A 203-V battery, an inductor, and a resistor are connected in series as shown in the diagram below. A two-way switch makes it possible to include or exclude the battery. The switch that had been in position 1 for a long time is suddenly moved to position 2. (Enter your answers to at least two decimal places.) le AV (i) (ii) (a) What is the voltage across the resistor at the end of five time constants? (b) At this time, what is the voltage across the inductor? V

A 203-V battery, an inductor, and a resistor are connected in series as shown in the diagram below. A two-way switch makes it possible to include or exclude the battery. The switch that had been in position 1 for a long time is suddenly moved to position 2. (Enter your answers to at least two decimal places.) le AV (i) (ii) (a) What is the voltage across the resistor at the end of five time constants? (b) At this time, what is the voltage across the inductor? V

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 52P: In Figure 14.12, =12V , L = 20 mH, and R=5.0. Determine (a) the time constant of the circuit, (b)...

See similar textbooks

Similar questions

An inductor is connected across the terminals of a battery. Does the current stance of the battery? Does the time required for the current to reach its final value depend on this resistance?
Do Kirchhoff’s rules apply to circuits that contain inductors and Capacitors?
When the current through a large inductor is interrupted with a switch, an are appears across the open terminals of the switch. Explain.
A circuit contains a 9 V battery, a 5 MΩ resistor, a 10 H inductor, and a switch. When the switch is closed, what isthe current in the circuit after 1 μsec?
A 9.5-V battery, a 5.07-Ω resistor, and a 9.8-H inductor are connected in series. After the current in the circuit has reached its maximum value, calculate the following.
0.2 H inductor and 146 ohm resistor are connected to a 12V battery. When will the current will reach 84% of its final value ??
The square loop in FigureP20.62 is made of wires with atotal series resistance of 10.0 Ω.It is placed in a uniform 0.100-Tmagnetic field directed perpendicularinto the plane ofthe paper. The loop, which ishinged at each corner, is pulledas shown until the separationbetween points A and B is 3.00 m. If this process takes 0.100 s,what is the average current generated in the loop? What is thedirection of the current?
In the circuit shown in Fig., neither the batterynor the inductors have any appreciable resistance, the capacitors are initiallyuncharged, and the switch S has been in position 1 for a very longtime. (a) What is the current in the circuit? (b) The switch is now suddenlyflipped to position 2. Find the maximum charge that each capacitorwill receive, and how much time after the switch is flipped it willtake them to acquire this charge.
A piece of electrical component inside a gaming laptop uses a source of electromotive force, resistor, and inductor. If the voltage, resistance, and inductance are 4 volts, 2 ohms, and 1 henry, respectively, what is the current along the circuit after 2 seconds when the initial current applied to the circuit is 0.6 amperes? Assume Kirchhoff's Voltage Law applies which states that travelling around any loop/circuit, the gains and losses of voltage across the elements add up to zero. Do not round off intermediate steps. Round off the final answer to two decimal places.
A solenoid with 35 x 103 turns per meter, a cross sectional radius of 0.6 m, and a length of 0.2 meters is used as to form an inductor. Then a 8 x 103 volt battery (DC) is connected in series to this inductor, a resistor of 4 kilo-Ohms, and another resistor of 8 kilo-Ohms. After 13 milli-seconds, what is the power output of the battery in kilo-watts?
If the capacitors as shown are replaced by inductors, which acts as a low-frequency filter and which as a highfrequency filter?
An (9.29x10^-3)-H inductor and a (1.857x10^0)-Ω resistor are wired in series to an ideal battery. A switch in the circuit is closed at time t = 0, at which time the current is zero. When does the current reach half its final value? Express your result in ms with three significant figures.