A 4 pole dc generator with duplex wave winding has 48 slots and four elements per slot. The flux per pole is 2.5 x 10 Maxwells and the speed of the prime mover is 30 rpm. What is the average generated armature voltage? Neglecting brush drop.

Q: A CS amplifier has a load resistance of 8 k and Rp = 1.76k. If gm = 5.67 mS and Vin = 500 mV, the…

A: Brief description :  RD = 1.76 k ohm  RL = 8 k ohm  gm = 5.67 m S   Vin = 500 m V  By the use of…

Q: For figure 3, how do I find: Is The average power delivered to each element, the reactive power for…

A: KCL states that algebraic sum of currents at a node must be equal to zero. It is also called nodal…

Q: y(n) = −0.17y(n − 1) – 0.3y(n − 2) + 0.04x(n) + 0.319x(n − 1) - -

A:

Q: Q1/ For a LTI system, drive the frequency response, if you know that the input is: r(t) = M cos(wt +…

A: Given,For a LTI system,The input signal is,rt = Mcosωt+θ

Q: An oil (S = 0,85, v= 1.8×10 m²/s) flows through 0.1m diameter pipe at 2m³/sec, 150m long. Find the…

A: Using Darcy's Weishbach equation the loss can be calculated.

Q: hifts one bit to the right at every clock pulse, is initialized to values "1000" for Q0Q1Q2Q3. The…

A:

Q: Q1: A JFET with parameters of Ipss = 3mA and VGS(OFF) = Vp = -6V is used in a circuit shown in…

A:

Q: Q1 Draw the signal flow graph for the following set of algebraic equations V/₂=ay₁-8y's y₁ = ey₂ +…

A:

Q: Design a component values for RLC series circuit with center frequency of 4KHz and quality factor of…

A:

Q: For k=3, n=6 and the parity check matrix is: ГО HT = 1 0 1 1 1 0 0 1 0 10 l1 1 0 0 0 1 If the…

A:

Q: need the answer quickly

A: Voltmeter are such devices which are used in experiments to measure the potential difference.

Q: Refer to the given circuit below. Determine the Thevenin Equivalent EMF if R3 is to be analyzed.

A: To determine the Thevenin's equivalent EMF considering R3 as load element

Q: The following information is given in connection with an alternator slot = 144; poles = 8; speed=…

A:

Q: €4 Ⓒ60V 10 M a M Bio b B A 4 :10F 2 Ix + 10v 6 2 m 12V

A:

Q: Design CMOS Layout for the Boolean function Y=A[(BC)+D].

A: Consider the given function as, Y=A[(BC)+D]

Q: AXY flip-flop has four operations clear to 0, no change, complement and set to 1, when inputs X and…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Q1/ For the below system, if you know that the input is (t) = A sin(wt), explain and draw the…

A:

Q: B- the instrument readings obtained from open and short-circuit tests on 10kVA, 450/120V, 50Hz…

A: As per Bartley policy we can answer only first three parts at a time. Please repost the question for…

Q: Activity 2: (Nanotechnology) Research about nanotechnology and cite at least 10 examples of how it…

A: Nanotechnology is the study, sculpting, and combining of matter just at atomic and molecular level.…

Q: Find the Fourier transform of the given waveform.

A: In this question we need to find Fourier transform of the given signal

Q: Determine fus O 104.3 Hz O 103.4 Hz 130.4 Hz 140.3 Hz

A: Answer: 140.3Hz   a) it is not a valid option. The value is not close to calculated value.  b &…

Q: A transmission line cable consists of 13 strands of identical aluminum conductors,

A:

Q: Q10: when press the button if the input convert from high to low what is the type of the resistor:…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: نقد * Why we need synchronization bits in ?TDM To decrease bandwidth To decrease system complexity…

A:

Q: ndard practice of synchronous generator construction now a days is to ndrical field ating armature…

A: These are the few questions related to the basic understanding of alternators their construction and…

Q: Determine IDQ, VGSQ, and VDS for the network of Fig below.When VDD=40V, RD=3K, RS=1K, R1-24M,…

A: The required parameters can be calculated by using the DC analysis of the MOSFET amplifier.

Q: Q1:A JFET with parameters of Ipss = 3mA and VGS(OFF) = Vp = -6V is used in a circuit shown in figure…

A:

Q: Determine the maximum bit rate for an FSK signal with a mark frequency of 48 kHz, a space fre-…

A:

Q: 1 8 Let K=2, G₁(s)=5G₂(s) == Find K₁ so that = 0.6 and ts=0.1 sec for a 1% tolerance.

A: Transfer function: A system, sub-system, or component's transfer function (also known as system…

Q: A unity feedback system has the open loop transfer function shown below. Find the breakin point.…

A:

Q: Q1. A single phase A.C. radial distributor system has long of 600m and a total impedance of…

A:

Q: Q1/For a LTI system, drive the frequency response, if you know that the inpu is: r(t) = M cos(wt +…

A: Frequency Response Analysis:  The reaction of a system may be classified into two types: transient…

Q: Find the output voltage vo(t) using the Fourier transform for the circuit given when v(t) = e'u(-t)…

A:

Q: Identify the given statement. Current density is a scalar quantity. Select your answer. The…

A: given statement is current density is a scalar quantity. here we have to tell whether the given…

Q: What are the patterns of QoQ1Q2 Q3 after 10-clock pulse when initial values of QoQ1Q2 Q3 are 0110.…

A: The given figure is a serial in serial out type shift register so for every clock pulse the data…

Q: Define the 2nd order system and give the open loop and close loop of the 2nd order

A: Block diagram of second order system is shown in below figure, This is negative unity feedback…

Q: a) Sketch and find the phase relationship between the following waveforms: V = 0.2 sin (wt - 60°) /=…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: A unity feedback system has the open loop transfer function shown below. Use the Nyquist Path that…

A: In this question we need to find a value of N for large k

Q: The transformer is used to change voltage, current and frequency according to the turn ratio. O True…

A: We know that voltage and current relationships with respect to turn ratio of a transformer as…

Q: نقطة واحدة The action of JFET in its equivalent circuit can be represented as which of the…

A: JFET is three terminal semiconductor device which current flow through one medium i.e electron or…

Q: Q3/ For the below system, explain what will happen at the output if we change the frequency of the…

A: For a LTI system, If input is sinusoidal signal then output also sinusoidal signal with same…

Q: QUESTION 6 A rectangular loop of length a-4.00 cm and width b-2.00 cm is put in a region of uniform…

A: Given data : Length of rectangular loop a=4 cm=4×10-2 m Width of rectangular loop b=2 cm =2×10-2 m…

Q: Refer to the Figure below. VDD RD HIV V₁0H Zo Z₁ Rs Compute for mV (with load) VO= if VDD-20V.…

A: Brief description : For the given common source MOSFET we need to calculate the value of output…

Q: Draw the logic diagram of  F=(a+b+c+d) (a'+b+c'+d) ( a'+b'+c+d) ( a' + b' + c + d')

A: Given  F=(a+b+c+d) (a'+b+c'+d) ( a'+b'+c+d) ( a' + b' + c + d')

Q: +51 VR₂ EQ-6 V R₂ [ 8.2 ΚΩ +1₁ R < 6.8 ΚΩ L ell -1. FIG. 12.75 Problem 18. 5 mH VL IL *18. For the…

A: In this solution, concepts related to the transient analysis is discussed.   NOTE :- As per our…

Q: In A/D converter, the maximum amount of error can be computed by dividing the voltage range over…

A: Given  An analog to digital converter  No of bits =10 Voltage range =0 to 6 volts  We need to find…

Q: 1 g R1 202 | v2 - 3V b V1 키가 2V 12 C R3 30 f R2 40 13 d I v3 e 10V

A:

Q: DRAW CIRCUIT OF ANALOG TO DIGITAL CONVERTER CIRCUIT. AND EXPLAIN HOW IT WORKS

A: Analog to digital converter:- This converter is used to convert the analog quantity to digital…

Q: C(s) R(s) 20 G(s) s(s+ 4) Gc(s) = K₂ + Kas 3.plot the time response of uncontrolled system 4. select…

A: Given data, G(S) = 20S(S+4) , GC(S) = KP+KdS

Q: Q4/ Evaluate the state space expression for the below circuit if the output is the current through…

A:

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.