2. Two composites are produced; one composite contains 30 vol% SiC particles, while a second contains an equal amount of SiC but in the form of fibers. Which will have the higher heat capacity? Will heat capacity be dependent on the orientation of the fibers?

2. Two composites are produced; one composite contains 30 vol% SiC particles, while a second contains an equal amount of SiC but in the form of fibers. Which will have the higher heat capacity? Will heat capacity be dependent on the orientation of the fibers?

Chemistry by OpenStax (2015-05-04)

1st Edition

ISBN:9781938168390

Author:Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark Blaser

Publisher:Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark Blaser

Chapter5: Thermochemistry

Section: Chapter Questions

Problem 52E: Before the introduction of chlorofluorocarbons, sulfur dioxide (enthalpy of vaporization, 6.00...

See similar textbooks

Related questions

Q: Which of these alcohols will react the fastest in hot conc. sulfuric acid ? ОН О OH ОН ОН ОН

A: Alcohol gives dehydration reactions when they react with a strong acid like H2SO4 or H3PO4 to form…

Q: 4PH3 ->> P4 + 6H₂ In a previous step, you calculated the rate of disappearance of PH3 at 6.67 x 10-3…

A: Given reaction: 4PH3 → P4 + 6H2 The rate of disappearance of P4 = 6.67 × 10-3 M/s

Q: Give good hand written explanation Asap What volume of concentrated hydrochloric acid solution…

A: Given that - Number of moles of hydrochloric acid solute = 2.1 mol We know that most Concentrated…

Q: Which of the following statements is false? The rate of a first order reaction is dependent…

Q: A microwave oven uses electromagnetic waves at a wavelength of 2.0 x 10*¹ cm (centi-meter) to heat…

Q: 11. Using the Debye-Hückel limiting law, calculate the value of the mean activity coefficient at…

A: d is correct answer. see below

Q: Predict the relative intensities of the M and M+2 for the following compound. Choose the approximate…

A: Here we are required to find relative intensity of M and M+2 for the following compound.

Q: A 10 g sample of Mg504 · 7H₂0 (246.489/mol) was heated in an oven at 105 °C until evaporated all the…

Q: When a metal leaf electroscope is charged by contact with a negatively charged rod: Oprotons move…

A: An atom consists of protons and neutrons present inside the nucleus and electrons revolve around…

Q: explain what the results of this experiment are and the purpose Table 2 Absorbance vs CoCl2…

A: Purpose of the experiment is to draw the calibration curve from standard data , to know then find…

Q: Find the molar solubility of calcium fluoride in a solution containing 0.70 M Ca(NO3)₂(aq). a.…

A: Check the Ksp value for CaF2 and using that find out molar solubility

Q: HO name of this compound? ethoxyphenol ОС

Q: 0.3872g of an unknown weak acid with general formula HY, was dissolved in water and made up to a…

Q: Calculateur (298.15 K, 1 bar) for nitrogen in air, assuming that the mole fraction of N₂ in air is…

Q: O Na₂Cr₂O7 in H₂SO4 O NaOH in H₂O O NaBH4 O H₂O in pyridine O NaNO₂ in HCI NH₂

A: When aniline is treated with NaNO2 in acidic medium, diazonium salt is formed.

Q: Propose the major product for each of the following reactions and propose a reaction mechanism for…

Q: What's More (PORTFOLIO OUTPUT #52) Directions: Cite the use of the given polymers. Write your answer…

Q: Give the major force between acetone and chloroform. dipole-dipole dispersion…

Q: A group of galvanic cells a(n)... a) Battery b) Voltaic Cell c)Sickle Cell

A: This question is related to electrochemistry, a branch of chemistry dealing with interconversion of…

Q: 4. Answer the following questions based in the scheme below: (i) Determine the principle involved in…

A: Here we have to synthesize the following given compound from the given starting material through…

Q: a-Lipids are organic compounds found in every type of plant and animal cell. They always contain the…

A: Lipids are a broad category of chemicals that are mostly nonpolar in nature. This is due to the fact…

Q: What product is formed when the compound below is treated with sodium hydride followed by…

A: When 2-butanol is treated with sodium hydride then due to removal of Hydrogen, sodium isobutoxide is…

Q: Planck regarded his theory as applying only to material oscillators, such as those in a solid which…

A: Planck's law describes the spectral density of electromagnetic radiation. These radiations are…

Q: What is the mol fraction of ethanol, C 2H 5OH, in a solution of 75.3g of ethanol and 525g of water?…

A: Number of moles is calculated by dividing the given mass with molecular mass.

Q: 1. a) When calcium forms a compound with chlorine, electrons are transferred from the atom to the…

Q: What is the total enthalpy of formation of the products Inh = 16 (-394) + 18 (-286) =

A: Total enthalpy of formation of products in : 16(-394) + 18(-286) = ?

Q: Question 1 Which combination results in the formation of a precipitate? O aqueous ammonium carbonate…

A: We have to tell among the given combinations, which one results in the formation of a precipitate.…

Q: Ammonia (NH3) chemically reacts with oxygen gas (0₂) to produce nitric oxide (NO) and water (H₂O).…

Q: Name the following compounds show work/annotate TUTTIG MG Tuning compe SHUTE TURV asr a. b. d. A +…

A: #(a): While giving IUPAC name to an organic compound, we follow the below rules: #1. Identify the…

Q: Planck regarded his theory as applying only to material oscillators, such as those in a solid which…

A: The German physicist, Max Planck, discovered laid the foundation for Planck's quantum theory and his…

Q: The following reaction is possible using a 4-step synthesis (putting 4 reaction schemes together in…

Q: Find Cas/aT) in terms of measurable. Properties CP-V-T)

Q: Select the functional groups that are present in the molecule shown below (more than 1 app NH₂ Ether…

Q: Which statement describes the electroanalytical techniques? The electroanalytical methods can…

A: Redox reactions can be defined as the reactions in which both oxidation and reduction reactions…

Q: Which labeled atom will most likely react when acetic acid is treated with sodium hydroxide? Ο Α

Q: Devise a general method for determining the fractional abundances of two or more isotopes from a…

A: Since you have asked multiple questions questions, we will solve the first question for you. If you…

Q: Planck regarded his theory as applying only to material oscillators, such as those in a solid which…

A: Planck regarded his theory as applying only to material oscillators, such as those ina solid which…

Q: 2N2O5 (aq) → 4NO₂ (aq) + O₂(g) In a previous step, you calculated the rate of disappearance of N2O5…

Q: Q4:- A moving boundary experiment is carried out with a 0.1 mol. L¹ Solution of hydrochloric acid at…

A: In order to solve this problem regarding the moving boundary method, we will need the following…

Q: Hydrofluoric acid, HF(aq), if absorbed through the skin and into the blood, can cause cardiac…

A: Hydrofluoric acid, HF

Q: Which of the following compounds does not exhibit hydrogen bonding? O -NH₂ O O O None of these O…

Q: O=CES H₂O=O CH4 CHIL H-CC-H

Q: Consider the reversible reaction at 2000°C, 2NO(g) + O₂(g) + N₂(g) If the system initially contains…

A: Chemical equilibrium is defined as the stage at which both reactant and product are in equilibrium.

Q: correct name for this molecule is: OH

Q: A precise chemical determination of the composition of fuel which gives, on mass basis, the six…

A: #(a): Volumetric analysis is a quantitative chemical analysis that determines the amount of a…

Q: Given the following information, put the acids in order of increasing strength. Justify (explain)…

A: Acidity is determined by looking acid dissociation const.(Ka) values,so we first need to determine…

Q: Convert between mass and moles of an element. What amount of oxygen, in moles, does 49.8 g 0…

A: Given that, mass of O=49.8 g molar mass of O= 16 g mol-1 moles of O=?

Q: Which reaction would have an increase in entropy? a. 2 NH4F (aq) + BaS (aq) → (NH4)2S (aq) +…

A: -> ∆S(gas)>∆S(liquid)>∆S(solid) ->If number of gaseous species in product increases then…

Q: Complete the following reaction schemes by choosing the correct product, starting material, and/or…

Q: Question 1 Evaluate: a) (YY) b) (x + √2Y9|Yº - √2Y9) c) (Y3|Y4+ √13Y3)

Question

2. Two composites are produced; one composite contains 30 vol% SiC particles, while a second
contains an equal amount of SiC but in the form of fibers. Which will have the higher heat
capacity? Will heat capacity be dependent on the orientation of the fibers?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Applications of Statistical Thermodynamics

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

At 1 atm, how much energy is required to heat 85.0 g H2O(s) at −12.0 ∘C to H2O(g) at 121.0 ∘C? Use the heat transfer constants found in this
At 1 atm, how much energy is required to heat 95.0 g H2O(s)] at −14.0 ∘C to H2O(g) at 115.0 ∘C? Use the heat transfer constants.
Two iron bolts of equal mass—one at 100.°C, the other at 55°C—are placed in an insulated container. Assuming the heatcapacity of the container is negligible, what is the final tempera-ture inside the container (c of iron =0.450 J/g.K)?
At 1 atm, how much energy is required to heat 75.0 g H2O(s) at −14.0 ∘C to H2O(g) at 123.0 ∘C? Use the heat transfer constants found in this table.
2 A cube of iron was heated to 70 oc and transferred to abeaker containing 100 g of water at 20 oc. The final temperature of the water and the iron was 23 oc. What are (a) theheat capacity, (b) the specific heat capacity, and (c) the molarheat capacity of the iron cube? Ignore heat losses from theassembly.
3 Calculate ∆G for the process during which 10 mmol He(g) which initially occupies a volume of 500 cm3, expands isothermally to a final volume of 5 dm3 at 298.15 K.
The heat of combustion of carbon, hydrogen and sucrose are 394.82, -289.28 and -5665.8kj/mol resp. What is the enthalpy of formation of sucrose?
Which equation from the formula bank is used to determine the experimental heat (q) in kJ involved when in a combustion reaction of 0.45 g of ethylene (MM = 28.00 g/mol) in an uninsulated device submerged in 100.0 mL of water (density 1.00 g/mL, s = 4.184 J/goC) where the temperature change (DT) is recorded as 12.5oC?
qsystem = -1834.3J, with a mZn = 34.8g (cZn = 0.390J/goC), What is the ∆T given the heat loss?
How logn would it take to convert 100 g Na(s) at 20oC to sodium vapor at 1000oC if heating rate at a pressure of 1 atm is 8 kj/min? Tmelt = 97.8oC Tboil - 883oC CNa(s) = 28.2 J/mol K CNa (l) = 30.8 J/mol K C Na(g) = 20.2 J/mol K Solve by adding all the qs and showing work please, need step by step, and solve on paper!
The specific heat of an unknown liquid is determined using a sample of molybdenum (Mo) with a mass of 35.12g. The Mo is heated to 99.2OC in boiling water, and then transferred to 52.16g of unknown liquid whose temperature is 23.4OC. The final temperature of the Mo-unknown liquid system is 28.9OC. Calculate the specific heat of the unknown liquid. CMo = 0.251 J•g-1•OC-1
Using Kopp's formula, estimate the heat capacity of 2‑methylheptane at 20.0C How much heat is required to heat 8.75 kg of 2‑methylheptane from 18.0 °C to 23.0 °C?