Answered: 7. An open tank contains 5.7 m of water…

7. An open tank contains 5.7 m of water covered with 2.8 m of kerosene (y=8.0 kN/m³ ). Find the pressure at the interface and at the bottom of the tank.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.121P: One side of the container has a 03-m square door that is hinged at its top edge. If the container is...

See similar textbooks

Related questions

Q: 2- A semicircular 30-ft-diameter tunnel is to be built under a 150-ft-deep, 800-ft-long lake, as…

Q: Q1:Find the location of resultant force( F)of the water on the triangular gate and the force(P)…

Q: Q8:Find the value of the hydrostatic force and the direction and the position of (c.p.) on the…

Q: An outside pressure 14.59 psi exist outside the small drop of water having a diameter of radius of…

Q: The uniform 5-m-long round wooden rod is tied to the bottom by a string. find the tension in the…

A: the rod weight acts at the middle 2.5m from the point C while the buoyancy is 2m from C W is the…

Q: B3. A circular plate of diameter 2 m is vertically placed in water in such a way that the centre of…

Q: 5. Calculate the net hydrostatic force per unit width on the rectangular panel AB and its location…

A: Answer: ◆The net hydrostatic force per unit width on the rectangular panel AB is 28.88304 kN. ◆ It's…

Q: Calculate the horizontal and vertical forces acting on the curved gate shown in the figure Calculate…

A: The figure below shows the schematic diagram of the Gate.

Q: An open tank contains water up to a depth of 1.2m from the bottom and above it mercury for a depth…

Q: Problem (3) Compute the horizontal and vertical components of the hydrostatic force on the…

Q: B3. A rectangular plate of width 45 mm, depth =65 mm is vertically placed in water in such a way…

A: Solution is given below.

Q: If the total ocean bottom depth is 5500 ft and the first layer depth is 13000 ft and the second…

A: Surface temp=60°Fsurface pressure=14.7psi

Q: 1- The flow of water from a reservoir is controlled by a5-ft-wide L-shaped gate hinged at point A,…

Q: An open tank contains 5.6m of water covered with 3.4m of kerosene (S.G=0.80). Find the pressure at…

Q: An open tank contains 5.8 m of water covered with 3.2 m of kerosene (y = 8). Find the pressure (kPa)…

A: Given Data - In Open tank Water up to a depth of 5.8m cover with kerosene with a depth of 3.2m The…

Q: A cylindrical tank having radius R is half filled with water having density p. There is a hole at…

Q: 9. In figure 4, determine the pressure head difference in feet of water between m and n, when z is…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A vertical bulkhead is 2 metres wide and 3.7 metres high. It has fresh water on one side to a depth…

A: Draw sketch of door with forces on it

Q: The gate shown is hinged at H. The gate is 3 m wide normal to the plane of the diagram. Calculate…

A: Given: The width of plate, b = 3 m The length of gate, L = 3 m

Q: ВЗ. A circular plate of diameter 3 m is vertically placed in water in such a way that the centre of…

Q: Calculate the force P required to keep the gate closed. Water 6 m Hinge 3 m

A: Please find the solution below

Q: A vertical bulk head is 2 meters wide and 3.7 meters high. It has fresh water on one side to a depth…

A: Assuming the door separates two fluids and the hinge of the door is at bottom. Assuming see water…

Q: A flotation device with volume = 0.15 m3 and specific weight 1 = 0.27H20 is held submerged in a tank…

Q: Pa) that suspends the elevator car in its shaft is 2500 N. How many mm will the elevator cable…

A: To find :- Cable strech

Q: The two sides of a V-shaped water trough are hinged to each other at the bottom where they meet, as…

A: Given data: The angle of each side is θ = 45o. The width of the each side is x = 0.75 m. The length…

Q: Q5: The rectangular gate AB has a length of L and width 2L and weight W, hinged at B, find P to…

Q: Q5. Find the center of gravity of a solid bounded by x = y´ and the planes x = z, z = 0, and x = 1.…

A: The region is V ={ (x,y,z) : 1≤ y ≤ I ; y2 ≤ x ≤ 1 ; 0≤ z ≤ 1} The mass of the solid is

Q: The tank in Fig. 2/is 3 m wide into the paper. Compute the hydrostatic (a) horizontal force…

Q: glass window has the shape of a trapezoid with height 3m, width at the top of 4m, and width at the…

Q: As illustrated in the figure, an inclined circular gate with a diameter of 1.1 meter has water on…

Q: Q.2: In the figure shows a curved surface LM, which is in the form of a quadrant of a circle of…

A: Solution: The horizontal component of the hydrostatic force From the figure position of x¯ from the…

Q: Find the maximum height of the water that would still allow you to open the door, using the same…

A: Answering the fourth question as the third question is being answered earlier It is asked to find…

Q: The field storage tank is filled with oil. The standpipe is connected to the tank at C and open to…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Q: : Find the hydrostatic pressure force acting on the ABCD curvilinear surface. (The width of the gate…

Q: 6. A tank of water has a gate in its vertical wall 5 m high and 3 m wide. The top edge of the gate…

A: Solution 6:

Q: Q1) If the vertical component of the hydrostatic force on the gate BC shown in fig.1 is 1200…

A: GIVEN DATA- A gate BC given we have to calculate all three point

Q: The pressure outside the droplet of water of diameter 0.04 mm is 103.2 kPa (atmospheric pressure).…

Q: 3. A semicircular 40-ft-diameter tunnel is to be built under a 150-ft-deep, 800- ft-long lake, as…

Q: In the figure shown, what the minimum height (h) t which water must rise in th water tank in order…

Q: 1.5 m B 2 m

A: The resultant force by the fluid on the object is known as hydrostatic force. The location of the…

Q: Q6:Find the hydrostatic force and direction and position of (c.p.) on the inclined submerged surface…

Q: Problem 1: One end of a U-tube that contains water is open to the atmosphere, but the other end is…

A: ...

Q: In the system shown in figure find the ratio A1/A2 if the change in pressure at B by 0.5 psi gives 1…

A: pressure will bbe equal in both limbs, Pa+Ywater(h1+h2)-YmercuryXh1-YoilXh2=Pb after the change in…

Q: 1.2 m and diameter 0.6 m is three quarters filled with water when stationary. If the tank is rotated…

Q: A rectangular tank 6 x 8 ft is filled with a gasoline to a depth of 80 ft. The pressure at the…

A: Given data: P=14.7 psih=80 ft Need to determine the pressure at the bottom of the tank and force…

Q: A dam is used to store water, and a rectangular gate which is hinged at its bottom edge is used to…

A: Data given- Width = 1 h1 = 1 m h2 = 5 m Alpha = 65°

Q: The Figure below shows a dam 30.5 m long that retains 8 m of fresh water and is inclined at an angle…

Q: 2- A semicircular 30-ft-diameter tunnel is to be built under a 150-ft-deep, 800-ft-long lake, as…

Q: Problem 5. From the given figure, the spillway gate CD is in the form of parabolic segment with a…

A: Given:head of water, h=4 mn=2 mlength=3 m

Question

7. An open tank contains 5.7 m of water covered with 2.8 m of
kerosene (y=8.0 kN/m³ ). Find the pressure at the interface and at
the bottom of the tank.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Calculate the resultant force caused by the water acting on the parabolic arch dam. The water levels are 16 ft on the upstream side and zero on the downstream side. For water, use =62.4lb/ft3.
One side of the container has a 03-m square door that is hinged at its top edge. If the container is filled with water, determine the smallest force F that must be applied to the bottom edge of the door to keep it closed.
Find the horizontal pressure acting at the face of the damn at 20ft depth.
ii. If the surface tension of the drop be 42.27x103 N/m, find the pressure difference of the drop
The face of a dam is a vertical rectangle of height 100 ft and width 200 ft (Figure 6.8.5a). Find the total fluid force exerted on the face when the water surface is level with the top of the dam.
The three reservoirs system contains water. If L1 = 2000 m, f 1= 0.013, D1 = 1m; L2 = 2300 m, f2 = 0.02, D2 = 0.60m; and L3 = 2500 m, f = 0.023, D3 = 1.20m. Compute Q3 in m3/s.
An inclined, circular gate with water on one side is shown in the figure. Determine the total resultant force acting on the gate.
Find the surface tension of the water droplet of 30 mm diameter when the inside pressure is 3.5 N/m2 The surface tension in N/m is
The distance between the two plates, which are 2 m x 2 m in size and parallel to the earth surface, is 9 mm, and there is water at 20 ° C between them. Find the force in (N) to be applied to pull the top plate to the right at 10 m / s.
In the figure shown, stop B will break in the force on it reaches 40 kN. Find the critical water depth (h-bar) the length of the gate perpendicular to the sketch is 1.5m. Ans (5.77m)
Determine the location of the total hydrostatic force from thr bottom surface and the top surface acting on the 2m x 4m gate shown on the illustration.
A dam is used to store water, and a rectangular gate which is hinged at its bottom edge is used to control the flow as shown in figure 1. For this gate, width = 1 m (in the direction of the page) , α = 65°, h1 = 1 m, and h2 = 5 m. Figure 1: Schematic for task 1. (Giancoli et al.) a. Describe the forces acting on the gate and the center of pressure. b. Determine the resultant force and the position of the center of pressure on the gate. c. What is the maximum gate mass that is needed for it not to fall? d. Show yc, yR, hc, hR, FR, and W on the free body diagram.