4) The amount of corn in a silo is given as a function of time, t, to be AO- in hours and A(t) is in tons a) Determine the amount of corn in the silo at t= 8 hours b) Determine the rate of change of the amount of corn in the silo at t=8 hours Vt* +t wheretis %3D %3D

4) The amount of corn in a silo is given as a function of time, t, to be AO- in hours and A(t) is in tons a) Determine the amount of corn in the silo at t= 8 hours b) Determine the rate of change of the amount of corn in the silo at t=8 hours Vt* +t wheretis %3D %3D

Advanced Engineering Mathematics

10th Edition

ISBN:9780470458365

Author:Erwin Kreyszig

Publisher:Erwin Kreyszig

Chapter2: Second-order Linear Odes

Section: Chapter Questions

Problem 1RQ

See similar textbooks

Similar questions

Explain the benefit of L’Hôpital’s Rule.
The specification for the pull strength of a wire that connects an integrated circuit to its frame is 10 g or more. Units made with aluminum wire have a defect rate of 10%. A redesigned manufacturing process, involving the use of gold wire, is being investigated. The goal is to reduce the rate of defects to 5% or less. Out of the first 100 units manufactured with gold wire, only 4 are defective. True or false: a) Since only 4% of the 100 units were defective, we can conclude that the goal has been reached. b) Although the sample percentage is under 5%, this may represent sampling variation, so the goal may not yet be reached. c) There is no use in testing the new process, because no matter what the result is, it could just be due to sampling variation. d) If we sample a large enough number of units, and if the percentage of defective units is far enough below 5%, then it is reasonable to conclude that the goal has been reached.
The EPA Risk Management Plan (RMP) defines a worst-case scenario as the catastrophic release of the entire process inventory in a 10min period (assumed to be a continuous release). The dispersion calculations must be performed assuming F stability and 1.5 m/s wind speed. As part of the RMP rule, each facility must determine the downwind distance to a toxic endpoint. These results must be reported to the EPA and to the surrounding community. A plant has a 100lb tank of anhydrous hydrogen fluoride. The toxic endpoint is specified in the RMP as 0.016 mg/L. Consider the EPA worst case release scenario described above (assume rural conditions) and consider in particular the footprint of the toxic cloud at ground level. (1) Determine the size of the toxic cloud in the downwind direction. (2) Determine the maximum thickness of the toxic cloud in the crosswind direction
only define the parameter and write the null and alternative hypotheses The production line for Glow toothpaste is designed to fill tubes with a mean weight of 6 oz.Periodically, a sample of 35 tubes will be selected in order to check the filling process. Qualityassurance procedures call for the continuation of the filling weight for the population of toothpastetubes is 6 ounces; otherwise the processes will be adjusted. Suppose a sample of 35 toothpaste tubesprovides a sample mean of 6.1 oz and standard deviation of 0.2 oz. State the parameter and both hypotheses to help determine whether the filling process should continue operating or be stopped and corrected.
The Us food and Drug administration has a limit for mercury content in fish of 1.0ppm (parts per million) while in Canada the limit is 0.5 ppm. Using the variable average mercury in the Florida lakes dataset to test whether there is evidence that average mercury level of fish ( large mouth Bass) in Florida lakes is less than 1.0ppm and whether there is evidence that average mercury level of fish in Florida lakes is less than 0.5ppm. STATE THE NULL AND ALTERNATIVE HYPOTHESES? GIVE THE TEST STATISTICS AND P-VALUE? round the test statistic to two decimal places and the p-value to three decimal places. DOES THIS SAMPLE PROVIDE EVIDENCE THAT THE AVERAGE MERCURY LEVEL OF FISH (LARGE MOUTH BASS) IN FLORIDA LAKES IS LESS THAN 1.0PPM? LESS THAN 0.5 PPM : STATE THE NULL AND ALTERNATIVE HYPOTHESES. GIVE THE TEST STATISTICS AND P-VALUE ? round the test statistic to two decimal places and the p-value to three decimal places. DOES THIS SAMPLE PROVIDE EVIDENCE THAT THE AVERAGE MERCURY…
What is the average NO3- concentration at the upslope site (3 decimal places)? What is the average NO3- concentration at the downslope site ( 3 decimal places)? Given the EPA drinking water quality standard is 10 mg/L of nitrate, is the upslope site safe to drink based only on nitrate content? (Enter yes or no) Is the downslope site safe to drink, based only on NO3- concentration? (Enter yes or no) Assuming the two sites are hydrologically well connected, the transit time between the two sites is fast, and the two sites cannot be treated as independent samples, what kind of t-test should be performed to show that the upslope site is greater than the downslope site? Enter the letter of your answer choice in the answer blank A. one-tailed unpaired t-testB. two-tailed unpaired t-testC. one-tailed paired t-testD. two-tailed paired t-test What is the calculated t statistic, rounded to 4 decimal places? Is the calculated t statistic greater or less than the critical t value reported by…
The "spring-like effect" in a golf club could be determined by measuring the coefficient of restitution (the ratio of the outbound velocity to the inbound velocity of a golf ball fired at the clubhead). Twelve randomly selected drivers produced by two clubmakers are tested and the coefficient of restitution measured. The data follow: Club 1: 0.8406, 0.8104, 0.8234, 0.8198, 0.8235, 0.8562, 0.8123, 0.7976, 0.8184, 0.8265, 0.7773, 0.7871 Club 2: 0.8305, 0.7905, 0.8352, 0.8380, 0.8145, 0.8465, 0.8244, 0.8014, 0.8309, 0.8405, 0.8256, 0.8476 Test the hypothesis that both brands of ball have equal mean overall distance. Use α = 0.05 and assume equal variances. Question: Reject H0 if t0 < ___ or if t0 > ___.
At a hydrocarbon processing factory, process control involves periodic analysis of samples for a certain process quality parameter. The analytic procedure currently used is costly and time consuming. A faster and more economical alternative procedure has been proposed. However, the numbers for the quality parameter given by the alternative procedure are somewhat different from those given by the current procedure, not because of any inherent errors but because of changes in the nature of the chemical analysis.Management believes that if the numbers from the new procedure can be used to forecast reliably the corresponding numbers from the current procedure, switching to the new procedure would be reasonable and cost effective. The following data were obtained for the quality parameter by analyzing samples using both procedures: Current (Y ) Proposed (X ) Current (Y ) Proposed (X ) 3.0 3.1 3.0 3.6 3.8 2.7 2.7 3.1 3.9 3.4 4.0 3.6 3.6 3.6 3.1 2.7 3.3 3.2 2.1 3.0 2.6 3.1 2.9…
Cal Poly Pomona found that 15% of its students withdraw without completing Calculus I course. Assume that 30 students registered for the course. Can we use normal approximation method to calculate #3? .
In a certain jurisdiction, all students in Grade Three are required to take a standardized test to evaluate their math comprehension skills.The file contains these data resulting from a random sample of n=30 schools within this jurisdiction. From these data you wish to estimate the model Yi=β0+β1Xi+ei where Xi is the percentage of Grade Three students in School i who live below the poverty line and Yi is the average mathematics comprehension score for all Grade Three students in the same school, School i. The observed data for the X variable is labled perbelowpoverty and the observed data for the Y variable is labeled mathscore in the file.Import (either hand type or load the file) data into R Studio, then answer the following questions based on the data.(a) Create a scatterplot of the data. What can you say about the nature of the relationship between the percentage of Grade Three students living below the poverty line in a certain school and the school's average Grade Three…
Recently there have been concerns about the effects of phthalates on the devel- opment of the male reproductive system. Phthalates are common ingredients in many plastics. In a pilot study a researcher gave pregnant rats daily doses of 750 mg/kg of body weight of DEHP (di-2-ethylhexyl phthalate) throughout the period when their pups’ sexual organs were developing. The newly born male rat pups were sacrificed and their seminal vesicles were dissected and weighed. Below are the weights for the eight males (in mg). 1710 1630 1580 1670 1350 1650 1600 1650 If untreated newborn males have a mean of 1700 mg, can you say that rats exposed to DHEP in utero have a significantly lower weight?
What are the criteria and steps needed to take to asses the degree in which an independent variable causes changes observed in the dependant variable?