2. When inspecting a transaxle's gears, be Technician A says that a shiny wear pattern on the center of the gear teeth is normal. Technician B says that it is normal for a reverse idler gear to have small chips on its engagement side. Who is correct? A. A only C. Both A and B В. В only D. Neither A nor B

2. When inspecting a transaxle's gears, be Technician A says that a shiny wear pattern on the center of the gear teeth is normal. Technician B says that it is normal for a reverse idler gear to have small chips on its engagement side. Who is correct? A. A only C. Both A and B В. В only D. Neither A nor B

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter39: Manual Transmission/transaxle Service

Section: Chapter Questions

Problem 7ASRQ: While inspecting a transaxies gears: Technician A says that wear on the back of the gear teeth is...

See similar textbooks

Similar questions

An epicyclic gear train has 3 shafts A,B and CA is an input shaft running at 100 rpm clockwise. B is an output shaft running at 250 rpm clockwise. Torque on A is 50 kNm (clockwise). C is a fixed shaft. The torque to fix C
Two mating 20°, 8-pitch, spur gears have 14 and 42 teeth. Will they interfere?
While inspecting a transaxies gears: Technician A says that wear on the back of the gear teeth is normal. Technician B says that it is normal for a reverse idler gear to have small chips on its engagement side. Who is correct? a. Technician A only b. Technician B only c. Both A and B d. Neither A nor B
In a simple planetary gearset, when the planetary carrier is held, the gearset produces a______. a. reverse b. direct drive c. fast overdrive d. forward reduction
Which type of gear develop gear whine at high rotational speed? a.Spur gear b.Helical gear c.Both a and b d.Neither a nor b
what is the equation of the addendum and dedendum in helical gears
The gears that are used to transmit motion and power between two parallel shafts and having teeth cut at an angle to the face of the gear is known as a -------------gear.
State an equation tha relate the number of teeth of gear D, B and C.
How can we define the module of a spur gear? a. The pitch diameter over the pi number (3.14). b. The pitch diameter multiplied by the tooth number. c. The circular pitch multiplied by the pi number (3.14). d. The circular pitch over the pi number (3.14).
Discuss the difference between simple gear train and compound gear train ..
Technician A says that a hunting gearset is one in which one drive pinion gear tooth contacts only certain ring gear teeth, Technician B says that a partial nonhunting gearset is one in which one pinion tooth contacts only six ring gear teeth. Who is correct?
Two identical involute, spur gears are in mesh. The module is 4 mm and each gear has 22 teeth If the operating pressure angle is 20° The minimum value of addendum needed to ensure continuous transmission of motion is