A 2.49 kg block is held in equilibrium on an incline of angle q = 53.0o by a horizontal force, F, applied in the direction shown in the figure below. If the coefficient of static friction between block and incline is ms = 0.326, determine the minimum value of F. Determine the normal force of the incline on the block.

A 2.49 kg block is held in equilibrium on an incline of angle q = 53.0o by a horizontal force, F, applied in the direction shown in the figure below. If the coefficient of static friction between block and incline is ms = 0.326, determine the minimum value of F. Determine the normal force of the incline on the block.

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter5: Displacement And Force In Two Dimensions

Section: Chapter Questions

Problem 1STP

See similar textbooks

Similar questions

Draw the FBD of this problem.An object weighing 95 N is suspended by two wires, the left wire makes an angleof 37 0 with the vertical while the right wire is projected 26 0 with the horizontal.Find the tension in each wire.
A 2.00 kg block is held in equilibrium on an incline of angle θ = 65° by a horizontal force applied in the direction shown in the figure below. If the coefficient of static friction between block and incline is μs = 0.300, determine the following. (a) the minimum value of N(b) the normal force exerted by the incline on the block N
A bag of cement of weight 325N hangs from three wires as shown below. Two of the wires make angles θ1 = 60o and θ2 = 40o with respect to the horizontal. If the system is in equilibrium, what are the three tension forces in the wire?
A block of weight W=100 is on a rough plane inclined at an angle of 30 degrees with the horizontal. The magnitude of the normal force N1 and the friction F1 when the block is in equilibrium. If the plane was frictionless, find the magnitude of the horizontal force F1, required to keep the block in equilibrium.
Using the same force table that you used, a student was given two forces and asked to find a single force that would produce equilibrium with the two forces. The two forces were given by providing one of the components and the angle the force made with the positive x- axis. The two forces were as follows: Force 1: Fx = −2.70 N; Theta = 220.0 degreees Force 2: Fy = 3.20 N; Theta = 60.0 degrees (a) For each force, calculate the magnitude of the force and the mass required to produce it. (b) Calculate the mass and its angle of application to produce equilibrium with these two forces. Please specify your angle as counterclockwise positive with respect to the positive x-axis.
A large wrecking ball is held in place by two light steel cables as shown in figure. If the mass m of the wrecking ball is 4200 kg, what are the tensions TB in the cable that makes an angle of 40° with the vertical and the tension TA in the horizontal cable?
A box on a 15-degree incline weighs 350N. Given that the system is in static equilibrium and us = 0.55 and uk = 0.42.a. what's the normal force (N) magnitude and what's its angle of direction with respect to the positive x-axis?b. what's the frictional force magnitude and it's angle of direction with respect to the positive x-axis?Now, a rope creates a tension T to pull the box in the direction 30 degrees upward with respect to the incline. This makes the box impending to slide.c. what's the magnitude of Td. what's the magnitude of N
A telephone pole is supported by a guy wire which exerts a pull of 300 N on the top of the pole. If the angle between the wire the pole is 60 degrees, what is the vertical component of the pull on the pole?
A student creates a beam bridge for a project, suspends masses from the bridge, and spans the bridge across two surfaces, as pictured below. What is the best approximation for the normal force applied on the bridge’s surface from PylonA? (A)About 0.8N (B)About 1.2N (C)About 1.4N (D)About 2.0N
Two masses mA =9.3kg and mB=6.1kg are on inclines and are connected together by a string as shown in the figure. The angles theta subscript A=700 and theta subscript B = 360 . In the absence of the friction, the force F is required to pull the masses at a constant velocity up the fixed inclines. The force F is now removed. What is the magnitude of the acceleration of the two blocks? Take g =9.81 m/s2, and express your answer using two decimal places.
A persons head is bent over her book. The head weighs P=37.2 N and is supported by the muscle force F m exerted by the neck extensor muscles and by the contact force F c exerted at the atlantooccipital joint. Given that the magnitude of F m is 60.0 N and is directed 35.0 degree below the horizontal. Find the magnitude of the contact force F c.
A bag of cement with a mass of 100kg hangs in equilibrium from three wires as shown in the figure . Two of the wires make angles θ1=40 and θ2=30 with the horizontal. Assuming the system is in equilibrium, a. What is the magnitude of tension in string 1 b. What is the magnitude of tension in string 2