3.) Find the percent overshoot, settling time and peak time for T(s) == 0.04 $240.002s +0.04

Q: From the given two bode plots figures below,explain briefly the two figures below and identify which…

A: Gain Margin Phase Margin Result Positive Positive Stable Negative Negative Unstable Positive…

Q: Design a widler current source that that supplies a current of 1-5uA using reference current of 500u…

A:

Q: QUESTION 3. In the reverse-bias region the saturation current of a silicon diode is about 0.1 μA (T=…

A: Given, Reverse saturation current (Isat(1)) = 0.1uA at temperature, T1 = 20°C We need to find…

Q: remains constant regardless of the load connected to it is O very high gain O high CMRR O infinite…

A:

Q: 4. Determine the Fourier Series coefficients X[k] (or D₂) for the signal in (a) and the Fourier…

A:

Q: d) To measure currents in the simple circuit shown in Fig. 2 below, you would replace a wire between…

A: We know that  For measuring current we connect ammeter in series with the corresponding element…

Q: Unit Step Function Example 1. a)Define a rectangular voltage pulse by the following conditions. b)…

A: Basic Input signals Delta function Unit step function Ramp function Parabolic function..etc

Q: We know that L = 3 x = W МЕ => x= 2 [p-} 11+/0 (WE 2 For good conductol, WE K<< D МЕ M/²2 { ₁ + √ √…

A:

Q: The magnitude of the frequency response of r(t) is shown below, use the Fourier Transform properties…

A: Since you have posted a question with multiple subparts, we will provide the solution to the first…

Q: 18. A 10.0 µF capacitor, a 40.0 uF capacitor, and a 100.0 uF capacitor are connected in series. A 12…

A: Given,       C1=10 μFC2 =40μFC3 =100μFV = 12 V

Q: in Manila, the LRT runs between Gil Puyat Station and Tayuman Station, which is 4 km apart and…

A:

Q: When using the transtor as a key The question is to explain briefly how the current of the collector…

A: The above question is based on the operation of a BJT. In the active mode of operation, the…

Q: Problem 02.038 - Series/parallel resistance combinations Find Req and io in the given circuit.…

A: We need to find out equivalent resistance and we need to find out current for given circuit .

Q: A battery has a short-circuit current of 20 A and an open-circuit voltage of 12 V. If the battery is…

A:

Q: 1) Give an example on how to sketch a transfer curve for an n-channel enhancement-type MOSFET from…

A:

Q: 6. A three-phase power transformer used in power system can be a) step down current b) extra step-up…

A:

Q: For the circuit in Figure below, what is Ic3? Assume all transistors are identical. IREF 1 Q5 R1…

A:

Q: 3. A constant voltage at a frequency of 1 MHz is applied to an inductor in series with a variable…

A: Solution (3) -  Frequency = 1MHz The current is maximum, when capacitor = 500 pF The current is…

Q: Q2.Three phase half-wave diode rectifier is operated fr 460 V,50 Hz supply at secondary side and the…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: I-Assume that a 12 V voltage drop occurs across an element from terminal 1 to terminal 2 and that a…

A:

Q: Exercise: 1 Consider the system shown in Figure 1. To improve the performance of the system a…

A: Since you have posted multiple questions, we will provide the  solution   only to the first question…

Q: a) Convert the flowing number (226)10 to binary, octal, and hexadecimal.

A: here we have to perform the number system conversion.

Q: Question Overall transfer function of a system is given as G(s) = (28+1) (s²+28+5) .The system is…

A: Given- The overall transfer function of a system, Gs=2s+1s2+2s+5   To find- System characteristics.

Q: Given a Bode diagram of a dynamic system, shown in Fig. 4: (a) Find the transfer function of the…

A: The Bode plots of a system with transfer function G(s) are provided. The magnitude plot has a slope…

Q: Problem 02.034 - Equivalent resistance seen by a source Using series/parallel resistance…

A:

Q: Figura 4 R₁ www (a) R₂ R3 42 R₁ 34₂ (b) R₂ www R3

A: given circuit problem.we have to calculate time constant

Q: Required information The circuit shows a two-op-amp instrumentation amplifier. Vo = 210 www.l R₂ ww…

A: We need to find out the output voltage for given circuit .

Q: An LRC circuit is shown with an alternating source with a current given by i(t)= Icos(cot), with…

A:

Q: 5. Given v = 200 sin 377t V and i = 8 sin (377t-30°) A for an ac circuit. Determine (a) the power…

A:

Q: The generator in Fig. 1 delivers 1 pu active power at 0.85 pf lagging to the infinite bus. 10.25…

A: Given P= 1 pu pf =0.85 lagging Xd' =0.15 infinite bus voltage , V=1 pu

Q: What are the sources of the noise in communication ?

A: Effect of Noise on communication Loss of Message content interference leads to changes in channel…

Q: 8. For this circuit, find the current I₁. A) 5.87 + j0.88 A B) 6.35 + j1.41 A C) -48 + j24 A D) 2.27…

A:

Q: Problem I f(t) to F(s) Use tables 12.1 and 12.2 from the textbook to find: d L {o cos wt} 2dt Use…

A: Please refer the attached images for the complete answer

Q: 1. A 30-ampere, 120-volt, UF cable circuit is buried outbuilding. The minimum depth of this cable is…

A: it is asked to find minimum depth of 30A,120V UF cable circuit buried from a dwelling unit to…

Q: A three phase, 400 kV, 50 Hz, 900 km long line is operating with VS =VR = V = 1.0 p.u. and 8=60°. A…

A:

Q: What is the capacitive reactance (in 2) of a 4.7-uF capacitor at 10 kHz?

A:

Q: The circuit has an RMS secondary voltage of 22.16 volts. One of the diodes is broken. Considering…

A: Given data Primary voltage, VpRMS=120 V Secondary voltage, VsRMS=22.16 V Supply frequency, f=60 Hz…

Q: g fed to the ADC. oltage follower alter comparator ample and hold circuit

A:

Q: Calculate the currents (,,i1, i2, i3 and ly in the figure below. Then, obtain the voltage value on…

A:

Q: ). If the sequence of Wye connected load is ABC and the reference is VCA then the phase voltage must…

A:

Q: (a) FIND THE EQUIVALENT INDUCTANCE WITH RESPECT TO TERMINALS a, b. 18 u H эт a b 25 ма т вома im 15…

A:

Q: 8. What is the Fourier transform of e-ltl cos(t)? (A) 1 (B) (C); 2 1+0² (E) 1+0² 1 (D) 1+ (0-1)² 1…

A:

Q: what is the 12) Consider a WSS random process X(t) with Rx (7) = e-all, where a is a positive real…

A:

Q: The output expression for the circuit given in Figure below is V1 10 k V2 WW 10 ΚΩ 10 k w 10 ΚΩ O…

A: Given opamp circuit is as follows.

Q: 5. A 3-phase full-wave bridge rectifier is built using six power diodes numbered 1 to 6. The phase…

A: Given data Line-to-line voltage is VL-L=208 V line-to-neutral voltage is at an angle of -30°. We…

Q: 24 V + www 80 www 30 20 ww 12.02 wwww 30

A: It is asked to find equivalent resistance of given circuit

Q: H.W: Find (HPBW) and (FNBW), in radians and degrees, for the following normalize radiation…

A: Since you have posted multiple questions we will provide the solution to the first three questions…

Q: a I 50 ohms 50 ohms d 50 ohms t R R ww w m 50 ohms 50 ohms 50 ohms R R R 50 ohms 50 ohms R C 50 ohms…

A:

Q: 6. In this circuit, the current I is 5245° Arms. Find SLoad. A) 50.01 2134.43° VA B) 5000 Z0° VA C)…

A: Voltage source connected to a load through impedance Z is given and value of both voltage source and…

Q: Question 57 A spacecraft in 550km circular orbit passes directly over a ground station. The ground…

A:

Latches and Flip Flop

Just like logic gates, the latches and flip-flops are the important elements of an electronic circuit. The logic gates form the important part of combinatorial circuits, while the latches and flip-flops form the essential part of a sequential circuit. Sequential circuits form the important concept of automata theory in electronics and electrical engineering, these circuits are a kind of logic circuit whose output depends on both present input and past inputs, that is, the input history.