7. Measure the length, width, and height of each block using a ruler. Under each block you'llfind the mass, what is the density of each block? Write the density below the block.Block 1- Mass = 98.6 gDensity =Block 2 - Mass 147.5 gDensity =8. The initial volume of water in a graduated cylinder is 2 ml. An irregularly shaped,i.stone was lowered into this graduated cylinder and the height of the water rose to 7ml. If the mass of the stone is 25 g, what is its density?

Given Volume of the water Vw = 2 ml Volume of the water and the stone combined Vsw = 7 ml Mass of…

Answered: -8. The initial volume of water in a…

Inquiry into Physics

8th Edition

ISBN:9781337515863

Author:Ostdiek

Publisher:Ostdiek

Chapter4: Physics Of Matter

Section: Chapter Questions

Problem 7P: A large chunk of metal has a mass of 393 kg, and its volume is measured to be 0.05 m3. (a) Find the...

See similar textbooks

Similar questions

(I) State your mass and then estimate your volume. [Hint: Because you can swim on or just under the surface of the water in a swimming pool, you have a pretty good idea of your density.]
Problem 3. Pascal’s Principle A hydraulic lift is supporting a car of mass 1 000 kg. If the cross-sectional area of the smaller chamber is 1 m2 and that of the bigger chamber is 4 m2, what force can be applied on top of the movable piston on the smaller chamber to support the car at the bigger chamber? Give the following and encode it please. This is not a writing assignment Given = Required = Formula = Solution = Answer =
A standard can of soda has a volume of 355 mL. The mass of the can is 0.369 kg when it is full, while the can weighs 0.153 N when empty. Determine the density, specific weight, and specific gravity of the soda, and compare your results to the corresponding values for water.
Please answer parts B, C and D! A beachball has a diameter of 24 cm and weighs about 6N. A-What is the volume of the beachball? Then, use this number to calculate the beachball’s average density in kg m-3. B-What is the volume of water displaced by the beachball if it is in the pool? C- Now, using a rope, you tie the beachball to the bottom of the pool so only half of the ball is submerged. What would the diagram look like? D- What is the buoyant force of the tethered beachball? What is the tension on the rope?
what is the correct equation for pressure based on force and area? P=FA m=F/A P=F/A or F=mA
A sylo can contain 3.75*10^4 lb of liquid. (a) What volume would this much water take?
Part A : What is the volume of the block? Part B: What is the density of the block? Part C: Comparing your finding with the web and comment what material is the block made of? Part D: What is the density of the oil? Comment on the type of oil too.
What is the minimum weight (in lbs) a bowling ball with diameter of 8.5 inches would need to have in order to sink in water (density of water is ~ 1.0 g/mL)? Assume that the volume of the bowling ball can be calculated as the volume of a sphere. Report your answer to the correct number of significant figures.
1. What is the relationship between density, specific gravity, mass, and volume? 2. What is the relationship between pressure to area and force? 3. What is the relationship of pressure to fluid density and depth?
Workout the problem What is the Density that an object has if it’s Mass is 128 Kilograms and its Volume is 63 cm3?
Please answer as much as you can! Thank you in advance! A beachball has a diameter of 24 cm and weighs about 6N. A-What is the volume of the beachball? Then, use this number to calculate the beachball’s average density in kg m-3. B-What is the volume of water displaced by the beachball if it is in the pool? C- Now, using a rope, you tie the beachball to the bottom of the pool so only half of the ball is submerged. What would the diagram look like? D- What is the buoyant force of the tethered beachball? What is the tension on the rope?
For the tank in Figure 1, a. Calculate the depth of the oil if the depth of the water is 2.80 m and the gage at the bottom of the tank reads 52.3 kPa. b. Calculate the depth of the water h2 if the pressure gage at the bottom reads 158 kPa. The total depth hT = 18.0 m.

SEE MORE QUESTIONS

Recommended textbooks for you

Inquiry into Physics

Physics

ISBN:

9781337515863

Author:

Ostdiek

Publisher:

Cengage

Inquiry into Physics

Physics

ISBN:

9781337515863

Author:

Ostdiek

Publisher:

Cengage

SEE MORE TEXTBOOKS

-8. The initial volume of water in a graduated cylinder is 2 ml. An irregularly shaped ... stone was lowered into this graduated cylinder and the height of the water rose to 7 ml. If the mass of the stone is 25 g, what is its density?