Question
Asked Nov 26, 2019
22 views
36. (SI units) A GO/NO-GO plug gage will be designed to inspect
a 60.00 0.40 mm diameter hole. A wear allowance of 3% of the
total tolerance band is applied to the GO side of the gage.
Determine the nominal sizes of the NO-GO gage. Round your
answer to the nearest thousandth of a mm.
help_outline

Image Transcriptionclose

36. (SI units) A GO/NO-GO plug gage will be designed to inspect a 60.00 0.40 mm diameter hole. A wear allowance of 3% of the total tolerance band is applied to the GO side of the gage. Determine the nominal sizes of the NO-GO gage. Round your answer to the nearest thousandth of a mm.

fullscreen
check_circle

Expert Answer

Step 1

Given data:

Diameter hole  = 60.00 ± 0.40 mm

Wear allowance = 3 %

Step 2

For a hole, NO-GO represents the maximum diameter of the product tolerance.

In case of NO-GO gage side wear allowance is not considered.

Hence, the NO-GO side will inspect the maximum diameter.

Tolerance
Shaft
NO-GO Gauge
GO Gauge
Lower Limit
Upper Limit
help_outline

Image Transcriptionclose

Tolerance Shaft NO-GO Gauge GO Gauge Lower Limit Upper Limit

fullscreen
Step 3

Thus, the nominal size of ...

60.000.40
60.40mm
help_outline

Image Transcriptionclose

60.000.40 60.40mm

fullscreen

Want to see the full answer?

See Solution

Check out a sample Q&A here.

Want to see this answer and more?

Solutions are written by subject experts who are available 24/7. Questions are typically answered within 1 hour.*

See Solution
*Response times may vary by subject and question.
Tagged in

Engineering

Mechanical Engineering

Related Mechanical Engineering Q&A

Find answers to questions asked by student like you

Show more Q&A add
question_answer

Q: Replace the system of two forces and one couple by a wrench. Determine the magnitude of the moment M...

A: Write the position vector of the all points.

question_answer

Q: Also, for each of the compression processes described in the following picture, determine the follow...

A: Apply the ideal gas equation at the constant pressure process (expansion) and substitute the provide...

question_answer

Q: I need parts 8, 9, and 10 answered pertaining to the print provided and the set of sequence operatio...

A: If intake and exhaust will be on the same side of cylinder head then this is a reverse flow and non-...

question_answer

Q: Consider the conditions of Problem 1, homework 5 (it is repeated below) and that the surroundings ar...

A: Given data,

question_answer

Q: I need answers to questions 1, 2, and 3 pertaining to the print provided. Note: A tutor keeps puttin...

A: If any changes in the part feature are made, the changes are recorded in the specified format in the...

question_answer

Q: Carbon monoxide (CO) contained in a piston–cylinder arrangement, initially at 3.5 bar and 462 K, und...

A: Given data as per question

question_answer

Q: At the beginning of the compression process of an air standard Otto cycle, p1 = 1 bar, T1 = 300 K. T...

A: Note: We will answer the first 3 subparts since the exact 3 are not specified. Please submit a new q...

question_answer

Q: SAE 10W30 motor oil has a dynamic viscosity of 0.21 kilograms per meter second and a specific gravit...

A: Given data as per question

question_answer

Q: solve (d) part of Q7 asap

A: Consider the simple gas refrigeration cycle,