5.) A cylindrical bucket 150 mm in diameter and 200 mm high contains 150 mm of water. A boy swings the bucket on a vertical plane so that the bottom of the bucket describes a circle of radius 1 m. how fast should it be rotated so that no water will be spilled?

5.) A cylindrical bucket 150 mm in diameter and 200 mm high contains 150 mm of water. A boy swings the bucket on a vertical plane so that the bottom of the bucket describes a circle of radius 1 m. how fast should it be rotated so that no water will be spilled?

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter9: Mass And Mass-related Variables In Engineering

Section: Chapter Questions

Problem 36P: A plugged dishwasher sink with the dimensions of 14 in. 16 in. 6 in. is being filled with water...

See similar textbooks

Related questions

Q: Engineering Mechanics-1 Stage 1 Course: 2020-2021 Example No.2: For the force system shown in…

Q: Consider a double-fluid manometer attached to an air pipe shown in Figure. If the specific gravity…

A: Specific gravity is defined as the ratio of the density of the substance to the density of the…

Q: In the figure, a stone is projected at a cliff of height h with an initial speed of 49.0 m/s…

Q: Suppose that you throw a ball straight up at 10 m/s and release it at 2 m above the ground. (a) What…

A: Given, Initial heighth = 2 m, initial velocityv0 = 10 m/s We know, acceleration due to gravityg =…

Q: The tank shown in the accompanying figure is being filled by pipes 1 and 2. If the water level is to…

A: Given: The diameter of the pipe (1) is d1=2.5 cm. The diameter of the pipe (2) is d2=4.5 cm. The…

Q: 2. A boy is flying a kite at a height of 50 meters. The kite is moving horizontally away from the…

Q: A thin empty frame is hung along side A (see figure). Side A is 1.08 m long and side B is 0.9446 m…

A: Solution: Let m denote the mass of the bullet. It is given as 21.51 g i.e. 0.02151 kg. Let L denotes…

Q: A cylindrical vessel 3m high and 1.5m in diameter is filled with water to a depth of 2.5m. In its…

A: Introduction- A pressure relief valve is a container designed to keep gases or liquids at a pressure…

Q: A ball sinks in a glass of water as shown below. Sketch in the velocity profile of the water at the…

A: Fluid particles move in a particular direction according to the velocity profile of a fluid. It is…

Q: 1. A 1.60m high water tank, three-fourths full of water, has a drain at bottom inclined 18 degrees…

A: Solution Given That Height of water tank= 1.60 m As Given 2gh

Q: Determine the moment of inertia about its horizontal centroidal axis of a T-beam shown. In mmª 600…

Q: An open cylindrical tank 45 cm in diameter and 135 cm tall is full of water and revolved about its…

Q: 6. Water flows through a circular tube with a velocity of 2 m/s. The diameter of the pipe is 14 cm.…

Q: Example A trough of water is 8 meters long and its ends are in the shape of isosceles triangles…

A: Solution constant rate V'= 6 m3/sec h=1.2m

Q: Q2) In the figure shown, find the direction from point M into point P, if you know the direction the…

A: Surveying is the branch of civil engineering including the amount of road scale and construction…

Q: 11. A beaker, partially filled with a liquid is rotated by an angle 30° as shown. If the pressure at…

Q: Determine the moment of Inertia of the quarter of the circle having a radius of óm shown in the…

A: Given- radius of quarter circle is 6 m To find- Moment of inertia with respect to Y axis

Q: a body of 30 metric tons mass is moved la

A: Using relationRighting arm=wxW×ldw=30MTW=5080MTx=10ml=1.2md=0.09m

Q: 5. A student wishes to find the velocity of air flowing through a pipe. He has a pressure gauge…

A: Please refer the attached image for complete solution. THANK YOU.

Q: A circus performer launches himself from a springboard with an initial velocity of 21 m/s at an…

A: Given :- initial velocity is21m/s Angle towards platform is 75° Hanging above ground…

Q: The time taken for the tail end of a train to cross a pole is 53 seconds. If the length of the train…

Q: 5. A long, open-ended cylinder shaped like a plus-sign is inserted vertically down into an open…

A: Fluid mechanics is an antiquated science that alive staggeringly today. The cutting edge innovation…

Q: A horizontal bar, 12 ft long and of negligible weight, rests on rough inclined planes as shown. The…

Q: 1. A rectangular tank is moving horizontally in the direction of its length with a constant…

A: Using formula

Q: 5. SITUATION: Harry and Hermione wanted to measure the length of the field where quidditch is…

A: w (weight of tape per unit length) = 6/50 N/m = 0.12 N/m Lo (length of tape) = 50 m P (applied pull)…

Q: 6) A person on a dock is pulling in at the rate of 1 m/sec a boat by means of a rope. The man's…

Q: 3. An object moves along a straight line with acceleration -8ms?. It starts its motion at the origin…

Q: fluid on the bottom of a tank. Compute the force exerted by the cylinder on the bottom of the tank…

Q: 1. A baseball pitching machine "throws" baseballs with a horizontal velocity v0. Knowing that height…

Q: 28) A cannon ball is fired across a flat field at an angle of 52° with an initial speed of 36 m/s…

A: Given, initial speed v0=36 m/sinitial height H =10mangle θ=520

Q: Ferris wheel is rotating with a constant angular velocity w. What is the direction of the…

A: The direction of angular velocity is perpendicular to the plane of rotating object plane's The…

Q: A snowball rolls off a barn roof that slopes downward at an angle of 40°. The edge of the roof is…

Q: 100 cm a₂

Q: A conical water tower with vertex down has a radius of 14 ftat the top and is 18 ft high. If water…

Q: iv. Determine the distance covered by a body in 4 s if it initial velocity is 20 m/s and the…

Q: 2-) A footbal player wants to throw the ball into the hole which is behind the wall. If she can kick…

A: Applying projectile motion equations formulas to be used, R=vo2sin2θog…

Q: In the figure, a stone is projected at a cliff of height h with an initial speed of 47.0 m/s…

Q: The refrigerator has a weight of 180 lb and rests on a tile floor for which μs = 0.25. If the man…

A: Given weight of refrigerator(w) =180lb μs = 0.25 free body diagram of given figure:-

Q: Suppose the U-tube in figure is not translated but rather rotated about its right leg at 95 rpm.…

A: It is given that, L=18 cmD=5 mm

Q: SITUATION. On a fictionless, horizontal air track, a glider oscillates at the end of an ideal spring…

Q: 6. A ball was thrown straight upward and after 1 second it reaches its maximum height then it does…

Q: 4. An iPhone is thrown vertically upward and returns to earth in 10 sec. How high dio go (in m) and…

Q: 40. A pressure tank is made of a cylinder of diameter 1.2 meters and height of 3 m, and two…

Q: x

A: Solution: Falling Ball Viscometer: The falling Ball Viscometer typically measures the viscosity of…

Q: 3. A closed cylindrical tank, 6 feet in diameter and 12 feet high contains water to a depth of 10…

A: Rotating a closed vertical cylindrical vessel about its central axis is a condition of forced vortex…

Q: An open cylindrical tank having a radius of 0.45 m. is filled with water at a depth of 0.7 m. If it…

Q: Q3) The tank shown in figure Q3 is being filled by pipes 1 and 2. If the water level is to remain…

Q: A stone is dropped from a balloon while ascending at a constant rate of 8.14 m/s and the stone…

Q: A swimming pool whose dimension is width=2650mm Length =11200mm is covered with movable platform .…

A: Given - B=2650mmL=11200mm s=30mm

Q: A bunch of keys is thrown from the top of a 50 m tall building with an initial velocity of 20 m/s.…

Concept explainers

Fluid Materials

In general terms, anything that flows can be termed as a fluid. In other words, a fluid is any substance that cannot resist shear forces and deforms continuously under the application of external shear forces. Fluid materials differ completely from solid materials such as metals and alloys. For instance, if we consider two infinitesimally small cross-sectional areas of fluid materials and solid materials, and apply shear forces to these elements, both the elements will undergo deformation. Upon releasing the shear force, the element of the solid materials will regain its original orientation, but the element of the fluid materials will keep on deforming continuously under the action of the shear force.

Question

Subject: Fluid mechanic Provide complete solution.

5.) A cylindrical bucket 150 mm in diameter and 200 mm high contains 150 mm of
water. A boy swings the bucket on a vertical plane so that the bottom of the bucket
describes a circle of radius 1 m. how fast should it be rotated so that no water will
be spilled?

Branch of science that deals with the stationary and moving bodies under the influence of forces.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A plugged dishwasher sink with the dimensions of 14 in. 16 in. 6 in. is being filled with water from a faucet with an inner diameter of 1 in. If it takes 220 seconds to fill the sink to its rim, estimate the mass flow of water coming out of the faucet.
QUESTION 6 A cylindrical tank, containing water, with a diameter of 3 m and a water level of 5 m is to be drained. Calculate the time taken in minutes to empty the tank for the following , 6.2 A pipe with internal diameter, length, coefficient of friction, of 50 mm, 6 m, 0.008, respectively, and the outlet 2 m below the bottom.
(Fluid mechanics subject) 1. An open rectangular tank mounted on a truck is 5m long, 2m wide and 2.5m high is filled with water to a depth of 2m. C. )If the acceleration is increased to 6m/s^2, how much water is spilled out?
Suppose that you throw a ball straight up at 10 m/s and release it at 2 m above the ground. (a) What maximum height above the ground does the ball reach? (b) How long after you release it does the ball hits the ground?
A rectangular tank that is 5/6 full, has a length of 26cm, height of 20cm and width of 15cm. If the water is transferred to another tank that is 18cm by 9cm by 30cm, how much water will overflow? (1cm^3 =1mL)
A pipe of diameter 20cm is carrying water with a velocity of 3m/sec . calculate the discharge of a pipe bifurcates into two pipes of 10cm each, find the velocity of water in the 10cm diameter pipe
Fluid mechanics- Bernoulli's Equation along a streamline: The flow-metering device shown consists of a stagnation probe at station 2 and a static pressure tap at station 1. The velocity at station 2 is twice that at station 1. Air with a density of 1.2kg/m3 flow through the duct. A water manometer is connected between the stagnation probe and the pressure tap, and a deflection of 10cm is measured. What is the velocity at station 2?
An open cylindrical tank having a radius of 0.36 m. is filled with water at a depth of 0.53 m. If it is rotated about its vertical axis to a velocity of 112 rpm, what should be the height (in meters) so that no water will be spilled out? Round off to two decimal places.
Water enters a large rigid tank steadily at a rate of V . = 0.5 m3/s, and exits through a large rectangular opening through which the velocity changes linearly in the vertical direction from 4 m/s to 5 m/s. Knowing that the tank is full, determine the magnitude of the velocity through the circular opening at the top whose diameter is D = 15 cm.
An open cylindrical tank having a radius of 0.35m and a height of 1.6m is full of water. How fast will it be rotated about its vertical axis if 65% of its volume is spilled out?
A water stream flows into a tank with a diameter of 0.2 m at a flow rate to maintain the water level inthe tank constantly at a height of 0.2 m. From the bottom of the tank, an opening with a diameter of0.01 m allows water to flow out of the tank. Determine the flow rate of the water flowing out of thetank.
ANSWER 3- (i) Write down equations for its position and velocity at time t s.