make any reasonable assumptions about the physical properties of the solution. Be sure answers you calculate using measured data are rounded to 2 significant digits. Note for advanced students: it's possible the student did not do the experiment carefully, and the values you calculate may not be the same as the known and published values for this reaction. 1. Is this reaction exothermic, endothermic, or neither? 2.If you said the reaction was exothermic or endothermic, calculate the amount of heat that was released or absorbed by the reaction in this case. = kJ 3.Calculate the reaction enthalpy ΔHrxn per mole of NH4NO3. = kJ/mol
he Don Juan Pond in Antarctica has one of the highest salt concentrations of any natural body of water on Earth. Even though it is in one of the coldest places on the planet, it almost never freezes due to this high salt content. The density of the pond water averages 1.3 g/mL. a.) Calculate the mass (in grams) of 1 gallon of water from the Don Juan Pond. b.) The dissolved salts are dominated by calcium chloride and the pond water is 44% salt by mass. What is the mass (in grams) of the salt in 1 gallon of the pond water? c.) If the salt is all CaCl2, what would be the molarity of the pond water?
The mass of a beaker is 5.333 g. After 5.00 mL of a concentrated hydrochloric acid solution is pipetted into the beaker, the combined mass of the beaker and the hydrochloric acid sample is 11.229 g. From the data, what is the measured density of the hydrochloric acid solution?
At 20oC 25.0 ml of concentrated nitric acid solution was found to have a mass of 32.503 g. What is the calculated density of this solution at 20oC? Show your calculation set-up and result using correct significant figures and proper units
A sailor on a trans-Pacific solo voyage notices one day that if he puts 735.mL of fresh water into a plastic cup weighing 25.0g, the cup floats in the seawater around his boat with the fresh water inside the cup at exactly the same level as the seawater outside the cup (see sketch at right). Calculate the amount of salt dissolved in each liter of seawater. Be sure your answer has a unit symbol, if needed, and round it to 2 significant digits. You'll need to know that the density of fresh water at the temperature of the sea around the sailor is 0.999/gcm3. You'll also want to remember Archimedes' Principle, that objects float when they displace a mass of water equal to their own mass.
An aqueous hydrochloric acid solution contains 65.0g hydrochloric acid in 500.0 ml solution. What is the chemical equivalents of the solution? What is the equivalent weight of the solution?
*Density of toluene 0.86g/mL Calculate the volume of toluene needed to make 50 mL of a 780 micrograms /mL solution. Round to the nearest microliter.
A student weighed a wet 10-mL graduated cylinder. The cylinder contained at least 0.5 mL of water when weighed. Next, the student added sodium chloride solution to the cylinder until the bottom of the meniscus read 5.0 mL. How will the 0.5 mL of water affect the calculated density of the sodium chloride solution? Justify your answer with an explanation.
Using the data below (included for context), what is the equation for the trendline for the data points that fall in the linear range (linear range was found to be timepoints 1 min to 4 min,)? Your answer should be in the form of y = mx + b. Make sure that your trendline only includes the data points that fall in the linear range. In order to determine the trendline using Excel, you may need to create a new graph that only includes the earlier data points. With your new trendline, what is the initial velocity when 1 nM OXA-M290 is mixed with 60 μM nitrocefin? Make sure to include units in your answer. Context: DO NOT ANSWER Concentration of hydrolyzed nitrocefin at 20 time points. Graph attached below Time (min) Concentration (μM) 0.5 6.01 1 11.78 1.5 17.6 2 23.51 2.5 29.58 3 35.31 3.5 39.73 4 44.5 4.5 48.18 5 50.05 5.5 52.72 6 54.01 6.5 55.06 7 55.65 7.5…
Infusion Rates for Dextrose (D5W). A 5% dextrose solution (mg per 100 mL of solution ) is given intravenously. Suppose a total of 1.5 L of the solution is given over a 12-hour period. a. What is the flow rate in units mL/hr? In units of mg (of dextrose)/hr b. If each milliliter of the solution is equivalent to 15 drops (this drop factor is expressed as 15 gtt/mL, where the abbreviation gtt comes from the Latin guttta, for drop), what is the flow rate in units of gtt/hr? c. During the 12-hour period, how much dextrose is delivered? I do not have the answers for this. Answer this as best as you can. This is for Math 140 Statistic and Probability. Please watch grammar, do not leave words out, use short answers. Thank you.
Specific gravity is important for diagnosing various health conditions, such as dehydration. The normal specific gravity falls between 1.002 - 1.030. Mild dehydration is indicative from specific gravity that is greater than 1.010 and the higher the value the more dehydrated one may be. A 25 year old female patient wastaken to the hospital with symptoms of extreme thirst, fatigue, and headaches. An 0.0077 liter urine sample was taken for the patient described above. The sample had a mass of 8.05 grams.
In an alternate reality, the following salinity vs. density information was collected and summarized below. Based on this data, calculate the salinity of a solution that has a density of 1.017 g/mL. Enter your answer with at least 3 significant figures. Salinity (g/mL) Density (g/mL) 0.00 0.983 20.00 0.998 50.00 1.020 100.00 1.057 150.00 1.095