A closed cylindrical tank 1.89m high and 0.99m in diameter contains water of height 1.35m. When the angular velocity is constant at 20rad/sec What is the area (m 2) uncovered at the bottom? A. 0.1 B. 0.3 C.0.7 D. 0.07 If it is rotated at 15rad/sec and the air has a pressure of 200kPa what is the minimum pressure at the bottom of the tank in KPa? A. 245.10 B.145.10 C.201.45

A closed cylindrical tank 1.89m high and 0.99m in diameter contains water of height 1.35m. When the angular velocity is constant at 20rad/sec What is the area (m 2) uncovered at the bottom? A. 0.1 B. 0.3 C.0.7 D. 0.07 If it is rotated at 15rad/sec and the air has a pressure of 200kPa what is the minimum pressure at the bottom of the tank in KPa? A. 245.10 B.145.10 C.201.45

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.5P: Evaluate the dimensionless groups hcD/k,UD/, and cp/k for water, n-butyl alcohol, mercury, hydrogen,...

See similar textbooks

Similar questions

A closed cylindrical vessel, 2m in diameter & 4m high is fully filled with water & rotated to its vertical axis at a constant speed of 12.2 rad/sec. The top is pressurized by 180 KPa. (a) What is the pressure at the center bottom of the cylinder? (b) What is the pressure at the circumference bottom of the cylinder? (c) What is the total hydrostatic force at the sides of the cylinder?
A uniform block of steel (SG= 7.85) will “fl oat” at amercury–water interface as in Fig. What is theratio of the distances a and b for this condition?
A fi sh tank 14 in deep by 16 by 27 in is to be carried in acar that may experience accelerations as high as 6 m/s 2 .What is the maximum water depth that will avoid spillingin rigid-body motion? What is the proper alignment of thetank with respect to the car motion?
Consider a cubical water tank with a side length of 3.5 m. The tank is half filled with water, and is open to the atmosphere. Now, a truck carrying this tank is accelerated at a rate of 7 m/s^2 on a flat road. The maximum vertical rise (in meters) of free surface of the water is ?"
a vertical cylindrical tank 4.82 m. in diameter and 6.87 m. high is full of water. if the tank is to be rotated about its vertical axis, what will be the required angular velocity (in rpm) so that there is no water within 0.6 m. fom the center of the bottom of the tank.
An open cylindrical tank is 1.3 m in diameter and 2.1 m high, is 3/5 full of water If the tank is rotated about its vertical axis, what speed should it have (in rpm) so that there is no water at the bottom within 36 cm from the vertical axis?
What is the smallest diameter glass tube that will keep the capillary height-change of water at 20 deg.C. less than 0.9 mm?
The U-tube in Fig has a 1-cm ID and contains mercuryas shown. If 20 cm 3 of water is poured into the righthandleg, what will the free-surface height in each leg beafter the sloshing has died down?
In Fig. both fluids are at 20 ° C. If surface tensioneffects are negligible, what is the density of the oil,in kg/m 3 ?
The cylindrical water tank in Fig. is being fi lled ata volume fl ow Q 1 = 1.0 gal/min, while the water alsodrains from a bottom hole of diameter d = 6 mm. At timet = 0, h = 0. Find and plot the variation h ( t ) and the eventualmaximum water depth h max . Assume that Bernoulli’ssteady-fl ow equation is valid.
In Fig P2.13 the 20°C water and gasoline surfaces are open to the atmosphere and at the same elevation. What is the height h of the third liquid in the right leg?
The 45 ° V-tube in Fig. contains water and is open atA and closed at C . What uniform rotation rate in r/minabout axis AB will cause the pressure to be equal at pointsB and C ? For this condition, at what point in leg BC will thepressure be a minimum?