Answered: 4. In the circuit shown, what are the…

4. In the circuit shown, what are the directions and magnitudes of the currents flowing through each resistor and the center wire? The positive terminal and emf of each battery is indicated.

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter21: Current And Direct Current Circuits

Section: Chapter Questions

Problem 12CQ

See similar textbooks

Related questions

Q: When a voltmeter is connected across the terminals of a resistor, what usually happens to the…

A: A voltmeter is an instrument that is used to measure the electric potential difference between two…

Q: 2) What is the difference between series connection and parallel connection? Construct a comparison…

A: Difference between the series and parallel connection of the resistance in the circuit.

Q: 3) In the circuit shown, the battery has EMF of ɛ=32 V. At what rate is thermal energy being…

A: Given data, EMF of the battery = 36 V Let, the current is divided into two loops as shown below :-

Q: 4. In the circuit shown in the figure below, the switch S is initially open and the capacitors…

Q: 13. If I double the resistance of a circuit, but leave the electric potential the same, how will the…

A: Introduction: The resistance R is the property of a material to block the passage of current I when…

Q: 57.The current flowing through a 12-Ω resistor is 2A. Determine the potential difference across…

A: Current through resistor, I=2A Resistance of the resistor, R=12Ω Let potential difference be V.

Q: 3. Which of the circuits has the lowest equivalent resistance?

A: (3) Consider circuit A in which the resistors are connected in parallel. The equivalent resistance…

Q: 1. Explain the difference between emf and terminal voltage.

A: Note: As per the guidelines, we can only answer first question of multiple question. Sorry for the…

Q: 1. How would you hook up three resistors in a circuit to get (a) the maximum current and (b) the…

A: if we have n resistors and all are connected in series then its equivalent resistance is given Req =…

Q: 9. From the above picture, the digital multimeter is used for measuring Current * by connecting both…

Q: 2. In the circuit shown in Figure 2, solve the given circuit to find the current through 3 2…

A: We have to apply thevenin and Norton theorem here

Q: 21. The label on a battery-powered radio recommends the use of a rechargeable nickel-cadmium cell…

Q: 6. What happens to the current in a circuit if a 102 resistor is removed and replaced by a…

Q: What will happen to current passing through a conductor if potential difference across it is doubled…

A: What will happen to current passing through a conductor if potential difference across it is…

Q: (3) What similarities and differences do you see from the equivalent resistance and capacitance…

A: Capacitors and resistors are the two different components used in electrical circuits. They have…

Q: 2. Is it possible for a thick wire to have a higher resistance than a thin wire if the two are made…

Q: If a 12 volt battery is supplied to the parallel connection, how much power is consumed by the 7.5…

A: Given data: Two resistors are connected in parallel R1 = 4 Ω and R2 = 7.5 Ω Battery voltage (V) =…

Q: 104. When two identical resistors (say 4 ohm each) are connected in PARALLEL to a 12 V car battery,…

A: Equivalent resistance for parallel combination of resistors is given as:…

Q: 7.Which of the following circuit has a total resistance of 15 2 if the total current in the circuit…

A: To identify : The circuit having a total resistance of 15 ohm if the total current is 3 Ampere

Q: 6. Complete the table using the given three resistors and a power supply below with their respective…

A: Given:- R1 =3 ohm R2 = 9 ohm R3 = 18 ohm V=12 Volt Find:- All the values of voltage and current…

Q: 5. In the circuit shown, 3 0 Determine the following: A. Magnitude and direction of the current B.…

A: Given The circuit diagram and we have to determine magnitude and direction of the current, the…

Q: 4. Explain why, for a parallel resistive circuit, each branch current equals the applied voltage…

A: in this question we discuss about combination of resistance.

Q: 4. Which of the following is not true about parallel connections? a. The electrical devices can be…

A: In parallel connected circuit The voltage drop across all branches is equal to the voltage of…

Q: 4. In the circuit shown in the figure below, the switch S is initially open and the capacitors…

Q: 23. Figure below shows several conductors that carry currents through the plane of the figure. The…

A: The line integral of a magnetic field is equal to the product of permittivity and the current…

Q: 03/ For the circuit shown in figure (2), by using mesh anal ysis, 1- Find the current through the…

Q: .Below is the panel of a Voltmeter that measures voltage in an electrical circuit. Since the unit of…

A: In the figure, we can see there are 10 divisions between 0-5 volts. 10 division = 5 volts 1 division…

Q: 7. In a portable speaker, only 16A of current pass through a copper wire. If the speaker is operated…

A: Write the given values with the suitable variables. I=16 AV=9 V Here, I and V are the current and…

Q: 6. Consider the circuit shown to the right. What is the current flowing through the battery, Ibat,…

A: Here two resistances of values 2R and 3R and connected in parallel. The current from the battery…

Q: 1. What do you mean by emf and what are the factors affecting emf?

A: Since you have mentioned multiple questions and did not specify any number, I will be solving the…

Q: 5. Assume that Circuits A, B, C, and D have identical batteries and convert all of their power to…

A: Heat ∝ Power Lets find the power usage of each circuit:- For circuit A:- All resistance are in…

Q: 25. What is NOT an advantage to using a parallel circuit? a. They have components that get an equal…

A: In parallel circuit one end of all resistors are connected at same point and other ends are…

Q: What is the total current in this circuit? What is the voltage drop across R3? What is the current…

A: Given Data : The Resistance of resistor 1 is given as R1 = 3 Ω The Resistance of resistor 2 is given…

Q: 4 - In the circuit with the resistors R1, R2, and a DC power source, 20 V is observed from the…

A: We need to calculate the current through the ampermeter.

Q: 5. What feature of a river is most similar to current in an electric circuit? (A) The depth of the…

A: The correct answer is option (d).

Q: 2. Given three resistors of different values, how many possible resistance values could be obtained…

Q: 2 Using Kirchhoff's rules on the circuit diagram below, show that the current through the 10-V emf…

A: To show: The current through the 10-V emf is approximately 2.3 A.

Q: 3-What happens to the total resistance in a parallel circuit as more resistors are added in…

A: Given:- 3)What happens to the total resistance in a parallel circuit as more resistors are added in…

Q: %3! Consider the given circuit, if R1 = 12.6 N, R2 = 18.4 N, and R3 = 15.7 N, what is the total…

Q: 2. Three resistors, each with resistance R1, are in series in a circuit. They are replaced by one…

A: given 3 identical resistor R1 equivalent of 3 resistor is R

Q: 2. In the figure below the resistors have resistances of R1 = 225 N, %3D R2 = = = 650 N 475 N, and…

A: Given: R1=225 ΩR2=475 ΩR3=650 Ω

Q: 5-Two resistors of resistances R and 2R are connected in parallel to an ideal battery. If the Power…

A: Power dissipated in a resistor in terms of voltage is given by the relation P…

Q: 3. Why is it important to have a resistor? 4. How does the current get pass through the circuit? 5.…

Q: A certain 20-A circuit breaker trips when the current in it equals 20 A. What is the maximum number…

Q: 3. What happens when you only touch one probe to the resistor / resistive component?

A: ****NOTE : Provide the theoretical data or information or instruction provided along with the…

Q: 5) What happens to the reading of the ammeter if you reverse the connections? The voltmeter?

A: The ammeter has a very low resistance , which can pull of a large amount of current from voltage…

Q: 24. The polarity of a resistor's voltage drop is determined by a) the direction of the current…

A: Let a current flowing through a resistor = I Let the voltage drop across the resistor = V Let the…

Q: 5. How would the current divide in a parallel branch of a circuit containing two resistorsD and R,…

Q: 12) In the circuit shown below, if switch S is closed, then which light bulbs will remain on? L2…

A: When switch S is closed L1, L2, L3 will remain on

Q: 2. Create an illustration of a parallel circuit that connects a battery and five resistors in five…

Question

4. In the circuit shown, what are the directions and
6.000
4.000
magnitudes of the currents flowing through each resistor
and the center wire? The positive terminal and emf of each
battery is indicated.
+
+
20.0V 4.00V
36.0V
10.00

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The human body can exhibit a wide range of resistances to current depending on the path of the current, contact area, and sweatiness of the skin. Suppose the resistance across the chest from the left hand to the right hand is 1.0 106 . (a) How much voltage is required to cause possible heart fibrillation in a man, which corresponds to 500 mA of direct current? (b) Why should rubber-soled shoes and rubber gloves be worn when working around electricity?
Consider the circuit below, (a) What is the initial current through resistor R2? when the switch is closed? (b) What is die current through resistor R2 when the capacitor is fully charged, long after die switch is closed? (c) What happens if the switch is opened after it has been closed for some rime? (d) If the switch has been closed for a time period long enough for the capacitor to become fully charged, and then the switch is opened, how long before the current through resistor R1 reaches half of its initial value?
A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any wires used for connections is negligible, (a) What is the current through the resistor? (b) What is the power dissipated by the resistor? (c) What is the power input from the battery; assuming all the electrical power is dissipated by the resistor? (d) What happens to the energy dissipated by the resistor?
Unreasonable Results (a) What current is needed to transmit 1.00 102 MW of power at 10.0kV? (b) Find the resistance of 1.00 km of wire that would cause a 0.0100% power loss. (c) What is the diameter of a 1.00-km-long copper wire having this resistance? (d) What is unreasonable about these results? (e) Which assumptions are unreasonable, or which premises are inconsistent?
A 240-kV power transmission line carrying 5.00x102. A is hung from grounded metal towers by ceramic insulators, each having a 1.00x 109- resistance. Figure 21.51. (a) What is the resistance to ground of 100 of these insulators? (b) Calculate the power dissipated by 100 of them, (c) What fraction of the power carried by the line is this? Explicitly show how you follow the steps in the Problem-Solving Strategies for Series and Parallel Resistors.
Currents of approximately 0.06 A can be potentially fatal. Currents in that range can make the heart fibrillate (beat in an uncontrolled manner). The resistance of a dry human body can be approximately 100 k . (a) What voltage can cause 0.06 A through a dry human body? (b) When a human body is wet, the resistance can fall to 100 . What voltage can cause harm to a wet body?
Unreasonable Results (a) What current is needed to transmit 1.00 102MW of power at 480 V? (b) What power is dissipated by the transmission lines if they have a 1.00 -resistance? (c) What is unreasonable about this result? (d) Which assumptions are unreasonable, or which premises are inconsistent?
The label on a battery-powered radio recommends the use of a rechargeable nickel-cadmium cell (nicads), although it has a 1.25-V emf, whereas an alkaline cell has a 1.58-V emf. The radio has a 3.20 resistance.(a) Draw a circuit diagram of the radio and its battery. Now, calculate the power delivered to the radio (b) when using a nicad cells, each having an internal resistance of 0.0400 , and (c) when using an alkaline cell, having an internal resistance of 0.200 . (d) Does this differenceseem significant, considering that the radio's effective resistance is lowered when its volume is aimed up?
A large cyclotron directs a beam of He ++ nuclei onto a target with a beam current of 0.250 mA. (a) How many He++ nuclei per second is this? (b) How long does it take for 1.00 C to strike the target? (c) How long before 1.00 mol of He++ nuclei strike the target?
The human body can exhibit a wide range of resistances to current depending on the path of the current, contact area, and sweatiness of the skin. Suppose the resistance across the chest from the left hand to the right hand is 1.0 × 106 Ω. (a) How much voltage is required to cause possible heart fibrillation in a man, which corresponds to 500 mA of direct current? (b) Why should rubber-soled shoes and rubber gloves be worn when working around electricity?
33. A flashlight battery has a rating of 0.8 ampere-hours (Ah) and a lifetime of 10 hours.(a) How much current can it deliver?(b) How much power can it give if its terminal voltage is 6 V?(c) How much energy is stored in the battery in kWh?
For the following circuit R1=R2=60 ohms , R3 = 250 ohms , R4= 325 ohms , R5= 260 ohms, and Vtotal = 35V . What is the total current (It)