A chemist weighs a steel cylinder of compressed oxygen, O2, and finds that it has a mass of 1027.8 g. After some of the oxygen is used in an experiment, the cylinder has a mass of 1023.2 g. How many moles of oxygen gas are used in the experiment? When answering this question include the following: Explain how you found the mass of oxygen gas. Explain how to find the molar mass of the compound. Explain how many significant figures your answer needs to have. The numerical answer

Q: Calculate the boiling-point elevation for a 2-liter volume of water containing 20 g of table salt. T...

A: Given :-  volume of water = 2 L  mass of table salt = 20 g  Kb of watet = 0.52 °C/m  To calculate :-...

Q: 2. A KCI solution has a concentration of 300 ppb. What mass of KCl is contained in 900 mL of this so...

A:

Q: Polarities of analyte functional group increase in the order of hydrocarbon < ethers < esters < keto...

A:

Q: thermodynamic

A: In this question we have to explain that these same thermodynamic principles govern the connections ...

Q: Determine the molar it’s of a solute when 0.130 mol of the solute is dissolved into enough solvent t...

A: Given :- no.of moles of solute = 0.130 mol                Volume of solution = 550 mL  To calculate ...

Q: Write the balanced net ionic equation and name the precipate formed in each reaction  1. CU(NO3)2 (...

A:

Q: A lawn fertilizer is rated as 4.40% nitrogen, meaning 4.40 g of N in 100g of fertilizer. The nitroge...

A: Answer: This is a question based on stoichiometric calculation where moles of nitrogen should be con...

Q: The reaction 2A → A2 was experimentally determined to be second order with a rate constant, k, equal...

A:

Q: 40. is made by combining sulfuric acid and sodium dichromate. O Chromic (1) acid Chromic (11) acid O...

A: Since you asked multiple questions so as per Q&amp;A guidelines of portal I solved first question fo...

Q: B. Ex: Sulfur and copper, when heated together, react to form copper(I) sulfide, Cu2S. How many gram...

A: The given chemical reaction is as follows: S8(s) + 16Cu(s) → 8Cu2S(s) The mass of sulfur given = 10....

Q: Which of the following statements about the van Deemter equation H= A+ Blu+ Cu is incorrect? O A. Th...

A:

Q: When 0.100 g of an unkown polyhydroxy organic substance was added to 50.0mL of phenol, a decrease of...

A:

Q: Design a buffer that has a pH of 9.74 using one of the weak acid/conjugate base systems shown below....

A:

Q: A solution was prepared by dissolving 35.0 mL of methanol in sufficient water to give a total volume...

A: We have to predict the percentage by volume of given solution.  

Q: 65. The picture below is alan OH :0-H acetone acetic acid acetaldehyde

A: A compound can be named based on the functional group present in the molecule. A functional group is...

Q: Using the Lewis concept of acids and bases, identify the Lewis acid and base in each of the followin...

A: Answer: According to Lewis theory, any substance that accepts lone pair in a chemical reaction is ca...

Q: Another student performed the same percent composition of a hydrate experiment, but kens the crucibl...

A: 3a. The experiment was the determination of percent composition of hydrate.

Q: Which of these structures shows how the pictured molecule will look after it is flipped over horizon...

A: Observations and conclusions: 1) Upon flipping, the atoms/groups on the axis would just change their...

Q: Suppose an EPA chemist tests a 250. mL sample of groundwater known to be contaminated with iron(III)...

A: Answer: This question is based on stoichiometric calculation. First of all we will calculate the num...

Q: For a reaction that follows the general rate law, Rate = k[A][B]2, what will happen to the rate of r...

A:

Q: To manufacture a vehicle, four tires and one steering wheel are required. How many cars can be manuf...

A:

Q: A. Give the IUPAC name of the following hydrocarbons: 1 CH3 CH2 CH3 ÇH3 H3C -CH2-C- CH CH3 ČH3 ČH3 2...

A:

Q: CH,(9)+2H,S(g) – CS,(9)+4H,(9) At the temperature the engineer picks, the equilibrium constant K, fo...

A:

Q: 50. What is the name of this compound 3HC-CH2-CH2-CH2-CH2-CH2- NH2? * 1-hexanamide 1-hexanamine hexa...

A:

Q: What is the percent composition of iron(II) sulfate hexahydrate? Select one: a. 4.2% Fe; 4.2% S; 41....

A: Molar mass of FeSO4 .6H2O = 260.0g/mol In FeSO4 .6H2O Number of Fe = 1 Number of S =1 Number of O=10...

Q: The kinetics of the reaction, A + B → P, were studied and it was determined that the reaction rate d...

A: We would use rate law to determine the order with respect to B .

Q: This is the chemical formula for methyl tert-butyl ether (the clean-fuel gasoline additive MTBE): CH...

A: Answer: This question is based on the stoichiometric calculation where in a molecule, ratio of each ...

Q: 69 The structural formulas below are examples of S-CaN phenyl thiocyanate phony isothiocyanate amine...

A:

Q: Which of these structures shows how the pictured molecule will look after it is flipped over vertica...

A:

Q: The following chromatogram is obtained for a mixture of substances X and Y. Calculate the separation...

A:

Q: A newly discovered gas has a density of 2.39 at 2310°C and 715 mm Hg. What is the molar mass of the ...

A: Consider the given information is as follows; Density (d) = 2.39 g/L Temperature (T) = 2310°C = 2310...

Q: Another conceptually simple approach to water purification, but it isn’t quite as straightforward as...

A: Forcing the water through small spaces can be done via an osmotic driving force.

Q: d) The literature specific rotation of (d)-epinephrine is 53 degrees. You measure the rotation of a ...

A:

Q: protein. 57. This is a chemical structure of Oprimary O ertary quarternary 58. This picture of tobac...

A:

Q: Do you think that leucine would have the same or a different structure depending upon if it was diss...

A:

Q: Why do you think there are slots in the metal atoms

A: A metal is a material, when freshly prepared, polished or fracture shows a lustrous appearance and m...

Q: 42. Phenol reacts with ferric ions to form O violet coloured complex O red coloured complex yellow c...

A:

Q: SYNTHESIS AND DECOMPOSITION Name: 1. Perform each reaction at your lab bench by following the direct...

A:

Q: thermometer A 58.8 g sample of aluminum, which has a specific heat capacity of 0.897 J-g is put into...

A: Answer: This question is based on the conservation of energy where heat lost by aluminum sample will...

Q: What is the molecular mass in g/mol of a solution prepared by dissolving 6.00 g of an unknown nonele...

A: The osmotic pressure of solution is given by expression- Osmotic pressure = i CRT.  where, i = Van't...

Q: Calculate the average atomic mass of the element iron (Fe) using the following data: Isotope Iron-54...

A:

Q: Draw product F. Select Draw Rings More F. (CHs),P-CH2

A:

Q: I0I Chem 101 app. 101edu.co Question 16 of 18 A sample of 3.05 g of banana was burned in a coffee cu...

A:

Q: Current Attempt in Progress Based solely on the amount of available carbon, how many grams of sodium...

A:

Q: Which of the following scenes depict the process of an increase in the enthalpy?     Stirring a coff...

A: a) When stirring a coffee mixture leads to increase in entropy due to increase in randomness in the ...

Q: The combustion of octane (C8H18) gas. The combustion of decane (C10H22) gas.

A: According to the Law of conservation of mass " all atoms of different elements must be equal on both...

Q: 4. How many grams of NaCl is needed to prepare a 0.87 M 500 mL solution?

A: Given,  Concentration of NaCl solution = 0.87 M  Volume = 500 ml = 0.5 L 

Q: Part A At 25 °C phosphoric acid, H3PO4, has the following equilibrium constants: K = 7.5 x 10 3 What...

A: Given that, at 25°C phosphoric acid H3PO4, has the following equilibrium constant, Ka1 = 7.5×10-3; K...

Q: Given the following reactions:             N2(g) + 2O2(g) → 2NO2(g)      ΔH = 66.4 kJ             ...

A:

Q: Which of the following scenes depict the process of an increase in the enthalpy?     Stirring a coff...

A:

Stoichiometry

Stoichiometry is a chemical division that evaluates the quantitative content of the chemical process with the help of the reacting molecules or products taking part in the reaction. The term “stoicheion” in “Stoichiometry”, is an old Greek term for "element" whereas “metron” means "measure".