5. Resistivity of the material is defined as the resistance of a piece of the material of length 1.0m and cross-sectional area 1.0 square meter. Conductors have while insulators have _resistivities resistivities. a. large, small b. large, large c. small, small d. small, large

5. Resistivity of the material is defined as the resistance of a piece of the material of length 1.0m and cross-sectional area 1.0 square meter. Conductors have while insulators have _resistivities resistivities. a. large, small b. large, large c. small, small d. small, large

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 5CQ: It was stated that the motion of an electron appears nearly random when an electrical field is...

See similar textbooks

Related questions

Q: Question 12 Which of the following shows how conductors, insulators, and semiconductors rank in…

Q: 5. A copper wire is 2.50 m long and has a diameter of 2.5 mm. How much current will it draw when…

A: Given values: Length of the copper wire, l=2.50 m Diameter, d=2.5 mm Voltage, V=3.0 V Resistivity of…

Q: 2 Determine the resistomce of a bus ban made ot copper if the leng th is 10 metens long and the…

Q: 10) A certain batch of copper wire was found to have a conductivity of 98% at 20°C. What is its…

A: In this question we are given that a batch of copper wire was found to have a conductivity of 98% at…

Q: 3) a) A wire sample (1 mm in diameter by 1 m in length) of an aluminum alloy (containing 1.2% Mn) is…

A: SOlution: Given that d = 1 mmL =1 mV = 432 mVI = 10 Ato find electrical conductivity

Q: Factor 2: Thickness/Diameter Two wires of the same length are shown below. Both are made of good…

Q: 1. Which of the following used to store electrical energy? A. Capacitor B. Diode C. Resistor D.…

A: A charged capacitor stores energy in between its plates. It stores energy in the form of electric…

Q: 10. Calculate the (a) resistivity and the (b) conductivity of a material that has a length of 15 m…

A: Given that length of the material and cross sectional area of the material and also given the value…

Q: Factor 2: Thickness/Diameter Two wires of the same length are shown below. Both are made of good…

Q: Q1 Answer by True or False the following statement 1- Kirchhoff's current law states that the…

Q: 3. A dryer has a power of 5000 W and runs on a 0.5-A current. What is the resistance of the dryer?

A: 3- Given: Power of dryer, P=5000 W Current, I=0.5 A To determine resistance of dryer. Note: It is…

Q: 3.The above graph is a showing the relationship between voltage-current. The resistance calculated…

A: solution as

Q: 23) For the graph shown in the figure, what physical quantity does the slope of the graph represent…

A: Ohms law is used to calculate the unknown resistance or current flowing through a resistor.

Q: (1) If the input voltage is 480 v and the voltage drop is 1.75, what is the output voltage? (2) If…

A: (a) The input voltage or EMF offered, E=480 V potential drop ,v'=1.75 V then, the output voltage ,…

Q: 3) A 100 meters long wire with diameter 2 millimeter is attached to a 6 Volts battery. You measured…

A: Given , Length of the wire, L = 100 m Diameter of wire, d = 2 mm = 2 × 10-3 m…

Q: 3. A 1-km cable consists of 12 identical strands of aluminum, each 3mm in diameter. What is the…

A: Given: The length of the wire is 1 km. The diameter of the wire is 3 mm. The number of strands is…

Q: charge has passed

Q: 5.A lab has a new material they must test in order to determine its nature. Which test will…

A: "Since you have asked multiple questions, as per instructions to us, we will solve the first…

Q: 3. If the current flowing in a certain conductor is 40 mA. a. find the total charge in coulomb and…

A: Given I= 40mA = 40×10-3 A And t= 1.8 sec. We know that charge Q= It and Q= ne Where n= no. Of…

Q: 2. What is the resistivity of the wire?

Q: Ohm's law states that the electric current flowing through a conducting wire, I is directly…

A: Ohms law is used in current electricity to find unknown resistance or current flowing through a…

Q: 3. You have a 12.0-V motorbike battery with a charge capacity of 5000 C and a 12.0-V automobile…

Q: 3. What potential difference must be applied produce a current of 50-mA? across a 2.5-k2 resistor in…

Q: Problem 4: Use the table below to answer the following questions Tempature Coefficients of…

A: Part (a)The resistance of the wire material is,

Q: 5.) A 5.0-meter long tin wire has a cross-sectional area of 2.0 x 10 m2 and a resistance of 0.35 Q.…

A: Write the expression for the resistivity. Here, R represents the resistance, A represents the area,…

Q: 4.) The SMSAT automotive team is assembling a car for the school, and they are trying to work with…

A: We know, Power, P = V I where, P is power, V is voltage and I is current. I = P/V I = 50W/ 24 V =…

Q: ship between resistance, conductivity, length of wire, and area of the wire.

A: Relationship between resistance, conductivity, length of wire, and area of the wire.

Q: Define resistivity of a conductor . Is the resistivity of an alloy lower or higher than that of its…

A: Resistivity : Resistivity of the material is defined as the resistance offered to current flow by a…

Q: 5. An electric heater takes 23.889 kcal in 20 minutes at 200 V. What is the current drawn by the…

A: Time=20 minutes Energy=23889 Cal

Q: 5. What does q means in the derived equation? 6. Is it always positive? 7. What condition/s must be…

A: (1)Here, in the above equation is the; Force is equal to charge multiply electric field. Hence, q is…

Q: 1. Select all of the following that correctly describe what a volt meter and ammeter measure. Select…

A: The voltmeter is a device that is used to measure the potential difference and it is always…

Q: 3. A 200 mn long aluminum wire has the same resistance and cross-sectional area as a carbon wire.…

A: 3. A 200 m long aluminum wire has the same resistance and cross-sectional area as a carbon wire.…

Q: 3. Mei puts in her values and constructs a graph which gives her a slope of 0.0980244ª She then uses…

Q: A four-colored resistor has a resistance of 67,000,000 ohms 5%. What are the colors of the band of…

Q: 3. Mei puts in her values and constructs a graph which gives her a slope of 0.0980244 She then uses…

A: Given data: Slope m=0.0980244 Ωm Area A1=1.306×10-7 m2

Q: Define the term resistance? How it is different from resistivity? What will be the change is…

A: Sol- Resistance : It is the property of the conductor by which it opposes the flow of current…

Q: 1. A wire with a diameter of 0.001 in has an area of how many CM?. Round off your numerical answer,…

A: 1) The given diameter of the a wire is d = 0.001 in Formula used: Area of the circle = πR2…

Q: 2. A resistor has a resistance of 3.20 kQ. A voltage of 12.0 V is applied across the resistor. What…

Q: 1. A silver wire 1.00 mm in diameter transfers a charge of 65.0 C in 1 hr. 15.0 min. Silver contains…

A: Since both questions are different as per Bartleby guidelines we can author only first one. Please…

Q: What basic principles should be observed to stay safe when dealing with electricity or working with…

A: The principles to stay safe when working with electrical equipment are: Test instruments before you…

Q: 1. In this lab you will be calculating the resistivity, you will first need to determine the cross…

Q: 6) In recent class lectures, we discussed the temperature dependence of the electrical resistivity,…

A: Conductors are those materials that have a positive temperature coefficient. Thus, In conductors,…

Q: 2. I-V graph, has a slope of 8, what is the current when the voltage is 10 V ?

A: Given Data : The slope of the I-V graph is given as m = 8. The voltage is given as V = 10V.

Q: Using hand-drawn schematic diagrams, show curves that illustrate the temperature dependence of the…

A: The Graph is giiven below:

Q: Jhea wants to use a glass rod as an insulator. The rod's diameter is 9 mm and its resistivity at 20…

A: Diameter of rod (d) = 9 mm Radius (r) = 4.5 mm = 0.0045 m Resistivity = 10-9 ohm-meter Resistance…

Q: 2. I-V graph, has a slope of 8 , what is the current when the voltage is 10 V ? 20 120.

Q: 1. In this lab you will be calculating the resistivity, you will first need to determine the cross…

A: Since you have asked multiple que, we will solve the first question for you. If you want any…

Question

5. Resistivity of the material is defined as the resistance of a piece of the material of length
1.0m and cross-sectional area 1.0 square meter. Conductors have
while insulators have ,
a. large, small
_resistivities
resistivities.
b. large, large
c. small, small
d. small, large

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

What is the resistance of a 20.0-m-long piece of 12-gauge copper wire having a 2.053-mm diameter?
A potential difference of 12 V is found to produce a current of 0.40 A in a 3.2-m length of wire with a uniform radius of 0.40 cm. What is (a) the resistance of the wire? (b) The resistivity of the wire?
How does the resistance for copper and for silicon change with temperature? Why are the behaviors of these two materials different?
The current through a 12-gauge wire is given as I(t)=(5.00A)sin(260Hzt)). What is the current density at time 15.00 ms?
1. Calculate the (a) resistivity and the (b) conductivity of a material that has a lengthof 15 m and a cross-sectional area of 5 × 10–8 m2 and a resistance (R) of 5 Ω.
4. What is the temperature coefficient of resistance of a piece of wire having a resistance of 11.56 Ω at 25 C and 10.22 Ω at 0 C? What will be its resistance at 50 C?
6.Which of the following refers to the resistance offered by the material directly proportional to the lenght of the conductor and inversly to its cross sectional area? A.Conductivity B.Elasticity C. Electricity D.Resistivity
2) A wire has a diameter of 10mm, length 50m and resistivity 3.8 x 10^-8 ohm metres. What is the resistance of the wire?
3) What causes resistivity in ordinary conductors? Why (and in what way) does the resistivity change if the temperature decreases.
1. The resistance of a wire of length 10 m is 2 ohm. If the area of cross section of the wire is 2 × 10–7 m2, determine its (a) resistivity, and (b) conductivity 2. Calculate the (a) resistivity and the (b) conductivity of a material that has a length of 15 m and a cross-sectional area of 5 × 10–8 m2 and a resistance (R) of 5 Ω.
1. A total of 620 C of charge passes through a flashlight in 0.550 h. What is the average current? this is not an will not be graded
5. Originally, a circuit contains four (4) identical resistors in series across a battery. If oneresistor is removed, what happens to the value of total current, total resistance andtotal voltage? Express the new quantities in terms of the original quantities