42 Switch S in Fig. 27-43 is closed at stime t = 0, to begin charging an initiallyuncharged capacitor of capacitanceC = 17.5 µF through a resistor of resis-tance R = 35.0 22. At what time is theRCpotential across the capacitor equal to Figure 27-43 Problemsthat across the resistor?42 and 43.

Given data as per question R = 35ohm C = 17.5micro farad

#2 Switch S in Fig. 27-43 is closed at ime t=0, to begin charging an initially uncharged capacitor of capacitance C= 17.5 µF through a resistor of resis- Cance R = 35.0 22. At what time is the potential across the capacitor equal to Figure 27-43 Problems that across the resistor? 42 and 43. 251 רw R 'C

#2 Switch S in Fig. 27-43 is closed at ime t=0, to begin charging an initially uncharged capacitor of capacitance C= 17.5 µF through a resistor of resis- Cance R = 35.0 22. At what time is the potential across the capacitor equal to Figure 27-43 Problems that across the resistor? 42 and 43. 251 רw R 'C

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter21: Circuits And Dc Instruments

Section: Chapter Questions

Problem 33CQ: Draw two graphs of charge versus time on a capacitor. Draw one for charging an initially uncharged...

See similar textbooks

Similar questions

Referring to Figure CQ21.4, describe what happens to the light-bulb after the switch is closed. Assume the capacitor has a large capacitance and is initially uncharged. Also assume the light illuminates when connected directly across the battery terminals.
Figure 21.55 shows how a bleeder resistor is used to discharge a capacitor after an electronic device is shut off allowing a person to work on the electronics with less risk of shock, (a) What is the time constant? (b) How long will it take to reduce the voltage on the capacitor to 0.250% (5% of 5%) of its full value once discharge begins? (c) If the capacitor is charged to a voltage V0through a 100-O resistance, calculate the time it takes to rise to 0.865V0(This is about two time constants.)
€22. Verify, as was concluded without proof in Example 23.7, that units of
Integrated Concepts If you wish to take a picture of a bullet traveling at 500 m/s, then a very brief flash of light produced by an RC discharge through a flash tube can limit blurring. Assuming 1.00 mm of motion during one RC constant is acceptable, and given that the flash is driven by a 600F capacitor, what is the resistance in the flash tube?
An electronic apparatus may have large capacitors at high voltage in the power supply section, presenting a shock hazard even when the apparatus is switched off. A “bleeder resistor" is therefore placed across such a capacitor, as shown schematically in Figure 21.50, to bleed the charge from it after the apparatus is off. Why must the bleeder resistance be much greater than the effective resistance of the rest of the circuit? How does this affect the time constant for discharging the capacitor?
Using the exact exponential treatment, determine how much time is required to charge an initially uncharged 100-pF capacitor through a 75.0-M resistor to 90.0% of its final voltage.
Integrated Concepts Use the ECG in Figure 20.34 to determine the heart rate in beats per minute assuming a constant time between beats. Figure 20.34 A lead II ECG with corresponding arterial blood pressure. The QRS complex is created by the depolarization and contraction of the ventricles and is followed shortly by the maximum or systolic blood pressure. See text for further description.
Regarding the units involved in the relationship t = RC, verify that the units of resistance times capacitance are time, that is, . F = S.
Using the exact exponential treatment, find how much time is required to discharge a 250-? capacitor through a 500- resistor down to 1.00% of its original voltage.
Consider the circuit in Figure 21.29 and assume the batter has no internal resistance. (i) Just after the switch is closed, what is the current in the battery? (a) 0 (b) /2R (c) 2/R (d) /R (e) impossible to determine (ii) After a very long time, what is the current in the battery? Choose from the same choices.
In places such as hospital operating rooms or factories for electronic circuit boards, electric sparks must be avoided. A prison standing on a grounded floor and touching nothing else can typically have a body capacitance of 150 pF, in parallel with a foot capacitance of 80.0 pF produced by the dielectric soles of his or her shoes. The person acquires static electric charge from interactions with Ills or her surroundings. The static charge flows to ground through the equivalent resistance of the two shoe soles in parallel with each other. A pair of rubber-soled street shoes can present an equivalent resistance of 5.00 103 M. A pair of shoes with special static-dissipative soles can have an equivalent resistance of 1.00 M. Consider the persons body and shoes as forming an RC circuit with the ground. (a) How long does it take the rubber-soled shoes to reduce a persons potential from 3.00 103 V to 100? (b) How long does it take the static-dissipative shoes to do the same thing?
When discharging a capacitor, as discussed in conjunction with Figure 21.39, how long does it take for the voltage on the capacitor to reach zero? Is this a problem?