A 252 resistor is connected in series with a coil of 502 resistance and 150 mH inductance. What is the equation of the current if the source voltage is 200sin (wt-30deg)?

Q: Find the Thévenin equivalent with respect to the terminals a,b in the circuit in Figure  3

A: Here, we have given a circuit. The circuit consists of no. of resistors connected in series and para...

Q: Determine the output (M) for the J-K flip-flop and the inputs shown in Figure 3. [Tentukan output (M...

A:

Q: 7-1 In a step-down converter, consider all components to be ideal. Let v, V, be held constant at 5 V...

A: As per guidelines, we can only provide the answer of first question in multiple type of question. He...

Q: 6 The area to be considered in using Gauss's Law should be the one where the electric field is perpe...

A:

Q: R

A:

Q: In the given circuit, find the DE Model and TF Model.

A:

Q: Give an example of an interface module used in a communications system, then explain its basic opera...

A: Interface module- Interface module is a hardware device which is used for the transferring of data b...

Q: R1 R2 R3 10 V1 10 V2

A: Kirchhoff’s voltage law: K.V.L. indicates that the sum of all voltages around a closed path (loop) i...

Q: Use this graphic for questions 6, 7, 8, 9, and 10. The total power from the supply is 500mW. R6 R4 R...

A:

Q: Q4/ Use Source Conversion technique to find the load current IL in the circuit below. R1 R2 R3 V1 12...

A: SOURCE CONVERSION Source conversion is the process of conversion of the series combination of the vo...

Q: Given an analog signal  x(t)=10 cos(2π.5500t)+5 cos(2π.7500t)  is sampled at a rate of 8,000 Hz,    ...

A:

Q: 2H 3H 340 12 V | 6 A 2F

A:

Q: 3. By applying the final-value theorem, find the final value of f(t) whose Laplace transform is give...

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please su...

Q: 23. Given a set of capacitors: 7nF, 6nF, 5nF, 4µF, 3pF and 10µF, solve the following problems: a. So...

A:

Q: Write the difference between BJT and JFET transistor.

A: BJT is a bipolar junction transistor where both minority and majority carrier in the device and JFET...

Q: For this class AB amplifier with an output resistance of 5 Ohms and quiescent collector current of 2...

A: Given -  Output resistance = 5 Ohms Quiescent collector current = 2.5 mA

Q: For number 12 question Final problem, you will need a test charge to move from one point to another ...

A: The solution is given below 

Q: Rs R. İsa Vsz Vsi Rs Write two KVLS that include vx. Write your KVLS in terms of voltages across res...

A:

Q: The value of T0 in the following circuit equals: 1kn 3 k2 8 mA 'Io a. 8 mA b. 2 mA

A:

Q: Given: Battery = 3v LED Light = 3v Asked: Measure the voltage of the battery. Measure the voltage ac...

A: LED- Light Emitting Diode. It is a semiconductor device which gives light as output when the current...

Q: Create a synchronous counter utilising J-K flip-flops that may be utilised for a 7-story building's ...

A:

Q: Given the circuit below. i, (t) = v210 cos(377t). Give your answer in four decimal places if it is n...

A: Belief description: For an AC circuit we have 3 types of powers such as real power, reactive and com...

Q: (t) is defined by the convolution g(t) = 5II(t/2) * [8(t +1) + 8(t)] ere II(t) and d(t) are the unit...

A:

Q: Doe Do Dor Do Vị V3 Figure 2: Simulating delays with inverters. Let each inverter have delay A, then...

A: Given the logic circuit as shown below: We need to construct this circuit using the MUX circuit. We...

Q: Generating capacity connected to the bus bars and ready to take load when switched on is known as Ho...

A: Generating capacity connected to the bus bars and ready to take load when switched on is known as  A...

Q: Using the following information; I (cos a2 Απρ H = cos a1) a ao = ag × ap H at point Q (5,5,10) if t...

A: Given: H=I4πρ(cos α2-cos α1) aφ We need to find the magnetic field intensity H at point Q (5,5,10) i...

Q: What is the formula for temperature coefficient of resistance

A: Temperature coefficient of resistance(TCR) TCR is defined as the calculation of a relative change of...

Q: i)Modulation process takes place in the modulator with two injection signals namely data or informat...

A: Please refer the attached images for the complete answer..

Q: Find the correct expression of Vout in the given circuit.

A: Apply KVL in loop to find the current in series connected circuit,  using ohms law find output volta...

Q: 10. A lossless coaxial cable terminates cuit load. What is the transmission line voltage expressed i...

A: Coaxial Cable- They are special type of cables which have a conductor in the middle and protected by...

Q: Region 1 (y 0) contains dielectric medium with ɛ2

A: Region 1 (y<0) contains the dielectric medium with ε1=5ε0 and μ1=1.5μ0. While region 2 (y>0) c...

Q: Power generation cost reduces as diversity factor decreases and load factor increases diversity fact...

A:

Q: resistor of 0.5 ohms is connected in parallel with a 10 millihenry inductor. If the source voltage a...

A:

Q: A magnetic circuit has a 20 V battery connected to an 80 Q coil of 800 turns with an iron bar of 2 m...

A:

Q: The ATM protocol has a CRC for the payload * True *False What is the payload data rate of an enco...

A: According to the question, The ATM protocol has a CRC for the payload * True *False What is the payl...

Q: In a step-down converter, consider all components to be ideal. Let v, V, be held constant at 5 V by ...

A:

Q: Find transfer function using signal flow graph

A: This question belongs to control system . It is about calculation of transfer function by using sign...

Q: Vs f = 150 Hz C 0.1 μF

A:

Q: Q9. Determine the voltmeter reading in Figure 2, if the 4.7 k (R3) resistor is open. What is the rea...

A: We will replace the voltmeters with the symbols for voltmeter. So, the simplified circuit will look ...

Q: Q2/ Calculate the effective resistance of the following combination of resistances (Req) and the vol...

A: Effective Resistance Effective resistance in series is equal to the sum of the resistance. The recip...

Q: Find the transfer function, G(s) = X2(s)/F(s),

A:

Q: can someone explain to me the logic how to do this problem step by step I have the answers but I wan...

A:

Q: Given the circuit below. i, (t) = v210 cos(377t). Give your answer in four decimal places if it is n...

A: Brief description:  The value of current source is given as is(t)  is(t) = 10 √2 cos(377t)  By compa...

Q: Explain the implications of integral and derivative control on damping and steady-state errors.

A: Controllers is  used to improve the performance of the plant in time domain. It is connected in casc...

Q: What is the importance of compensator in control systems?

A: Compensator is used in the control system to improve system dynamics, improve characteristics of the...

Q: Find the correct Norton equivalent circuit for the network

A: This question belongs to network theory . It is based on the Norton's theorem . Norton's equivalent ...

Q: Question 1 An engineer intends to determine all of the different currents flowing in the circuit sho...

A: In this question we need to substitute the values of Vs  and all the resistances and arrange them in...

Q: An uncharged 10 microF capacitor is charged by a constantcurrent of 1 mA. Find the voltage across th...

A:

Q: Given the following Resistances in Series and Voltage Source: R1 = 8 ohms R2 = 5 ohms R3 = 8 ohms...

A: If resistances R1,R2,R3 are in series then their equivalent resistance is sum of the three resistors...

Q: Transform the vectors F 10 a, to spherical coordinates at (4, 110°, 120°)

A:

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.