40 kips 4 kips/ft 2 kips/ft X C A 8 ft 8 ft 5 ft 400 lb 100 lb/ft A в С 2 ft 8 ft *Е

Q: The top of a ladder weighing 20 kg and 6m long rests against a vertical wall and the foot of the…

A: Answer: The value of X is 1.923574 metres.

Q: Calculate Tension BD if P = 100 kN. ... 1m 2.5 m D 250 N P -1.5 m- 2 m 1.5 m Use the editor to…

A: Find the tension in BD.

Q: Example 10: Determine the resultant of the tensions of the wires shown in figure below. n' 12b 18b 3…

A: Consider below figure for calculation: From the figure, F1 = 18 lbF2 = 17 lbF3 = 12 lbOA ⇀ = ( 2 ,…

Q: H 15 kN 3 m A 3 m A 3 m 2.25 m D 2.25 mA 10 kN

A: calculating reactions at B and E  using conditions of equilibrium, Take sum of all the forces in X…

Q: 4. When unloaded, bars AB and AC are each 36 -in long and have a cross-sectional area of 2 in. Their…

A:

Q: 3 m 5 m F1 C. A weight is hanging on the structure. The weight exerts a force of F1 (5.65x10^2) kN…

A:

Q: Consider the bracket shown in Fig-1. If: • F1 = 10 N@ 120° • F2 = 75 N@ -90° then, what is the…

A: Given: The force, F1 = 10 N The force, F2 = 75 N

Q: 10 N 80 N Ra (400, 200 200, 300 20 N 50 N (200, 500) $400, S00) R, R1 3. A table 600 mm by 600 mm is…

A: Draw a diagram for the problem showing the reactions on each leg. Here, R1, R2, and R3 are the…

Q: Prove the following two equations: Strengh of Material G= K = E 2(1+v) E 3(1-2v)

A:

Q: The weight of the crate is 50 kg and the spring constant is 200 N/m in DB. Use g= 9.81 m/s2.

A:

Q: Find shear stress at point B on the =cross section 10 AN 10 AN 2m 25 mm 10 m 5mm NA Given the…

A:

Q: Question 3 Find the smallest angle 0 for which a sufficiently large force P would cause the uniform…

A: For the given arrangement  To determine  the smallest value of θ for which P would cause the log to…

Q: A door of width 1.8 m can rotate if a moment of 20 Nm is applied. The minimum force that can be…

A: Given data Width = 1.8m Moment = 20 N-m

Q: The bridge has a length of 12 meters with a continuous linear load value at the beginning and end of…

A: Given data L=12 mW=15 N/m

Q: A post is supported by a ball-and-socket joint at O and cables BC and BD. A triangular distributed…

A: Given data, w = Maximum intensity of UVL = 36 N/m rOA = Length OA = 1.6 m rOB = Length OB = 2.5 m…

Q: Find the tension exerted by each cord as shown below. 38° 35° 525N 389 N 62° 550

A: given; T=tention in different cord

Q: Determine the equivalent spring stiffness constant of the following spring in series and parallel.…

A:

Q: Example 10: Determine the resultant of the tensions of the wires shown in figure below. n' 12b 18tb…

A: Solution:

Q: Draw the free body diagram for the two figures below: a) jy A P, 60° 2 2. М в B. a) 2 P 60 4 A 2

A: Mechanical Equilibrium: A body is said to be in mechanical equilibrium if it satisfies the following…

Q: hand written plz i'll upvote Shown in the figures (1) and (2) are trusses containing members that…

A: To choose: The correct option. Given: The modulus of elasticity of material of the members are same…

Q: A person is pulling a weight as shown below. His shoulder joint is not moving, but his elbow joint…

A:

Q: 2000Lbs 30% 60° y A' \ B The bar OA is fully constrained at O and attached to the cable AB.

A: Given Data: The length of bar AB is 20'. The coordinate of point B is (8',16',0). The force in the…

Q: In terms of Poisson's ratio (v), the ratio of Young's modulus (E) to shear modulus (G) of elastic…

A: Dear student,                     According to the guidelines I am allowed to answer only one…

Q: A body of weight 150N rests on an inclined plane as shown in figure 5. What is magnitude of force P…

A: Given, W = 150N co-efficient of friction = 0.3 θ = 10 Free body diagram:   W =mg…

Q: A body is loaded as shown in Figure 2 where P 80 kN and Q = 3 kN. In addition, the following…

A: P=120KNJQ=3kOP →=5i +0j -3k^OQ→ =7i + Oj^-6k^mom due to p=r^ x…

Q: a. b. C. d. 4. The relationship between Young's modulus (E), Bulk modulus (K) and Poisson's ratio…

A: Given data : Youngs modulus=E Poisson ratio=μ Bulk modulus=K   To find the correct relation between…

Q: a. b. C. d. 4.The relationship between Young's modulus (E), Bulk modulus (K) and Poisson's ratio (u)…

A: Young's modulus: The ratio of the normal stress to the longitudinal strain is known as young's…

Q: The top of a ladder weighing 20 kg and 6m long rests against a vertical wall and the foot of the…

A:

Q: 5. The work done by the couple M= (4.5 sin 0) when the rigid bar rotates from 0 = 0 to 0 = 180° is:…

A:

Q: As can be seen in the figure, the first rope pulls a hook attached to the ceiling with a force of…

A: Draw the free body diagram.

Q: Determine the magnitude acting on joint C for the frame shown below. 370 P- 72 N 1.7 m C 2.9 m 490 A…

A:

Q: mparison with the other loads, determine its diameter. Take e factors for bending and torsion as 2…

A:

Q: from the shear stresses data above, DRAW THE SHEAR STRESS DISTRIBUTION DIAGRAM at each point of the…

A: Find the shear stress at each point and shear stress distribution.

Q: 22. The cable AB is subjected to a uniform loading of w = 1000 N/m along the x-direction, as shown.…

A:

Q: A loading condition is shown below. Using Castigliano's theorem and by applying a fictitious force Q…

A: (a) The free-body diagram of the beam BD is given as, Now, apply force equilibrium in a horizontal…

Q: Question 8 Given, a plane flies in a vertical loop as shown. VA = 80 m/s (constant) W = 130 N Find…

A:

Q: Derive

A:

Q: Calculate the reaction force on the B support according to the loading shown in the figure. 4 kN/m 2…

A:

Q: AB represents a uniform horizontal shelf of weight 30N which is at X and Y. Blocks are placed along…

A:

Q: 3 m y 2 m 4 m В E F. AB= F(AB)=tension force in AB F. = F(AD)=tension force in AD AD F =…

A: Given : weight of the flowerpot = W= 40 N To find :Tension force magnitude in rope AE

Q: What would be the maximum weight W of the block, shown in the following figure, so that the tension…

A:

Q: 6.66 Auniform 80-t pipe that weighs 960 lb is supported entirely by a cable AB of negligible weight.…

A: Given:                   Pipe length (L)=80 cm                   Weight(w)=960 kN…

Q: A string 2 m long is tied to the ends of a uniform rod that weighs 60 N and is 1.6 m long. The…

A: Data given-  W = 60 N  AC = CB = 1 m  AB = 1.6 M

Q: A 50.0N weight uniform 4 metre long beam is hanging from a cord held out at a 30° angle as shown.…

A:

Q: 045. A horizontal Y is shown in figure. Determine the X and Y components of the force exerted in the…

A:

Q: In the Figure 3, if m=15 kg and e=30°, then the weight component normal to the block is: * m Figure…

A: For solve this problem, we resolved weight of body which is the product of mass and acceleration due…

Q: (2) The strength condition of composition of bending and torsion is _M₂_ √ M² + (aT)² ≤ [0_16] J.= W…

A:

Q: 3 During free-fall, a parachutist reaches terminal velocity when A) weight equal drag force (B)…

A: Its option is A) weight equal drag force.

Q: What would be the maximum weight W of the block, shown in the following figure, so that the tension…

A:

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.