i need the answer quickly 6 Find the convolution between x.(t) and hittAXCU4 h(t)st....#-1(y(t) = x(t) @ htt), the find y(W); check the resultby using convolution property of .F.T.2Ans: Yow) = 4 sinc (W)<-244 y(t)2

Given, The signal x(t) is given below, The signal h(t) is given below,

Answered: 6 Find the convolution between X(t) and…

6 Find the convolution between X(t) and hit! AXU 4 h(t) st. # -1 y(t) = x (t) htt), the find yew), check the result by using convolution property of.F.T. 2 Ans: Y(u) = 4 sinc (W) -2 4 4 y(t) 2 18

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Explain the faults in transformer. Explain the construction and working principle of Buchhloz Relay

A: Currents caused by a failure on a transformer winding depend on the source, neutral grounding…

Q: 10.23. Draw the block diagrams of both the direct forms I and II simulation diagrams for the systems…

Q: What is the magnitude of the force required to stretch a 10 cm-long spring, with spring of 100 N/m,…

A: here we have to find the force required to stretch the 10 cm long spring , with spring constant of…

Q: 2- A message signal given by m(t) = 3 cos (400 t+n/2) is sampled with the minimum sampling rate…

A: As per the guidelines of bartleby i need to answer first three subparts only so kindly repost other…

Q: What is wrong with this circuit? V₁ 24 V R₁10 kn D₁ 1N4744A 15 V 4.790 VR₂2.5 k RL

A: The given circuit diagram is shown below:

Q: Explain solar PV and wind farm behaviour during grid distribution

A: Type of Renewable energy resources Wind energy solar energy Hydro energy Biomass energy Tidal…

Q: AM spectrum consists of

A: The correct option along with the explanation is provided in the following section.

Q: 5. Two point particles, one with charge +8 × 109 C and the other with charge -2 × 10⁹ C, are…

A: Given data : One charge q1=8×10-9C Other charge q2=-2×10-9C Distance between charge d=4m

Q: a) [ Explain in your own words how we can choose the state variables of a system. Justify your…

A: Transfer function is defined as the ratio of output to input with zero initial conditions. The…

Q: a. A 55-hp, 550-V shunt wound motor draws a line current of 5 A at no load. The shunt field…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: _X(t) = sint t>o, h(t) = S(t) — S. (t-π) sint ostet 4 y(t) sint Ans y(t) = elsewhere 71

Q: Hi RZ

Q: A system with unitary feedback is shown in Figure 2, where R(s) and Y(s) stand respectively for…

A: Given data : The open loop transfer is, Gs=10s+4ss+1s+2s+5 Unity feedback Hs=1

Q: 9. Which of the following equation represents mass semiconductors in electronic circuits? action law…

Q: 1. The circuit shown below is a dc model of a residential power distribution circuit. Use the…

Q: Calculate the steps in a 5-section rotor starter induction motor. for a 3-phase Maximum starting…

Q: Design an astable 555 timer circuit to produce 1kHz square wave, where TH = 0.35 ms and TL = 0.65…

A: Given data, The value of TH is 0.35 ms, The value of TL is 0.65 ms, The value of the Capacitor(C)…

Q: Design a non inverting Schmitt trigger circuit with VT to be adjustable from = 5 V to 10 V.

A: Solution- Non inverting schmitt trigger is given by, from KCL, Vx-VinR1+Vx-V0R2=0VxR1+R2=VinR2+V0R1…

Q: 6. a. What is the equivalent resistance between points 1 and 2 of the circuit shown is. b. If at…

Q: A voltage-multiplier has a Vm = 60 V peak sinusoidal secondary voltage. During the positive…

Q: Discuss the important requirements to be satisfied by protective system

Q: (+ -15V 15V U1 VEE 741

A: Given data, Input is given, vi=12V, 6 V, 0 V, -6 V,-12 V Circuit diagram is given as,

Q: a) If the channel length is tripled, determine what happens to the transport time assuming diffusive…

A: Let the length of channel is l Velocity is v

Q: A CMOS inverter with minimum sized transistors has K₂ = 100 µA/V², Kp = 50 µA/V² and V™n = |VT|= 0.6…

A: For the given inverter we need to calculate the value of inverter switching threshold voltage.

Q: FE h-off voltage Vpi

A: Given as, VGSoff=-4

Q: alent circuit for the network in fig 4. through terminals A B and C in fig 5. ΚΩ C 15 Ω 100 V 7Ω 11…

A: For the given electrical circuit we need determine its thevenin equivalent circuit for node A B.

Q: R(5) K G(S) (5+2) (5+3) [S+5) (S+20) H(S) = 1 ((s)

Q: Determine the value of ix and V. 20/30° V 60Hz 10 92 ww ΤΗ m 0.1 F 0.5 H V

Q: A Step-Down Transformer. A transformer connected to a 120 V (rms) ac line is to supply 12.0 V (rms)…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Find Transfer Function of given network in Fig. P. 2.9.6. 1₁ R₂ Ip V₁₂1₂=0 b V;(s) R₁ www R₂ V₂ www…

Q: Consider the following differential equation; d³y dr 3 di dt d³x =2 +4 dt -+9x dt Derive the…

Q: Determine the gain, vo/vi, for the ideal op-amp circuit shown in Figure 3.

Q: In all the topics presented and discussed in your Instructional Materials, what do you like the most…

A: BJT is a current controlled Device in which base current control the mode of operation of BJT. Mode…

Q: (a) € (11 Determine the Laplace transform of the signal x(t) in Figure Q1(a) and state its region of…

Q: A 150 V, 1400 rpm shunt DC motor is used to supply rated output power to a constant torque load. On…

Q: Find the output voltage for the following circuit. ( TOMA 15ks M 5 ksv 30k 25kr ww ww loke till…

Q: What is the turns ratio of the transformer needed to match a 1 k source resistance to a 160 load?…

A: We need to find out the turn ratio for given load resistance

Q: In below Figure, two forces F1, and F2, act on a 5 kg object that is initially at rest. If the…

A: The resultant of the above forces is given by the vector addition rule, Fres=F12+F22+2F1F2cosθ…

Q: 7. Space diversity s also known as

A: The solution is provided in the following section.

Q: Notes Convert 100 watts of power into dBW? Show all steps Done

Q: 14.a. A clothes dryer in a one-family dwelling is rated at 6,000 VA. What's the demand load on the…

Q: GROUP 8 LRC series circuit connected in series with resistance of 4 ohms, a capacitor of 26 farad…

A: For the above given series RLC circuit we need to calculate the value of current flow in the…

Q: R1 R2 wwwwwww C1 R3

Q: semiconductors in electronic circuits

Q: Calculate the emitter current and collector current if the current amplification factor, a = 0.96…

A: Given data, Current amplification factor, α=0.96 Base current, IB=90 μA

Q: D1.8. Transform the following vectors to spherical coordinates at the points given: (a) 10a, at P(x…

A: It is given that: a) 10ax at Px=-3,y=2,z=4b) 10ay at Qρ=5,ϕ=30°,z=4c)10az at Mr=4,θ=110°,ϕ=120°

Q: Determine the value of ix and V. 20230° V 60Hz 10 92 ww ΤΗ m 0.1 F 0.5 H V

Q: Determine the values of 11, 12, 13, 14 in the circuit below in terms of current I. From the circuit…

Q: Calculate the bandwidth and baud rate for an FSK signal with mark frequency 34 kHz, space frequency…

A: Given a FSK signal,Mark frequency= 34kHZ Space frequency = 26Khz…

Q: Derive the expression for power developed due to wind energy

A: Let v is the speed of wind, d is the height of the blade, Cross section area of blade is given by,…

Question

i need the answer quickly

6 Find the convolution between x.(t) and hitt
AXCU
4 h(t)
st....
#
-1
(
y(t) = x(t) @ htt), the find y(W); check the result
by using convolution property of .F.T.
2
Ans: Yow) = 4 sinc (W)
<-2
4
4 y(t)
2

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A)Perform the N=5 point circular convolution of x and h using DFT. B)Perform the N=5 point circular convolution of x and h in time-domain.
If r(t) = < 8cos t, 8sin t, 12t >, find the i-component of its principal unit normal, N at t = π/2.
Determine the Th´evenin equivalent of the circuit inFig. P7.48 at terminals (a, b), given thatυs(t) = 12 cos 2500t V,is(t) = 0.5 cos(2500t − 30◦) A.
A system has the following characteristic equation: s + s + 3 + 2s + 2 = 0 Using the Routh-Hurwitz method, check
find the derivative expression for i(t),Vl(t), and Vc(t). Then solve given the different numbers in the cases.
Graph the following functions for the given x[n]= {…,0,2,-2,0,1,3,-2,-3,1,-1,0,…} signal. a) y[n]=x[n](u[n+3]-u[n-2])-2∂[n]+3∂[n-3]x[n b) y[n]=2x[-n]+(x[n])²+x[-n+2]
For the circuit shown below, the initial conditions are zero, Idc is a current source continuous and switch S is open at t = 0.a)Determine the equivalent impedance to the right of points a and b of the circuit, Z(s).b)Obtain the voltage between points a and b of the circuit in the frequency domain, V(s). Employ the initial and final value properties and calculate the values of v(0) and v(∞).c)Find the expression for v(t). Check that the values of v(0) and v(∞) agree with those calculated in the previous item.d)Obtain currents i1(t) and i2(t).
given that vc=q/C. derive the expression for q in terms of time t.
: If F(s) = s 4+ 5s3+20s 2 + 40s + 50 , Investigate the stability of this system
The antiderivative of f(x), denoted by F(x), exhibits an odd symmetry i.e., it satisfies the property F(-x) = -F(x). If , determine which of the following is true. [Assume both f(x) and F(x) are defined for all real values of x.]
The characteristic equation of a system is given by S5+2S4+S3+2S2+S+5=0 Determine (i) Stability of the system (ii) Number of roots on the right side of 's' - Plane (iii) Number of roots on the left side of 's' - Plane
If x(n)={1, 2, 0, -1} and h(n)={1, 2, 0, -1} find y(n). don't care where n=0.