(a) A teaching assistant is preparing for an in-class demonstration, using insulated copper wire and a power supply. She winds a single layer of the wire on a tube with a diameter of dsolenoid = 10.0 cm. The resulting solenoid is ℓ = 80.0 cm long, and the wire has a diameter of dwire = 0.100 cm. Assume the insulation is very thin, and adjacent turns of the wire are in contact. What power (in W) must be delivered to the solenoid if it is to produce a field of 9.40 mT at its center? (The resistivity of copper is 1.70 ✕ 10−8 Ω · m.) W What If? Assume the maximum current the copper wire can safely carry is 24.0 A. (b) What is the maximum magnetic field (in T) in the solenoid? (Enter the magnitude.) T (c) What is the maximum power (in W) delivered to the solenoid? W

(a) A teaching assistant is preparing for an in-class demonstration, using insulated copper wire and a power supply. She winds a single layer of the wire on a tube with a diameter of dsolenoid = 10.0 cm. The resulting solenoid is ℓ = 80.0 cm long, and the wire has a diameter of dwire = 0.100 cm. Assume the insulation is very thin, and adjacent turns of the wire are in contact. What power (in W) must be delivered to the solenoid if it is to produce a field of 9.40 mT at its center? (The resistivity of copper is 1.70 ✕ 10−8 Ω · m.) W What If? Assume the maximum current the copper wire can safely carry is 24.0 A. (b) What is the maximum magnetic field (in T) in the solenoid? (Enter the magnitude.) T (c) What is the maximum power (in W) delivered to the solenoid? W

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter28: Current And Resistance

Section: Chapter Questions

Problem 68PQ

See similar textbooks

Similar questions

If the copper wire of an electromagnet has a resistance of 0.300 Ω when at roomtemperature (20 oC) with no current flowing, what is the temperature of the wire when thecurrent is turned on and the resistance increases to 0.347 Ω?
What is the approximate take off latency recorded at 17 cm in a nerve fiber having a conduction velocity of 49 m/s?
An iron wire has a cross - sectional area of 5.00 x 10-6 m2.Carry out steps (a) through (e) to compute the drift speed ofthe conduction electrons in the wire. (a) How many kilogramsare there in 1 mole of iron? (b) Starting with the density of ironand the result of part (a), compute the molar density of iron(the number of moles of iron per cubic meter). (c) Calculatethe number density of iron atoms using Avogadro’s number.(d) Obtain the number density of conduction electrons giventhat there are two conduction electrons per iron atom. (e) Ifthe wire carries a current of 30.0 A, calculate the drift speed ofconduction electrons.
Consider a power plant is located 60 km away from a residential area uses Q-gauge (A=42.40mm2) wire ofcopper to transmit power at a current of I = 100.00 A.How much more power is dissipated in the copper wires than it would be in superconducting wires?
A block of weakly-conducting material with conductivity sigma has two pieces of metalembedded inside, which form a capacitor with capacitance C.(a) Find the resistance R between the two pieces of metal.(b) At t = 0, the two pieces of metal have a potential difference V0, and at future times t not equal to 0the potential is V (t) = V0e-t/TFind T
An old lightbulb draws only 50.0 W, rather than its original 60.0 W, due to evaporative thinning of its filament. By what factor is its diameter reduced, assuming uniform thinning along its length? Neglect any effects caused by temperature differences.
Consider following circuit with R1 = 62 Ω, R2 = 11 Ω, R3 = 62 / 10 Ω, R4 = 11/10 Ω and and ξ=11 V i. Cross sections through two long conductors of the same length and material, with square crosssections of edge lengths are shown below. Conductor Y fits snugly within conductor X, Rank theresistance of X and Y?
Calculate the specific conductivity of the conductor in Mega(Ωm)-1 since the current passing through a conductor with a cross-section (1.00nm x 1.00µm), length of 10.00mm, is 1.00mA and the voltage value falling on it is 1.00V.
A 240-kV power transmission line carrying 5.00×102 A is hung from grounded metal towers by ceramic insulators, each having a 1.00×109 -Ω resistance. (a) What is the resistance to ground of 100 of these insulators?(b) Calculate the power dissipated by 100 of them. (c) What fraction of the power carried by the line is this?
Compute the power required to service a city 110,000 homes, each of which draws an average current of 18A at a potential of 118V? If the transmission lines that carry power were capable of carrying a current of 1000A, what potential would be required to transmit the power from the source?
An electrical cable of length l=12m consists of a copper wire of diameter D=0,3 cm, and resistivity p= 1,7. 10^(-8) , surrounded by a cylindrical layer of rubber insulation, thickness s= 0,10 cm. A potential difference of 6 volts is applied to the ends of this cable. I) Find the intensity of electric current in the cable.
A wire of copper having length I and area of cross-section A is taken and a current / is flown through it. The power dissipated in the wire is P. If we take an aluminium wire having same dimensions and pass the same current through it, the power dissipated will be: A) P B) < P C) > P D) 2P