5. Kerosene (sp.gr. = 0.88 ) enters the cylindrical arrangement as shown on the figure at section 1 at 0.08 /s. The 80 mm diameter plates are 3 mm apart. Assuming steady flow and unit weight of water is 9790 N/ m3 (a) Compute the inlet average velocity Va (b) Compute the outlet volume flux in m/sec (c) Compute the average velocity V2 assuming radial flow in mm/sec D-80 mm 3 mm 4 mm 4 mm

5. Kerosene (sp.gr. = 0.88 ) enters the cylindrical arrangement as shown on the figure at section 1 at 0.08 /s. The 80 mm diameter plates are 3 mm apart. Assuming steady flow and unit weight of water is 9790 N/ m3 (a) Compute the inlet average velocity Va (b) Compute the outlet volume flux in m/sec (c) Compute the average velocity V2 assuming radial flow in mm/sec D-80 mm 3 mm 4 mm 4 mm

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A 6 in. pipe, as shown in the figure, takes water from a reservoir and terminates in a nozzle having a jet diameter of 2 in. Assuming a nozzle loss of 8 percent of the velocity head in the jet, compute the discharge (in S.I. units). Also, make a table showing the elevation head, velocity head, pressure head, and total head at each of the six stations. Lastly, draw the hydraulic gradient line (H.G.L.) & the energy gradient line (E.G.L.).
For the configuration shown in the figure given below, the fluid is ethyl alcohol at 20°C, and the tanks are very wide. The diameter d of the tube is 2.5 mm. For ethanol, take ρ = 789 kg/m3 and μ = 0.0012 kg/m⋅s. Find the flow rate that occurs in m3/h. Take π = 22/7. Determine the Reynolds number of this flow. Take π = 22/7. Yes or No --> Is the flow laminar?
Water at 38°C flows from A to B through 244 m of average 300-mm-I.D. cast iron pipe (∊ = 0.00061 m). Point B is 9.1 m above A, and the pressure at B must be maintained at 138 kPa. If 0.222 m3/s is to flow through the pipe, what must be the pressure at A?
A 12′′ pipe line carries oil of specific gravity 0.811 at a velocity of 80.0 ft/sec. At points A and B, measurements of pressure and elevation were 52.6 psi and 100.0 ft and 42.0 psi and 110.0 ft,respectively. For steady flow, find the lost head between A and B. indicate the free body diagram
Water flows upward in a vertical 300-mm pipe at the rate of 0.222 m /s. At point A in the pipe the pressure is 210 kPa. At B, 4.57 m above A, the diameter is 600 mm, and the lost head A to B equals 1.83 m. Determine the pressure at B. indicate the free body diagram
The figure below shows a gasoline storage tank with cross-sectional area Asub1, filled to a depth h. The space above the gasoline contains air at pressure psub0, and the gasoline flows out the bottom of the tank through a short pipe with cross-sectional area Asub2. Derive expressions for the flow speed in the pipe and the volume flow rate. Thank you!
A centrifugal pump having a head-capacityrelationship given by the equation ha=180 –6.10 X 10-4 Q2, with ha in feet when Q is ingpm, is to be used with the system shownin the figure, For Z2-Z1= 50 ft, what is theexpected flowrate if the total length ofconstant diameter pipe is 600 ft and thefluid is water? Assume the pipe diameter tobe 4 inch and the friction factor to be equalto 0.02. Neglect all minor losses.
Ethyl alcohol flows in the pipe as shown in Figure below of specific weight 19 lb/ft^ 3 . What is the mass flow rate? If viscous effects are neglectedTake the specific weight for mercury equal to 846 and for water equal to 62.4 at 68 F
Water flows from a large tank through an orifice of 75 mm diameter and against a block as shown in the figure. The water jet strikes the block at the vena contrata. The block weighs 223 N and the coefficient of friction between the block and the floor is 0.57. The coefficient of discharge C = 0.60 and its coefficient of contraction Cc = 0.62. What is the minimum height to which water must rise in the tank in order to start the block moving to the right?
Water tower used to supply potable water to a small area which includes 15 houses (Figure 1).Determine water velocity (m/s), diameter size (m), and head losses (m) in BE pipe if you know that thepressure at point B is 200 Kpa, the pipe length is 100 m, and the flowrate is 0.05 m3/s.
Water flows in a horizontal pipe 3.2-in diameter; the diameter of the pipe is reduced to 1.8 in. If the differential pressure between the two sections is 1.28 psi, what is the mass flow rate through the pipe in lbm/s? Neglect losses
Ethyl alcohol flows in the pipe as shown in Figure below of specific weight 49 lb/ft3. What is the mass flow rate? If viscous effects are neglected. Take the specific weight for the mercury equal to 846 and for water equal to 62.4 at 68 0F.