Could these same thermodynamic principles govern the connections between cells that support morphogenesis of the embryo? The thermodynamic properties governing thesurface tension between water molecules andthe grains of sand serve to hold the parts of Olaftogether. Moreover, the sunlight on this sandsculpture establishes differential temperaturesand associated water evaporation on the surfacecompared to the inner composition;consequently, the adhesion between sand grainson the surface rapidly becomes reduced,whereas more centrally located grains hold tight(i.e., until the tide changes).

In this question we have to explain that these same thermodynamic principles govern the connections…

Answered: thermodynamic

Science

Chemistry

thermodynamic

Physical Chemistry

2nd Edition

ISBN:9781133958437

Author:Ball, David W. (david Warren), BAER, Tomas

Publisher:Ball, David W. (david Warren), BAER, Tomas

Chapter22: Surfaces

Section: Chapter Questions

Problem 22.8E: Equation 22.6 defines surface tension in terms of Gibbs energy. Borrowing an analogy from chemical...

See similar textbooks

Related questions

Q: che mass

Q: Rank the following elements in order of increasing atomic size: carbon, silicon, Florine

A: We have find out atomic size.

Q: CI HNO3 H2SO4 CI Br 1) H* / H2O 2) NaH 1 equiv. m-CPBA HBr 10°C `CI , AICI3 1) 2) Zn(Hg), HCI 3) NBS...

Q: Imagine that you are in chemistry lab and need to make 1.00 L of a solution with a pH of 2.60. You ...

Q: The density of water is very close to 1.00 g/mL. If 3.00 moles of ethanol (molar mass 46 g/mol) is m...

A: moles of ethanol = 3 mole Mass of water = 1000 g = 1 kg

Q: A cup of tea containing 400.0 g of liquid at 20.0°C was heated. If 58.5 kJ of heat was absorbed by t...

Q: Consider these compounds: A. BaSO3 В. Cr(ОH)з С. РЬСrO4 D. A93PO4 Complete the following statements ...

A: Sulfite are soluble . All hydroxide,phosphate chromates Are insoluble in water.

Q: A sample of 23.9g of ammonium nitrate, NH&NO3. was dissolved in 133.8 g of water in a coffee cup cal...

A: Given Mass of NH4NO3 =m = 23.9 gMass of water = Mw = 133.8 gInitialTemperature = T1 = 28.1°CFinal Te...

Q: glass vessel contains 28 g of nitrogen gas (N2). Assuming ideal gas behavior, which of the processes...

Q: certain bottle of mineral water has a stated chloride concentration of 28 ppm. How many mg of chlori...

Q: write the formula of each chemical, then draw lewis structure and structural diagram with approxima...

A: This question is related to valence bond theory. Lewis structure can be defined as representation of...

Q: Consider the octahedral species CrCl63- (point group Oh). What point group results by removing on...

A: Given

Q: 1. [). 6 -C-C- -O- I C-C-C-

A: For name we have to select long chain and first protity will give to alcohol and then iodine

Q: CH3 H3C- CH CH CECH CH3 CH2 ČH3 CH3 5 CH2 H3C-CH-ĆH- CH2 CH3 ČH3 H3C- CH-CEC- CH -CH3 CH2 CH3 CH3

A: Answer : Naming of alkenes and alkyne : ★ Find the longest carbon chain that includes both carbons o...

Q: Which NaOH solution is the most concentrated? (assume a density of 1.00 g/mL wherever necessary; mol...

A: We have to predict solution of highest concentration.

Q: Nitrogen dioxide (NO, gas and liquid water (H,0) react to form aqueous nitric acid (HNO,) and nitrog...

Q: 5. A 6.00-g candle is consumed in heating 45.0 g of water from 19.0°C to 32.0°C. If you ignore loss ...

Q: Calculate the most probable speed for hydrogen molecules at 0C. Select the correct response: 1200 m/...

A: Given data: Temperature (T) = 0°C = (0+273.15) K = 273.15 K Molar mass of hydrogen molecule(M) = 2 g...

Q: Complete answers with solution. Enclose your final answer in a box. 1. What is the % composition of ...

Q: 3. Use a titration between an acid and a base to answer the following: a. Mole to mole ratio of acid...

A: The reaction between an acid and base is called neutralisation reaction in which salt and water is p...

Q: Which of the following scenes depict the process of an increase in the enthalpy? Stirring a coff...

A: a) When stirring a coffee mixture leads to increase in entropy due to increase in randomness in the ...

Q: 5. Benzaldehyde can slowly oxidized into benzoic acid by contact with air. What would be the effect ...

A: Answer and explanation is given below hope you like it. Benzoic acid acts as catalyst in WITTIG Re...

Q: A solution was prepared by dissolving 35.0 mL of methanol in sufficient water to give a total volume...

A: We have to predict the percentage by volume of given solution.

Q: What is the freezing point (°C) of a solution prepared by dissolving 50.0 g of glycerin in 200.0 g o...

A: Given data is as follows: The mass of glycerin = 50.0 g The mass of ethanol = 200.0 g The freezing p...

Q: Practice Problem 16.3 What product is formed when each carbonyl compound is treated with K,Cr,0,? In...

Q: Which of the following solutes will have the lowest vapor pressure given the same amount in moles? ...

A: Colligative properties: The colligative properties are those properties of solutions that depend on ...

Q: 4. Identify the element oxidized and the element reduced in the first reaction of the lab: Assign ox...

A: Concept: Oxidation: Oxidation is a process in which a chemical substance changes because of the addi...

Q: 15. Methylamine is a weak base with the formula, CH3NH2, the Kb for methylamine is 4.38 x 10-4 In a...

A: Methylamine is a Bronsted base, as it can accept a proton from water.Methylamine (CH3NH2) is conside...

Q: polar or nonpolar?

Q: When the Cu2+ concentration is 2.32x10-4 M, the observed cell potential at 298K for an electrochemic...

Q: The heat of combustion, AH°C, of acetone, C3H,O, is -1790.4 kJ/mol. How many kilojoules of heat are ...

A: The combustion is a reaction of the compound in the presence of oxygen. The combustion reaction will...

Q: Consider the reaction and the value of its equilibrium constant: S2C12(g) + Cl2(g) → 2SCI2(g) Keq = ...

A: The equilibrium constant is represented by Keq. and the reaction quotient is Q If Q= Keq the reactio...

Q: 2. The picture in the introduction shows that the mass of a crucible and lid was determined to be 22...

A: Given, The mass of Crucible and lid = 22.1504 g. The mass of crucible and lid and hydrate = 24.29...

Q: 10a.Bulletproof vests are made of the polymer called Kevlar. It is produced by the polymerization of...

Q: Balance the following equation and determine how many moles of aluminum oxide can be produced from 9...

Q: Chemical Formula Prelab Questions Name: Ashlyn Neurton Section: O0 Prepare For It! Pre-Lab Questions...

A: 4.) Mole ration is calculated by dividing the least value of moles by each value. 5.) We use mole r...

Q: Which solution would have the lowest pH? Select one: a. 0.1 mol/L NH3(aq) b. 0.1 mol/L HCl(aq) ...

Q: How many moles of water are produced when 24.3 mL of 0.100 M NaOH is mixed with 31.4 mL of 0.08 M ac...

Q: The position of equilibrium would not be appreciably affected by changes in the volume of the contai...

A: Le Chatelier's principle: This principle is used to predict the effect of a change in conditions on ...

Q: DDT tetra chlorodiphenyl 57. This is an example of O monopeptide amino acid O dipeptide amino acid t...

A: The given example of which type of peptide amino acid is given below.

Q: An ideal gas is allowed to expand from 6.40 L to 48.0 L at constant temperature. By what factor does...

Q: 1) m-СРBА 2) МеO"/ MeOH Br2 .C=N Me-C Me CH3 МеОн gentle heat Br Me +

A: Concept: A) m-CBPA: it is used for epoxidation of Alkene. Further epoxide opening will be via SN2 ...

Q: Assuming a brass alloy contains 20g of zinc, its maximum amount of solute. What will you do to make ...

A: A supersaturated solution is usually prepared by adding maximum amount of solvent which is already p...

Q: A bubble of gas with volume 18.4 mL is released by a scuba diver at 1.50 atm and 0.00 0C. Calculate ...

A: A numerical problem based on properties of gas that is to be accomplished.

Q: A cylindrical metal canister is filled with pressurized diatomic oxygen gas, O2. e circular base of ...

A: Radius of circular base of cylinder = r = 0.06m Height of cylinder = h = 0.3m Pressure of gas = 5.78...

Q: Design a buffer that has a pH of 3.65 using one of the weak acid/conjugate base systems shown below....

Q: 12. What is the oxidizing agent that can oxidize both primary and secondary alcohol to form aldehyde...

Q: Describe how to prepare 15 ml of a 0.25 M CaCl2 solution using deionized water and CaCl2 salt. The m...

A: Given :- Volume of solution = 15 mL = 15×10-3 L Molarity of CaCl2 = 0.25 M Molar mass of CaCl2 = 110...

Q: Suppose a 250. mL flask is filled with 1.1 mol of CO, 0.80 mol of H,0 and 0.60 mol of CO,. The follo...

A: Volume of flask = 250.0 mL Moles of CO = 1.1 mol Moles of CO2 = 0.60 mol Moles of H2O = 0.80 mol

Q: Consider the dissolution of A¿B: A2B(s) 2A*(aq) + B(aq). Using the information below, calculate for ...

A: We have to calculate the ∆Go for reaction.

Question

Could these same thermodynamic principles govern the connections between cells that support morphogenesis of the embryo?

The thermodynamic properties governing the
surface tension between water molecules and
the grains of sand serve to hold the parts of Olaf
together. Moreover, the sunlight on this sand
sculpture establishes differential temperatures
and associated water evaporation on the surface
compared to the inner composition;
consequently, the adhesion between sand grains
on the surface rapidly becomes reduced,
whereas more centrally located grains hold tight
(i.e., until the tide changes).

Science that deals with the amount of energy transferred from one equilibrium state to another equilibrium state.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Relate viscosity to strength of IMFs among liquid molecules
Is it possible to have a homogeneous, binary liquid solution that has a higher (or lower) viscosity relative to either component?
which of the following would have the highest viscosity at a temperature and pressure where all are liquid? Rn, He or Ne?
An aerospace manufacturer is building a prototype experi-mental aircraft that cannot be detected by radar. Boron nitride ischosen for incorporation into the body parts, and the boricacid/ammonia method is used to prepare the ceramic material.Given 85.5% and 86.8% yields for the two reaction steps, howmuch boron nitride can be prepared from 1.00 metric ton of boric acid and 12.5 m³ of ammonia at 275 K and 3.07X10³ kPa?Assume that ammonia does not behave ideally under these con-ditions and is recycled completely in the reaction process.
Saturatad uater vapour at 60c°has iti pressure decrease to ncrease the volume by 10 % Keeping the temperature constant. To what pressure Should be expands.
explain the difference between the phases undergone by carbon dioxide and as compared to water.
Calculate the viscosity of a liquid sample of density 1.2 g/cm3 ,taking into account that a metallic sphere of density 8.1 g/cm3 and 10 mm diameter takes 8 seconds to move one meter.
Discuss the importance of bulk vs. surface properties of biomaterials. Briefly describe the importance of “biomaterials surface” considering the series of events following implantation of it.
AI-Si Eutectic, Calculate the mass fraction of the B phase, silicon, given a sample with 61.8 wt% alumimum at 576.99 degrees C.
The viscosity of a multigrade motor oil (such as one rated10W-40) is less temperature dependent than the viscosities ofmost substances. These oils contain polymers (long moleculescomposed of repeating units) that coil up at low temperatures butunwind at higher temperatures. Explain how the addition ofthese polymers to the motor oil might make the viscosity lesstemperature dependent than a normal liquid.
The viscosities of five liquids at 25°C are given in the following table. Explain the observed trends in viscosity.
Equation 22.6 defines surface tension in terms of Gibbs energy. Borrowing an analogy from chemical potential, we submit that surface tension can also be defined in terms of enthalpy, internal energy, or Helmholtz energy. Write partial derivatives for those definitions.