Answered: 2. Two heaters rated 80 W and 100 W…

2. Two heaters rated 80 W and 100 W respectively both rated at 240 V. Find the total power consumed when connected in series.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: in a work environment 50 Hz 220V Find the following hardware in the power system 1. .piece 100W…

A: Given f = 50Hz Vrms =220V Since all the loads work at a rated voltage of the supply we will…

Q: The apparent power for an electric network was measured and found to be 360.6VAL-56.34. Determine…

A: There are two independent questions. We are authorized to answer one question at a time. So we are…

Q: A heater coil rated at 1000 W, 220 V is connected to 110 V line. Power consumed is?

Q: Four identical dry cells with an emf of 1.4 volts and internal resistance of 0.06 ohm each, are…

Q: A 1470 W radiant heater is constructed to operate at 115 V. (a) What is the current in the heater…

Q: Q) Using nodal analysis, find current i, and the power dissipated in the 4-ohm resistor in the…

Q: Calculate the power and voltage of the dependent source in the circuit below.

A: The solution can be achieved as follows.

Q: 2. An electrician uses a clamp-on ammeter and a voltmeter to measure the current and voltage of a…

Q: Compute the percent efficiency of the electrical system of the figure below. Note: Resistors absorbs…

A: Given circuit-

Q: For the network of the figure below, Calculate the true power delivered to the circuit. E - 20 V 20°…

A: In this question we need to find a true power delivered to the circuit.

Q: Consider a source network with internal resistance of 10 ohms. If the maximum power transfer to the…

A: In this question we need to find a value of current source.

Q: Find the resistance and peak current in a 1000 W heater connected to a 220V-AC line.

Q: Determine the Power consumed by the load (Green) when it is connected to a supply voltage of 48Vdc…

Q: 1.By using NODAL ANALYSIS solve the following electric circuit. 202 zi (a)Calculate the current in 4…

Q: I |(1) (2) (3) 10 2 52 V = 100 -<45° ( ww

A: By the complex power analysis

Q: What is the current when resistance is reduced by 50%

Q: For the series-parallel network shown in the following figure, find: (a) the supply current, (b) the…

A: The required parameters can be calculated by using the ohms law and current division rule.

Q: Using Kirchhoff's Law, calculate the current through the 4 ohms resistor of the circuit shown. 15 V

A: The equivalent circuit with assumed direction of current each resistor is shown below: To calculate…

Q: 4. The open circuit voltage across the output terminals of an AC power supply is 15.2 V. When these…

Q: A) The apparent power for an electric network was measured and found to be 360.6VAL- 56.34. 1.…

A: Hello. since you have posted multiple questions and not specified which question to solve. We will…

Q: circuit shown, the value of R such that the power supplied by the 100-volt source is the same as the…

Q: Analyze the following AC networks, define and calculate all voltages, resistances (if necessary) and…

A: Given Here a,b,c,d forms star then we use star to delta connection

Q: Two coils are connected in parallel acros 100-V supply mains take 1OA from the line The power…

Q: Determine the current if the power rating of a particular instrument is 675 W that is connected to a…

A: Given To determine current of an instrument If Power rating, P = 675W Voltage, V = 225V

Q: Question For the series-parallel network shown in the following figure, find: (a) the supply…

Q: Motor Suppose the voltmeter in the circuit shows 20 V, and the conductance of the motor is 25 mS.…

Q: 1.By using NODAL ANALYSIS solve the following electric circuit. 201 1ov E (a)Calculate the current…

Q: For the circuit shown in Figure, find the following a. The magnitude of current in the circuit, I.…

Q: State the purpose and value of the coefficient that relates to the conversion of power output which…

A: Given that the purpose and value of Betz limit needs to be discussed in detail.

Q: 3. Consider an electric circuit shown in the figure below. Determine (a) the current and power…

Q: "Using a series circuit with supply voltage 10V, internal source resistance of 10kohms, what load…

Q: What is the demand factor of the consumer, if the connected load of a consumer is 5 kW and maximum…

A: Given: Connected load is 5 kW Maximum demand is 3 kW

Q: Two coils are connected in parallel across 100-V supply mains take 10A from the line. The power…

Q: 5 Using current division rule, find the source voltage for the circuit shown in figure If Whose 2 =…

A: Network analysis

Q: A circuit takes a current of 3 A at a power factor of 0.6 lagging when connected to a 115 V, 50 Hz…

A: Power is the time rate of change of energy. Its SI unit is watt. Apparent power contains active and…

Q: d) the power delivered by the controlled cur- rent source, e) the total power dissipated in the two…

A: As per your request , I'm gonna solve only sub parts d & e.

Q: a load of a customer is more than the rating of the kWh meter so a current transform with a ratio of…

A: This question belongs to measurements and instrumentation . It is based on the concept of CT .…

Q: Find the equivalent resistor at the terminal of the voltage source then find the power delivered by…

A: Using current division rules.

Q: Q2: For the circuit in figure shown, determine the value of R such that the maximum power delivered…

A: We will use source transformation to find current in RL. power in resistor is I2×R

Q: Find V, in the circuit below using absorbed power and supplied power. Do not use unit in the answer.…

A: Given circuit with voltage sources and elements

Q: An incandecent light bulb has a power rating of 60W. A compact flourescent light (CFL) has a power…

Q: solar

A: Answer Solar panels (also known as "PV panels") are used to convert light from the sun, which is…

Q: From the circuit diagram of power measurement using two wattmeter for delta connected load in…

A: In Wattmeter method, Instrument to measure the current is called?

Q: For the circuit given, the reading on the voltmeter is 49 V and the reading on the ammeter is 9.7…

Q: stion here Draw the important components of a standard power system with a brief description.…

A: In an interconnected grid system multiple power system are connected to supply a load.

Q: An electric boiler has two heating elements each of 230V, 3.5kW rating and contains 8L of water at…

A: Given data: Heating element rating = 3.5 kW Water = 8 L Temperature = 30 deg Loss = 10 % Solution:…

Q: In the circuit shown below, the extermal resistance connected across the terminals of the battery is…

Question

mallery Cf
Suggested Sites
Imported From IE
M Gmail
YouTube
9 Maps
Translate
C1 4
2. Two heaters rated 80 W and 100 W respectively both rated at 240 V. Find the total power consumed when connected in series.
O180 W
O 45 W
O 90 W
O 135 W
« Previous Page
Next Page »
Powered by FlexiQuiz.
prt - Response....pdf

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q 03: Briefly discuss, how the energy consumptions for operations of a fork lifter could be justified. Suppose that a fork lifter has a total energy consumption of 150 W.Hr. The total trips of the vehicle are 375. How the battery duty cycle may be calculated in this case?
please send solution asap
TOPIC: Power Systems, Power Plants & IlluminationINSTRUCTIONS:- Answer in this format: Given, Illustration, Required Conversion, Solution, Final Answer.- Step-by-step solution, do not skip even simple calculations to avoid confusion.- If answered in written form, make sure it is readable.PROBLEM:A 55000-kW thermal plant of National Power Corporation delivers an annual output of 238000000 kw-hr with a peak load of 44 MW. What is the capacity factor? 49.4% 42.4% 48.2% 44.6%
. If a 100 MW coal-fired power plant is replaced by a natural gas plant, what are the before and after annual emissions of: Sulfur dioxide NOx Carbon dioxide https://www.eia.gov/todayinenergy/detail.php?id=44095# (Links para um site externo)
Humble Reqest To solve this. subject Power Transmission and Distribution. a. What are the main components of overhead transmission lines (OHTL)? b. List commonly used conductor materials for OHTL c. List different types of line supports in OHTL? d. List different types of insulators used in OHTL? e. List methods for improving string efficiency?
Suppose a power system consists of two isolated regions: a western region and an eastern region. Five units have been committed to supply 3090 MW as shown below. The two systems are separated by a transmission line that can handle a maximum transfer of 550 MW in either direction. Calculate the spinning reserve for the overall system and for eachregion.
Q2. A) Define only Five items of the following: 1) Load curve, 2) Demand factor, 3) Daily load curve, 4) Plant use factor, 5) Diversity factor, 6) Yearly load curve, 7) Maximum demand, 8) Load factor.
A hydroelectric plant has a reservoir area 28.5 x 10^5 sq. meters and of capacity 5 million cubic meters. The net head of water at the turbine is 60 m. If the efficiencies of turbine and generator are 85% and 95% respectively, calculate the total energy in kWh that can be generated from this station. If a load of 25,000 kW has been supplied for 6 hours, find the fall in reservoir.
Suggested answers: a)hie1= 2.624kohms hie2= 2.624kohms b) ads= 95.27 add= 190.541 c) Acs= 0.3294 acd= 0
Consider a Pumped storage micro-hydel plant is to be built as a Peak load-plant on above mentioned Nathiya-Galli Water Fall with available head of 39 m and average discharge of 5640 m³/hour from the upper pound. The hydraulic efficiency and electrical efficiency of the plant to be 0.86 & 0.92 respectively. Analyze the following output from the above Pumped Storage Plant: a. Hydro-Power and Annual Hydro-energy available b. Electrical Power and annual electrical energy units that can be generated from the plant.
Can you provide clear solution? so i can rate!
2. Given a biomass fuel cell powerplant which has power capacity of 600 kW, and assume it generates at 83% of full power for 40 hours per week, 50 weeks per year. If the installation of the powerplant costs $10 million, and yearly operating costs are $100k, but it saves $400k per year in waste disposal costs, how many years before the powerplant pays back the installation cost? Use the average industrial electricity rate found at https://www.electricitylocal.com/states/california/oxnard/ (