A5 kg cart moves with a constant speed of v; = 8 m/s before it starts to go down a 53° ramp, as shown in the figure below. The cart then moves into a spring placed on the ground level. The initial height of the cart is 20 m and all surfaces can be assumed frictionless. Find the maximum compression on the spring by the cart if the spring constant is 1200 N/m. V = 8 m/s 5 kg h= 20m k =1200 N/m 53°

A5 kg cart moves with a constant speed of v; = 8 m/s before it starts to go down a 53° ramp, as shown in the figure below. The cart then moves into a spring placed on the ground level. The initial height of the cart is 20 m and all surfaces can be assumed frictionless. Find the maximum compression on the spring by the cart if the spring constant is 1200 N/m. V = 8 m/s 5 kg h= 20m k =1200 N/m 53°

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Pressures up to 3000 bar are measured with a dead-weight gauge. The piston diameter is 4 mm. What is the approximate mass in kg of the weights required?
A shop-vac is capable of pulling in the air at a rate of 210 ft³/min. What is the rate of the vacuum's airflow in L/s?
A shop-vac is capable of pulling in air at a rate of 210 ft^3/min. What is the rate of the vacuum’s air flow in L/s?
Determine the specific weight, specific gravity, and mass of the natural gas (80% methane, 15% ethane and 5% propane) in a 2-m diameter cylindrical tank that is 5.4-ft long at 1.35 bar and 113°F.
a cylinder was connected to an open ended U-tube (1 atm) containing some mercury, Hg (density=13.6gcm^-3), and the Hg was displaced 100mm towards the container. What is the pressure of the gas inside the container?
A student team is to design a human-powered submarine for a design competition. The overall length of the prototype submarine is 4.85 m, and its student designers hope that it can travel fully submerged through water at 0.440 m/s. The water is freshwater (a lake) at T = 15°C. The design team builds a one-fifth scale model to test in their university’s wind tunnel. A shield surrounds the drag balance strut so that the aerodynamic drag of the strut itself does not influence the measured drag. with all the same conditions except that the only facility available to the students is a much smaller wind tunnel. Their model submarine is a one-twenty-seventh scale model instead of a one-fifth scale model. At what air speed do they need to run the wind tunnel in order to achieve similarity? Do you notice anything disturbing or suspicious about your result? Discuss your results
I am trying to find the boiling point of liquid Unknown. Barometric pressure _650_ mm Hg, Observed _79_ 0C, need to find the Estimated ture (normal) b.p (apply pressure correction to obtain)_____ and what the unknown (please type answer not write by hend)
At 90 °F and 30.0 psi absolute, the specific weight of a certain gas was 0.0877 lb/ft³. Determine the gas constant.
Tooling for a vacuum deposition system is cleaned and reassembled. Unfortunately, a drop of water 0.125 cm3 in volume is left in the bottom of a screw hole. Due to the obstructed path to the pump, a negligible amount of water escapes during the early stages of pumpdown, and the drop becomes a virtual leak at a chamber pressure of 4.3E-06 torr. Find the volume of gas formed by the water at this pressure (assume it stays at room temperature). The density of water is 1g cm-3 and the molecular weight 18 g mole-1. (First, determine the number of moles in the drop of water, and use the ideal gas law to determine the volume)(b) To make this result clearer, what is the added time (in hours) to pump out this chamber due to this droplet if the pump, at that pressure, has a rate of 1480 L/s?
The ammonia contained in a container measuring rectangular tank 1m x 700 cm x 3000mm if the pressure is 1.5 bar and temperature is 28 0C. Assume the molecular weight ofammonia is 17. Calculate the mass of ammonia
wo spherical vessels of different sizes contain the same gas and are connected by means of a pipe with a valve. Sphere A has a diameter of 5 foot at the given pressure gauge of 50 kgf/cm2. Sphere B contains the same gas at 20 kgf/cm² gauge. The valve is opened and when the properties have been determined, it is found out that the gauge pressure is 36 kgf/cm2. The temperature at the two vessels before and after opening the valve is maintained at 21.1°C. If the barometric pressure is 750 torr and the gas inside the sphere is oxygen, find the following: 1. The pressure at sphere B in psia. 2.. Temperature at sphere B in F. 3. The pressure of the gas when mixed in psia.
The 100-lbf crate is initially stationary. The coefficients of friction between thecrate and the inclined surface are μs = 0.20 and μk = 0.16. Determine whether the crate slips if thehorizontal force F = 90 lbf. If the crate slips, determine how far the crate moves from its initialposition in 2 seconds. Indicate the tendency for motion.