18 V Use the step-by-step method to find v, (t) for t> 0 in the given circuit. 3k0 ww 6k0 200 uF 3 k

Q: A coil of inductance 100 mH and resistance 800 ohm is connected in parallel with a variable The…

A: Given data, L=100 mH R=800 ohm V=12V f= 50Hz  C=? Zdynamic=? I=? Q- factor = ?

Q: Calculate the value of stored energy in an inductor if the value of inductance is 10 mH and 2 mA of…

A:

Q: Compute V

A:

Q: For a given op amp, CMRR = 107 and differential gain = 108. What is the common mode gain of Op-Amp.…

A: Given: An op-amp with, CMRR=107 Differential gain, Ad=108 Common mode gain, Acm=?

Q: Delta modulation uses bits per sample. a) One b) Two c) Four d) Eight

A: Given  Delta modulation uses.....bits per sample.

Q: 1. 2. A wire carries a steady current of 2.00 Amp over a period of 600 ms. What total charge passes…

A:

Q: Delta modulation uses a) One b) Two c) Four d) Eight bits per sample.

A:

Q: A full Wave rectifier shown in the circuit has 120V (rms) 50 Hz input through a transformer. RL = 2k…

A: Given: Input at primary of transformer, Vprms=120 V RL=2 kΩ

Q: Ex For the circuit shown below; if the input voltage is a sinusoidal wave, sinusoidal wave, find the…

A:

Q: Interrelate and differentiate Transient response , Steady State response and stability

A:

Q: Solve for the Norton equivalent current (in Ampere) at terminals a and b, if R=1.30. (Use 3 decimal…

A:

Q: If F (s) = L {f(t)} and f" (t)+3f' (t) + f(t) = 28 (t), where f' (0-) = f(0) = 0, ti f" (t) + 3f'…

A:

Q: SP₂ SP₁ PV 8 6 4 2 A B 10 5 15 20 Figure 3 Process responses from a pressure control loop Time (s)…

A:

Q: For how many hours can a battery deliver 2 A if it is rated at 70 Ah? 30 25 40 35

A: Given data, Rating of battery = 70 Ah Current flowing through battery i = 2 A

Q: 3. A balanced three-phase Y-connected source has a line voltage of 208 V feeds two balanced…

A:

Q: Q1. A station started broadcasting on the commercial AM system with the frequency 600 kHz, while a…

A:

Q: Two balanced, parallel connected loads are connected to a 50 Hz, 300 V, three-phase supply. The…

A:

Q: QUESTION 3 w much current flows thr R1 + dc(5) 4500

A: Given data, Circuit diagram is given as,

Q: Find the line current, shaft speed, load torque, induced torque, and rotor frequency of an induction…

A:

Q: Problem: A 250 resistor is connected inductance in parallel with an of 2.5 mH across a Vrms = 75<0°…

A:

Q: A JFET is also called ...... 1. unipolar 2. bipolar 3. unijunction 4. none of the above transistor

A: JFET( Junction gate field effect transistor) is a three-terminal semiconductor device used as a…

Q: 22. This is the product of an applied force in a certain area of fluid. a. energy b. work c. power…

A: Force: Force is a physical quantity that can change the motion of an object. It is denoted by 'F'.…

Q: A suggested amplifier has an 8dB noise figure, a noise bandwidth of 1MHz and an input resistance of…

A:

Q: The figure below shows three resistors (R- 13.5 0, R -7.95 0, and Ry- 12.5 0) and two batteries…

A: Given- Source voltage= 40 V and 22 V Resistance = 13.5 ohm, 7.95 ohm, 12.5 ohm To find- Current in…

Q: Usts. 2-t, 1≤t≤2 x(t) = = be a periodic signal with fundamental period T = 2 and Fourier…

A:

Q: LVDT produces an rms output voltage of 5.0 V for displacement of 3.5 mm. Calculate the sensitivity…

A: We have been given an LVDT transducer which produces the, Output Voltage = 5.0 V Displacement = 3.5…

Q: A 50μF capacitor initially charged to 125V is discharged across a series combination of a 1k0…

A: A 50 μF capacitor initially charged to 125 V. Resistor R= 1K-ohm Capacitor210 micro farad Find…

Q: A 25 µF (25E-06 F) capacitor is connected in parallel with an 90 resistor across a Vrms = 230<0° V,…

A: Given  R = 90 F = 60 Hz C = 25 microF

Q: Write a Note on use of ODE in solving series RL circuit. Using Kirchhoff's voltage law find ordinary…

A: Given data: The constant voltage V=5 V Resistance R=50 Ω Inductor L=1 H Initial current i=0 A

Q: A series circuit of resistance 60 2 and inductance 75 mH is connected to a 110V, 60 Hz supply.…

A: From the question, it is given thatResistance=60 ΩInductance=75 mHVoltage=110VFrequency=60 HzWe have…

Q: gain (G₁) = 60 dB; A= 105, BW= 5KHZ₂ f₁ = 1 MHZ ; Ri= 1 Mr and Ro=702, find @ Rof @ Rif 50 кл H.W₁:…

A:

Q: Q2: Assume a sinusoidal signal with a frequency of 3.5 kHz and maximum amplitude of 1v. Then this…

A: Given data, fm=3.5 kHz, Am=1 VRb=15 kbps

Q: Find v for t>0. 30 V 12 V | 12+ 16e-0.25t O 4 + 6e-0.25t Ο 4 - 6e-0.25t 1=0 O4 +6e-4t 6Ω 3 Ω v- 2F

A: Electrical circuit:- It provides the path to current flow. A valid circuit satisfies Kirchhoff's…

Q: A 3-phase, 4-wire system supplies an unbalanced load. The positive and the negative sequence…

A:

Q: B) 6 pole alternator running at 1000 r.p.m. supplies an 8 pole induction motor. What is the actual…

A:

Q: solve this

A: We have to find the Laplace transform of e-atcosωtLcosωt=ss2+ω2We will use the complex shift…

Q: A series RLC circuit has C=12.5mF and L= 2.22 H. What value of resistance will make the circuit…

A:

Q: 2. The de source supplying a single-phase inverter with is 99 V. The load is an R. L series…

A: Given information about a PWM controlled single phase inverter is, DC supply voltage Vdc=99 Volts.…

Q: a current element J.dv is measured in terms of

A: given current element J.dv

Q: A transformer has a rated output of 200 kVA at a power factor of 0.8. Determine the rated power…

A: Rated output of transformer=200 kVAPower factor=0.8We have to find the rated output power and…

Q: Section 2.2: The Inverting Configuration 2.7 Assuming ideal op amps, find the voltage gain v/v, and…

A: Given data, Circuit diagram is given as,

Q: QUESTION # 05 A shunt motor on a 240 V line has an armature current of 75 A. If the field circuit…

A: Given data, Terminal voltage V = 240 V Armature current ia=75 A Field resistance Rsh=100 Ω

Q: Match the measuring equipment with the parameters it measures. Prompts Ammeter Voltmeter Ohmmeter…

A:

Q: QUESTION # 05 A shunt motor on a 240 V line has an armature current of 75 A. If the field circuit…

A: Given:- Voltage V=240 V Armature current Ia=75 A Field resistance Rsh=100 Ω We have to find field…

Q: But what precisely is meant by the term "digital audio"? The procedure through which analog sound…

A: Analog to digital converter : Analog signals get converted into digital signals. amplitude…

Q: 2.. plot. > Given the following transfer function for K. G(s)H(s), how many branches will be in the…

A:

Q: 11. Pulse code modulation is preferred to PAM because of ______________. 12. Most FDM telemetry…

A: Pulse code modulation is preferred to PAM because of ______________.12. Most FDM telemetry systems…

Q: (b) How long can a 205-W television set be on before using more than 4 kWh of energy?

A: Given data, For a television P=205 WE=4 kWh

Q: 15. A 100-pcs Christmas light, each with 1 ohm are arranged in a parallel circuit, and is plugged in…

A: When n resistors of resistance R are connected in series, then total resistance, RT = nR In case of…

Q: A 240 V, 4 pole wave wound dc shunt motor has 600 conductors on its armature. It has an armature…

A: Given, A DC shunt motor has V=240 VP=4 A=2  wave woundZ=600Ra=0.7 ΩE=210 Vϕ=10 mWb

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.