3.(a) Make a truth table for this given logic gate, as shown in the figure. Show the steps. What is this gate? Q1 (b) Construct a Resistor-Transistor Logic circuit with the same logic function as the given logic gate. Q2 Q5 Y=A+B Q4 Q6

Q: Explain the reasons for applying system grounding in electric power systems.

A:

Q: The signal flow graph of a system is shown in figure. The transfer function of the system is 5/s 1/s…

A: Given the signal flow graph,

Q: (a) The plane defined by y – x = 6 separates medium-1 (y – x > 6) of permeability u = µo from…

A:

Q: Q4) A black and white television picture may be viewed as consisting of approximately 3x10 elements…

A: The solution is given below

Q: Power amplifier delivers 3.6 W of power to a load. The input signal power was 200 mW. What is the…

A: We need to find out power gain

Q: valuate the stability of the following system by determining the poles: :) = -2 +

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: (a) The plane defined by y – x = 6 separates medium-1 (y – x > 6) of permeability u = µo from…

A:

Q: S.62) The 8085-programming manual says that it takes seven T states to fetch and execute the MOV…

A: Given data: The system clock frequency, fclk=2.5 MHz Number of T states = 7

Q: Draw a parallel system diagram for the following transfer function: 6/11 0.0167 0.15 + 0.133 H(s) =-…

A: We need to draw the transfer function

Q: Use source transformation, reduce the circuit to a single voltage source in series with an…

A: In this question,   We need to determine the circuit to a single voltage source series with an…

Q: After a long time with the switch at position a, the switch moves to position b at time t=0. Assume…

A: In this question,   We need to determine the voltage across the resistance R2 at the time t= 0.1ms.…

Q: (b) A radio station that radiates from a point source transmits a 10-kW signal. It operates at 100…

A: Antenna- Metal device, which captures and transmits radio electromagnetic waves. it is know as…

Q: Q2 A 200 V shunt motor having armature resistance of 0.4 N and shunt field resistance f 100 2 drives…

A:

Q: In the circuit below, the switch closes at time t=0. Assume that Vs = 13 V, R switch closes is 3.9…

A:

Q: 7. Two single-phase transformers, connected in open delta will supply power to a 200 hp, three-phase…

A:

Q: QUESTION 3 Determine Vol and Vo2 for the networks of Figure 3. Si Ge Si 4.7 k2 1.2 k2 +12 Vo -10 Vo…

A:

Q: *10. Calculate the current I for the network of Fig. 18.118. 20V Iz = 1 mA Z 0° VR, s kn I = 2 mA Z…

A: Apply KVL in internal Loop 1 to find Voltage across 2 Kohm Apply KCL at A and do substitution  Find…

Q: What is the wavelength corresponding to a frequency of 300 MHz?

A: Wavelength is nothing but the speed of light to the frequency. The unit of wavelength is meter.

Q: 2<t<5 5 Q2. Find the Laplace transform for f(t)=- 0 otherwise

A: The Laplace transform of the function can be obtained by using the following equation  F(s)…

Q: Two 100-kW, single-phase transformers are connected in parallel both on the primary and secondary.…

A: In this question we need to find a load share by transformer

Q: Need explain for any of these phasor diagrams (Medium length transmission line nominal PI model)…

A: It is asked to explain any of the phsor diagram. we are explaining first, pure resistive load

Q: anced Wheatsone briage ABCD has the following arm resistances : = 1 kN ± 2.1%; RBc = 300 N ± 0.4%.…

A: Solve the problem

Q: Consider the circuit shown in Fig. (5) Assume that E - 1.25 p.u., and V- 1.00 p.u. a- Assume that…

A:

Q: The switch in the circuit below closes at time t=0, and a long time passes such that steady-state…

A: Brief description : For the given second order system we need to calculate voltage across resistor…

Q: For the circuit shown, R, 'RI R, • R1 = 39 kN • R2 = 18 kn • R3 = 22 kN • R4 = 47 kn RA Is = 0.54 mA…

A: In this question,   We need to determine the current in the resistance R2 using current division…

Q: a: Find the Discrete Fourier series of x(n) = cos (1.414n n).

A: We need to find out Fourier series coefficient

Q: For the circuit given below, and find the formulas for: Vout a. Output voltage gain, which is…

A: for our policy, i can solve first three parts

Q: Volage Soerce ISV I mA Superposibion =1+I=1, = 1;+1; =I, = I; +1= Both source, 1 = I, = Direct 1 =…

A:

Q: Design a multi range ammeter to give the following ranges 100mA, 1A, 5A, and 5OA. If d'Arsonval…

A:

Q: Q4 A 220 V shunt motor has an armature resistance of 0.5 N and take armature current of 40 A at…

A: In this question we need to find a reduction in main filed flux

Q: 6. A 250-V circuit, consisting of a resistor, an inductor and a capacitor in series, resonates at 50…

A: In this question,   We need to determine the value of R, L, C if all are connected in the series.…

Q: Consider the transmission line in the figure below. RG t=0 VG Zo d The length of the line is d = 3…

A: Given transmission line The length of the line is d = 3 m. The source voltage VG = 15 V, and the…

Q: H.W. Determine the Curvent thraugh RI R. 152 15n E= 220L0°

A: Given here a circuit and asked to determine the current through the resistor R1 inductive reactance…

Q: Q6 a d.c. shunt machine while running as generator develops a voltage 250 V at 100 r.p.m. at…

A: In this question,   We need to determine the speed and efficiency of the generator

Q: Write a Boolean expression for the output of the logic circuit. W X Y

A: This question belongs to digital electronics . It is based on the concept of Boolean expression for…

Q: For b) what is Vry, Vbr, Vyb? Why is Vyb phase -90 degrees and Vby phase 90 degrees?

A: In this question we will find line voltage phase angle with respect to phase voltage.....

Q: ww 10 V 6V ww Find i Select one: O a. 0.333 A O b. 0.666 A O c. -2.666 A O d. -0.333 A e. -0.666 A

A: We need to find out current for given circuit

Q: The following f(t) is a periodic function of period 4 defined over the domain –1 <t< 3 by when |t| <…

A:

Q: Find v.(t) in the circuit of Fig. 16.7. Assume v,(0) = 5 V. 10 Ω 10e u(t) V 10 Ω v,(1) 0.1 F 28(1) A…

A:

Q: Q16 A 240V, 50 Hz, single-phase capacitor start a.c. motor is loaded such that the slip is 6% the…

A: In this question,   We need to determine the output power and efficiency of the motor?      Given…

Q: Example 7.6: CB radio channels are 10 kHz apart. What is the maximum modulation frequency that can…

A: Solution is given below

Q: [5 Q2. Find the Laplace transform for f(t) = 2<t<5 0 o therwise

A:

Q: 4. Using superposition, find the sinusoidal expression for the voltage vc for the network of Fig.…

A:

Q: An Inductor has an internal resistance of 10 Ohms and an inductance of 0.5H. What is it's impedance…

A: Given R = 10 ohm, L = 0.5H, F = 60Hz  To calculate impedance Z

Q: Calculate the diode’s equivalent voltage if the forward bias current is 1mA over a 100 kHz…

A: The solution is given below

Q: Q5: find the DTFT of the following two-sided sequence x(n) = (0.5)| %3D

A:

Q: 5. A hydroelectric station is supplied from a catchment area of 150 km- with annual rainfall of 200…

A: In this question we need to choose a correct option

Q: A system has an open-loop transfer function given by K/[s(1 + 3s)]. Which one of the following…

A:

Q: b) Unpolarized light of intensity 20 W /em? is incident on two polarizing filters. The axis of the…

A: Given:Unpolarized light of intensity=20W/cm2θ1=25°θ2=62°

Q: 4. For the network of Fig. 16.42: a. Find the total impedance Z7. b. Calculate the voltage V2 and…

A: In this question,   We need to determine impedance ZT  and voltage V2  and current IL  and power…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.