Answered: 4. Draw a boiling point-composition…

4. Draw a boiling point-composition diagram for an ideal binary solution. With the aid of the diagram briefly explain how the pure components could be obtained by fractional distillation.

Macroscale and Microscale Organic Experiments

7th Edition

ISBN:9781305577190

Author:Kenneth L. Williamson, Katherine M. Masters

Publisher:Kenneth L. Williamson, Katherine M. Masters

Chapter5: Distillation

Section: Chapter Questions

Problem 7Q: In fractional distillation, liquid can be seen running from the bottom of the distillation column...

See similar textbooks

Related questions

Q: 9. In which solvent is iodine more soluble? Give experimental evidence that supports your answer.

A: Non-polar solvent diethyl ether should be the best solvent for iodine

Q: The graph of temperature-component mole fraction for Benzene-Ethanol binary system is given in the…

A: Simple distillation is a technique of purification/ separation of liquids in which a liquid is…

Q: Why is rinsing of the burettes both with distilled water and solution a critical step in titration?

A: Please find your solution below : In chemical analysis, titration (volumetric analysis) is a…

Q: In order for the gravimetric analysis to be valid, how do you ensure that all of the chloride ions…

A: Gravimetric analysis is the analysis in which ions from solution is precipitate as a solid ,which…

Q: In a steam distillation, the amount of water actually distilled is usually greater than the amount…

Q: Calculate the boiling point elevation of 0.100 kg of water containing 0.010 mol of NaCl, 0.020 mol…

A: When a solute is added to a solvent, the vapour pressure of solvent decreases and boiling point…

Q: In the ternary phase diagram experiment acetic acid (7.6 mL) and water (1.4 mL) mixture is titrated…

Q: If 0.454g of thyroxine is dissolved in 10g of benzene, the freezing point of the solution could be…

Q: Nitrous acid-observation is gas bubbles Hinsberg test-obsersvation is one layer. THen acid is added…

A: Hinsberg test is a chemical test used to distinguish between primary, secondary and tertiary amines.…

Q: Which component(s) in the water-salt-potassium permanganate mixture i removed by distillation? Which…

Q: The strength of weak solutions or liquid preparations is frequently expressed in terms of strength.

Q: Why must solid remain in constant contact with a solution of sparingly soluble salt in order to…

A: The equilibrium is a phenomenon of reversible reaction. Any reaction's equilibrium constant (K) is…

Q: 7.2. What is the influence on the phase diagram if the atmosphere pressure is changed during the…

Q: Nitrous acid-observation is gas bubbles Hinsberg test-obsersvation is one layer. THen acid is added…

A: Hinsberg test is a chemical tes used to distinguish between primary, secondary and tertiary amines.…

Q: Which of the following statements is TRUE regarding an ideal precipitating reagent? Of unknown…

A: The precipitate is a water insoluble solid product in a chemical reaction.

Q: Why is salt not soluble in isopropyl alcohol?

A: Alcohol can be defined as the organic compound in which hydroxyl group is attached to carbon atom.

Q: What is the rationale of diluting the solution in the flask with washing distilled water at the…

A: Titration is done in neutralization reactions or redox reactions to determine the concentration of…

Q: The vapor pressure of 2-propanol (60.096 g/mol) is 50.00 kPa at 338.8 °C, but it fell to 49.62 kPa…

Q: explain why the boiling point of a two component mixture rises slowly throughout a simple…

A: A temperature is not absolute. When you measure a temperature, you are measuring a distribution of…

Q: 3. A solution of butanoic acid and water (81.6 % water by mass) is heated to 99.4 °C.. The vapor…

Q: Commercial bleaching solutions commonly found on store shelves usually are labeled, "Contains at…

A: Temperature affects the bleach shelf life. Thats why the bleach is stored at somewhat less…

Q: Is it true or false to say that X and Y will form an azeotrope? OFalse OTrue A solution with a mole…

A: An azeotrope is a mixture of two or more liquids which displays the same level of concentration in…

Q: (c) Briefly state the 4 Hume-Rothery rules that give guidelines on the likelihood of substitutional…

A: Hume-Rothery Rules is Related with the condition that determine whether an alloy or impurity element…

Q: What weight of sample must be used in the Mohr method for chloride so that two times the volume of…

A: Here we have to determine the mass of sample used in Mohr's method for chloride if the volume of…

Q: assuming that you distill a mixture of two liquids that initially contains 80% of a and 20% of b…

A: The phase diagram given is,

Q: Why should deionized water he used throughout the analysis?

A: Metal ions are formed by loss of electrons from metal. Electrons are negatively charged particles…

Q: At 90°C, the vapor pressure of pure 1,2-dimethylbenzene (orthoxylene) is 20 kPa and that of pure…

Q: 1. What is the use of boiling chips? 2. List at least 3 limitations of using distillation as a…

A: Hello. Since your question has multiple parts, we will solve first question for you. If you want…

Q: Why a precipitate of manganese dioxide be removed from the potassium permaganate solution before…

Q: Calculate the ionic strength of the plasma-substituting 0.89% NaCl solution, the density of the…

A: We have to find ionic strength of NaCl

Q: How do you choose the most suitable precipitate for gravimetric purposes if given many choices?

A: A precipitate is formed when an insoluble compound is dissolved in a solution when a precipitating…

Q: A solution contains 1.33x10 M silver acetate and 1.11×10 M barium nitrate. Solid ammonium phosphate…

A: A precipitation reaction refers to the formation of an insoluble salt when two solutions containing…

Q: Assume that the solubility of compound X in water is 4.0 g/100 mL and in ether it is 16.0 g/100 mL…

A: Nernst’s distribution law The Nernst’s distribution law suggests that the distribution of a solute…

Q: For a given solution containing an ionic compound, what is the relationship between Q, Ksp and the…

A: Ksp is the solubility product constant and it refers to the level in which the solute gets dissolved…

Q: Why are many ionic precipitates washed with electrolyte solution instead of pure water?

A: The polar substances are the one which is separated by electric charge and leads to the formation of…

Q: If water was used to rinse the burette used to dispense the hydrochloric acid solution, how would…

A: Analytical techniques need precision and accuracy. Errors can occur due to various reasons, personal…

Q: 0.1 g of the mixture of na2so4 and k2so4 is taken and 100 ml of solution is prepared. 10 ml of this…

Q: A compound weighing 0.458g is dissolved in 30.0g of acetic acid. The freezing point of the solution…

Q: A mixture was known to contain three of the four compounds in the table. After the mixture of the…

A: Based on the solubility of the compounds A, B and C in the various solvents such as cold water, hot…

Q: Explain why the boiling point of a two-component mixture rises slowly throughout a simple…

A: Let us take an example of an ideal solution made up of two liquids, as for example benzene (bp 80…

Question

4. Draw a boiling point-composition diagram for an ideal binary solution. With the aid of the diagram
briefly explain how the pure components could be obtained by fractional distillation.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Use a temperature-composition diagram to explain why fractional distillation of two components is more easily accomplished if the components have boiling points that differ by 20C or more.
During the distillation of the Bromobenzene and water mixture which fraction is richer in Bromobenzene: a) First fraction b) Second fraction c) The last fraction d) All fractions have the same composition
Give a fundamental description of the recrystallization process. Explain why it is required and how it can be executed.
List and describe two methods that can used to improve the separation of a liquid mixture by fractional distillation
In a steam distillation, the amount of water actually distilled is usually greater than the amount calculated, assuming that both water and organic substance exert the same vapor pressure when they are mixed that they exert when each is pure. Why does one recover more water in the steam distillation than was calculated? (Hint: Are the organic compound and water truly immiscible?)
Construct an approximate boiling-point-composition diagram for a benzene– methanol system. The mixture shows azeotropic behavior (see Table 15.3). Include on the graph the boiling points of pure benzene and pure methanol and the boiling point of the azeotrope. Describe the behavior on distillation of a mixture that is initially rich in benzene (90%) and then for a mixture that is initially rich in methanol (90%).
In fractional distillation, liquid can be seen running from the bottom of the distillation column back into the distilling flask. What effect does this returning condensate have on the fractional distillation?
7.A student carried out a fractional distillation of an unknown binary (2-component) mixture from a 50 mL pot solution. Based on the plot below, and assuming no azeotropes, what percent by volume was the solution in the lower boiling point component?
Compute for the needed values for slution preparation: 1. Prepare the following solution quantitatively using boiled distilled water per group:250.0 mL 0.0500 M standard HCl solution from 1.0 M HCl 2. a. 500.0 mL 0.1000 M stock EDTA solutionb. 100.0 mL 0.0500 M stock Ca2+ solution
in fractional distillation, how do you tell which liquid is in which fraction and which fraction has a mix of liquids if you are trying to seperate cyclohexane and toluene?? what would the density and boiling point of the first fraction be
The graph of temperature-component mole fraction for Benzene-Ethanol binary system is given in the picture. If you want to purify this binary mixture, which is known to have a 0.8 mole fraction, by simple (ordinary) distillation, what would the mole fraction of benzene in the distillate be approximately (but a reasonable value)?
Students were tasked to conduct a recrystallization experiment to test the ability of the newly discovered solvents in their laboratory to purify and separate a mixture containing compounds X and Y. The solubility of the two compounds in g/50 mL of hot and cold solvents are given by the photo.