8. Mars is known as the "Red Planet" because of the red color of its soil. The red soil is rich in iron oxide (rust) caused by thousands of years of oxidation changing the iron in the soil to rust. This process on Mars is an example of a -- A physical change B chemical change C both A and B D neither A or B

8. Mars is known as the "Red Planet" because of the red color of its soil. The red soil is rich in iron oxide (rust) caused by thousands of years of oxidation changing the iron in the soil to rust. This process on Mars is an example of a -- A physical change B chemical change C both A and B D neither A or B

World of Chemistry, 3rd edition

3rd Edition

ISBN:9781133109655

Author:Steven S. Zumdahl, Susan L. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan L. Zumdahl, Donald J. DeCoste

Chapter2: Matter

Section: Chapter Questions

Problem 25A

See similar textbooks

Similar questions

A hot metal block is plunged into water in a well-insulated container. The temperature of the metal block goes down, and the temperature of the water goes up until their temperatures are the same. A total of 1500 J of energy' is lost by the metal object. By how much did the energy of the water increase? What law of science is illustrated by this problem?
58 Magnesium will burn in air to form both Mg3N2 and MgO. What mass of each product would be found if burning a 3.11-g sample of magnesium to completion produces a combined total of 5.09 g of the two products?
9.90 Many engineering designs must incorporate ways to dissipate energy in the form of heat. Water evaporators are common for this task. (a) What property of water makes it a good material for evaporators? {b} If an application could not use water, hut instead was forced to use a material with a value for the property in part (a) that was one half that of water, what changes would need to be made in the design?
The flashlight in the photo does not use batteries. Instead, you move a lever, which turns a geared mechanism and finally results in light from the bulb. What type of energy is used to move the lever? What type or types of energy are produced?
You have two distinct gaseous compounds made from element X and element Y. The mass percents are as follows: Compound I: 30.43% X, 69.57% Y Compound II: 63.64% X, 36.36% Y In their natural standard states, element X and element Y exist as gases. (Monatomic? Diatomic? Triatomic? That is for you to determine.) When you react gas X with gas Y to make the products, you get the following data (all at the same pressure and temperature): 1 volume gas X + 2 volumes gas Y 2 volumes compound I 2 volumes gas X + 1 volume gas Y 2 volumes compound II Assume the simplest possible formulas for reactants and products in the chemical equations above. Then, determine the relative atomic masses of element X and element Y.
You have a chemical in a sealed glass container filled with air. The setup is sitting on a balance as shown below. The chemical is ignited by means of a magnifying glass focusing sunlight on the reactant. After the chemical has completely burned, which of the following is true? Explain your answer. a. The balance will read less than 250.0 g. b. The balance will read 250.0 g. c. The balance will read greater than 250.0 g. d. The scales reading cannot be determined without knowing the identity of the chemical.
You have two distinct gaseous compounds made from element X and element Y. The mass percents are as follows: Compound I: 30.43% X, 69.57% Y Compound II: 63.64% X, 36.36% Y In their natural standard states, element X and element Y exist as gases. (Monatomic? Diatomic? Triatomic? That is for you to determine.) When you react gas X with gas Y to make the products, you get the following data (all at the same pressure and temperature): 1. volume gas X + 2 volumes gas Y2 volumes compound I 2. volumes gas X + 1 volume gas Y2 volumes compound II Assume the simplest possible formulas for reactants and products in the chemical equations above. Then, determine the relative atomic masses of element X and element Y.
A particulate-level illustration of the reaction AB+CDAD+CB is shown below. a Identify the reactants and products in this reaction. b Is the change shown chemical or physical? c Is the mass of the product particles less than, equal to, or greater than the mass of the reactant particles? d If the reaction takes place in a container that allows no energy to enter or leave, how does the total energy in the container after the reaction compare with the total energy in the container before the reaction?
How many joules of heat are lost by 3580 kg of granite asit cools from 41.2°C to -12.9°C? The specific heat ofgranite is 0.803J/(gC) .
During a recent winter month in Sheboygan, Wisconsin, it was necessary to obtain 3500 kWh of heat provided by a natural gas furnace with 89% efficiency to keep a small house warm (the efficiency of a gas furnace is the percent of the heat produced by combustion that is transferred into the house). (a) Assume that natural gas is pure methane and determine the volume of natural gas in cubic feet that was required to heat the house. The average temperature of the natural gas was 56 F; at this temperature and a pressure of 1 atm, natural gas has a density of 0.68 1 g/L. (b) How many gallons of LPG (liquefied petroleum gas) would be required to replace the natural gas used? Assume the LPG is liquid propane [ C3H8 : density, 0.5318 g/mL; enthalpy of combustion, 2219 Id/mo for the formation of CO2(g) and H2O(l) ] and the furnace used to burn the LPG has the same efficiency as the gas furnace. (c) What mass of carbon dioxide is produced by combustion of the methane used to heat the house? (d) What mass of water is produced by combustion of the methane used to heat the house? (e) What volume of air is required to provide the oxygen for the combustion of the methane used to heat the house? Air contains 23% oxygen by mass. The average density of air during the month was 1.22 g/L. (f) How many kilowatt—hours ( 1kWh=3.6106 J) of electricity would be required to provide the heat necessary to heat the house? Note electricity is 100% efficient in producing heat inside a house. (g) Although electricity is 100% efficient in producing heat inside a house, production and distribution of electricity is not 100% efficient. The efficiency of production and distribution of electricity produced in a coal-fired power plant is about 40%. A certain type of coal provides 2.26 kWh per pound upon combustion. What mass of this coal in kilograms will be required to produce the electrical energy necessary to heat the house if the efficiency of generation and distribution is 40%?
When corn is allowed to ferment, the fructose in the corn is converted to ethyl alcohol according to the following reaction C6H12O6(aq)2C2H5OH(l)+2CO2(g)(a) What volume of ethyl alcohol (d=0.789g/mL) is produced from one pound of fructose? (b) Gasohol can be a mixture of 10 mL ethyl alcohol and 90 mL of gasoline. How many grams of fructose are required to produce the ethyl alcohol in one gallon of gasohol?
A 5.00g sample of sand and salt is 75.0%w/w salt. How many grams of salt and sand are in the mixture?