5- Water flows over a flat surface at 4 ft/s, as shown in Fig. 5. A pump draws off water through a narrow slit at a vol- ume rate of 0.1 ft³/s per foot length of the slit. Assume that the fluid is incompressible and inviscid and can be represented by the com- bination of a uniform flow and a sink. Locate the stagnation point on the wall (point A) and determine the equation for the stagnation streamline. How far above the surface, H, must the fluid be so that it does not get sucked into the slit? 4 ft/s 0.1 ft/s (per foot of length of slit)

5- Water flows over a flat surface at 4 ft/s, as shown in Fig. 5. A pump draws off water through a narrow slit at a vol- ume rate of 0.1 ft³/s per foot length of the slit. Assume that the fluid is incompressible and inviscid and can be represented by the com- bination of a uniform flow and a sink. Locate the stagnation point on the wall (point A) and determine the equation for the stagnation streamline. How far above the surface, H, must the fluid be so that it does not get sucked into the slit? 4 ft/s 0.1 ft/s (per foot of length of slit)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Water flows from a faucet into a sink at 3 U.S. gallonsper minute. The stopper is closed, and the sink has two rectangular overflow drains, each 3/8 in by 1¼ in. If the sinkwater level remains constant, estimate the average overflow velocity, in ft/s.
Pipe A, 30 cm in diameter, branches into two pipes B and C. Pipe B is 15 cm in diameter and pipe C is 7.5 cm in diameter. If the flow in A is divided as follows 2/3 goes to B and 1/3 goes into C, what is the discahrge in pipe A, if the velocity must not exceed 3 m/s in any of the pipes?
A water truck drives slowly around a construction site, spraying water to keep dust down. A pump maintains a constant pressure of 100 kPa, gage, and the water is dispersed through 20 spray nozzles, each of diameter 0.01 m. If the truck is initially filled with 4000 L of water, and the flow rate is constant, determine how long the truck can drive before a refill is necessary in seconds.
Water at a guage pressure of 4 kPa flows at a rate of 250 l/s in a 135° pipe bend of diameter 300 mm, find in MN the magnitude and direction of the resultant force on the bend.
Assume an inviscid, incompressible flow. Also, standard sea level density and pressure are 1.23 kg/m3 (0.002377 slug/ft3) and 1.01 × 105 N/m2 (2116 lb/ft2), respectively. Consider a venturi with a throat-to-inlet area ratio of 0.8, mounted on theside of an airplane fuselage. The airplane is in flight at standard sea level.If the static pressure at the throat is 2100 lb/ft2, calculate the velocity ofthe airplane.
Consider the incompressible flow of water through a divergent duct, where the inlet has a velocity & section area of 5 ft/s & 10 ft2. If the exit area is 5x the inlet area and the density of water is 62.4 lbm/ft3, solve for the pressure difference. (Please type answer no write by hend)
A 30° elbow is used to deflect water flow at a rate of 14 kg/s in a horizontal pipe upward The elbow discharges water into the atmosphere Cross-sectional areas of the elbow are 113 cm^2 at the inlet and 7 cm^2 at the outlet. The elevation difference between the centers of the outlet and the inlet is 30 cm Neglect the weight of the elbow and the water inside the elbow,Using appropriate integral equations, find a) Wet and outset velocity b) Gage pressure at the center of the inlet section of the elbow c) Anchoring force required to hold the elbow In place Take the density of water to be 1000kg/m^3 & the flow is incompressible.
PROBLEM 5: In Lake Geneva (Switzerland), there is a water jet (called the Jet d’Eau) that is discharged 130 m straight upward (measured from the surface of the lake). The exit of the discharge pipe is 20 cm in diameter.
A valve is placed at the downstream end of a 3 kM long pipeline. Water is initially flowing along the pipe at a velocity of 2,5 m/s. what is the magnitude of the surge generated by a sudden and complete valve closure. For water K = 2100 x 106 N/m2 and density, ρ = 1000 kg/m3.
An incompressible fluid (water) flows steadily from an open tank. The elevation of point 1 is 10.0m, and the elevation of point 2 and 3 is 2.00m. The cross-sectional area at point 2 is 0.0680 m^2, at point 3 it is 0.0360 m^2. The area of the tank is very large compared to the cross-sectional area of the pipe. Assuming that Bernoulli’s equation applies, compute: (a) The discharge rate in cubic meters per second;(b) The gauge pressure at point 2.
A pump is being utilized to deliver a flow rate of 500 li/sec from a reservoir of surface elevation of 65 m to another reservoir of surface elevation 95 m.The total length and diameter of the suction and discharge pipes are 500 mm, 1500 m and 30 mm, 1000 m respectively. Assume a head lose of 2 meters per 100 m length of the suction pipe and 3 m per 100 m length of the discharge pipe. What is the required horsepower of the pump? **provide complete solution using bernoullis equation..provide illustration with labels like datum line and such** Show all formula derivation
A pump delivering 0.23 m3/s of water has a 304.8mm diameter suction flange and 254mm discharge flange. The suction pipe is 3.66m long and the discharge pipe is 22.86m long. Neglecting the turbulence losses in the pipe, find: a.) the head which the pump must deliver ( in meters ) b.) the motor power in KW required if the efficiency is 80%, c.) the reynold’s number and type of flow in the suction pipe d.) the reynold’s number and type of flow in the discharge pipe