3) an open die. Initial diameter of the cylindrical work part = 30 mm, and its height = 50 mm. The part is upset to an average diameter temperature yields at 90 MPa. Coefficient of friction at the die-work interface Determine (a) the final height of the part and (b) the maximum force in the operation. Chapter 18: Problem 18.14 (SI units) A hot upset-forging operation is performed in 45 mm. The work metal at this elevated 0.40.

3) an open die. Initial diameter of the cylindrical work part = 30 mm, and its height = 50 mm. The part is upset to an average diameter temperature yields at 90 MPa. Coefficient of friction at the die-work interface Determine (a) the final height of the part and (b) the maximum force in the operation. Chapter 18: Problem 18.14 (SI units) A hot upset-forging operation is performed in 45 mm. The work metal at this elevated 0.40.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

1) A upset forging operation is performed in an open die. The initial size of the workpart is: Do = 63 mm, and ho = 100 mm. The part is upset to a diameter = 70 mm. The work metal has a flow curve with strength coefficient = 600 MPa and strain hardening exponent= 0.22. Coefficient of friction at the die-work interface = 0.40. Determine (a) final height of the part, and (b) maximum force in the operation.
27(B). Distinguish the Open die and closed die forging process with its benefits and limitations.
Forging processes may be characterized by die work limitation. This categorization yields three basic types.
What are the advantages of a counterblow or impact forging machine? What are some of the properties desired in forging dies?
A cylindrical billet that is 100 mm long and 50 mm in diameter is reduced by indirect (backward) extrusion to a 20 mm diameter. The die angle is 90°. In the Johnson equation, a = 0.8 and b = 1.4. In the flow curve for the work metal, the strength coefficient = 800 MPa and strain hardening exponent = 0.13. Determine (a) extrusion ratio, (b) true strain (homogeneous deformation), (c) extrusion strain, (d) ram pressure, and (e) ram force
Explain steps of rolling process in forming process?
Q#3:(b) Explain the differences between Forward Extrusion and Reverse Extrusion processes
Q#1: (a) Explain the advantage of corner radii of punch and die in Sheet Metal Drawing Process. (b) Explain the disadvantages of Tube Drawing process in which mandrel is not used.
The quantity of work that can be done in the die may be used as a defining feature of forging processes. Please identify the following three broad classes that this sorting generates.
Q26. Compare any ten major differences between Drawing process and Extrusion process
1. A component is designed to be hot forged in an impression die. The projected area of the product is 5800 mm2. During the forging process flashing is formed so that the area including the flash will be 8900 mm2. The part geometry is considered to be simple and the heated work material yields at 92 MPa. Calculate the maximum force required to perform the operation. 2. What are the advantages and disadvantages to forge a product through the open forging process, rather than to machine it from the same material?
L) Friction between .................. and .... ........... in direct extrusion more forcerequires.m) The method of sheet forming in which springback is prevented is named ..........