2. A single coloumn manometer is connected to a pipe containing a liquid of specific gravity 0.75. Find the pressure in the pipe if the area of reservoir is 250 times the area of tube for the manometer reading. The difference in mercury level is 40 cm. On the left limb the fluid is upto the height of 20 cm. a) 10.42 N/cm² b) 5.21 N/cm? c) 2.60 N/cm²

2. A single coloumn manometer is connected to a pipe containing a liquid of specific gravity 0.75. Find the pressure in the pipe if the area of reservoir is 250 times the area of tube for the manometer reading. The difference in mercury level is 40 cm. On the left limb the fluid is upto the height of 20 cm. a) 10.42 N/cm² b) 5.21 N/cm? c) 2.60 N/cm²

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

diameter = 60 cm height = 60 cm The CLOSE cylindrical tank is two-thirds full of water. It is subjected to pressure = 10 kpag. Considering that the tank is to rotate about the axis at the center at 10 rad/s a. What is the pressure at point C? b. What is the pressure at point D?
A pressure gage at Elev.8.00m on the side of a tank containing a certain liquid reads 57.4kPa, while a second gage at Elev.5.00m reads 80kPa. What is the specific weight of the liquid in kN/cu.m?
A cylindrical tank 2m in diameter and 15 meters high is filled with liquid Z. A pressure gage at elev 10 m at the side of the tank reads 105 kPa. another gage at elev 6m reads 138 kPa. compute the (a) specific weight of the liquid and (b) density of the liquid.
The system in Fig. P2.48 is open to 1 atm on the right side. (a) If L = 120 cm, what is the air pressure in con tainer A? (b) Conversely, if Pa = 135 kPa, what is the length L?
A reservoir contains water has a vertical circular orifice 25.2mm diameter and is first plugged up to measure any displacing force, the tank is suspended in a particular way. The horizontal force is required to keep the tank in place on the removal of the plug. The opposite applied force to the orifice is 16.8N. The volume per time was found as 141lt/minute. It is assumed that the level of the water is maintained at a constant height of 2.785m above the orifice. Calculate Cc, Cv, and Cd for the orifice.
Q1(b) Water flows through a pipe with a diameter of 2 m. Stagnation and static pressures measured by pitot tube are 0.3 m and 0.25 m of water, respectively. Calculate the velocity of flow
(50m x 50m) swimming pool. The pool is 2m deep and pumps maintain a slow, steady horizontal flow within the basin at 2 cm/s. Please calulate the Reynolds number and Rossby numbers.
Based on the provided differential-type manometer, calculate the difference in the pressure between points A and B (as in Δp = pA - pB = ?). SG of oil is 0.8
A vertical conduit is carrying oil (S = 0.95). A differential mercury manometer is tapped into the conduit atpoints A and B. Determine the difference in pressure between A and B when h = 3 in. What is thedifference in piezometric head between A and B?
A 4.1 m diameter tank having equal layers of water, oil(SG=0.87), and another liquid with SG=1.74, with each layer is 0.84 m in height is being observed. Find the gage pressure(in kPa) at the bottom of the oil layer.
Based on the provided differential-type manometer, calculate the difference in the pressure between points A and B (as in Δp = pA - pB = ?).
A tank containing water moves horizontally (parallel to length) with a constant linear acceleration of 3 m/s2 . The tank is 3 m long and the depth of water when the tank is at rest is 1.5 m. FIND THE FOLLOWING: A. what angle (degrees) does the water make during acceleration? B. what is the minimum height of the vessel for no spilling of water? C. what is the maximum pressure head? (m)